参数资料
型号: LT3825EFE#TRPBF
厂商: Linear Technology
文件页数: 7/32页
文件大小: 0K
描述: IC REG CTRLR FLYBK ISO 16-TSSOP
标准包装: 2,500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 250kHz
占空比: 88%
电源电压: 11 V ~ 18 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
包装: 带卷 (TR)
LT3825
PIN FUNCTIONS
V C (Pin 9): Pin used for frequency compensation for
the switcher control loop. It is the output of the feed-
back amplifier and the input to the current comparator.
Switcher frequency compensation components are
normally placed on this pin to ground. The voltage on
this pin is proportional to the peak primary switch cur-
rent. The feedback amplifier output is enabled during the
synchronous switch-on time.
UVLO (Pin 10): A resistive divider from V IN to this pin sets
an undervoltage lockout based upon V IN level (not V CC ).
When the UVLO pin is below its threshold, the gate drives
are disabled, but the part draws its normal quiescent current
from V CC . The V CC undervoltage lockout supersedes this
function so V CC must be great enough to start the part.
The bias current on this pin has hysteresis such that the
bias current is sourced when the UVLO threshold is ex-
ceeded. This introduces a hysteresis at the pin equivalent
to the bias current change times the impedance of the
upper divider resistor. The user can control the amount
of hysteresis by adjusting the impedance of the divider.
See the Applications Information for details. Tie the UVLO
pin to V CC if you are not using this function.
SENSE – (Pin 11), SENSE + (Pin 12): These pins are used
to measure primary-side switch current through an ex-
ternal sense resistor. Peak primary-side current is used
in the converter control loop. Make Kelvin connections
to the sense resistor to reduce noise problems. SENSE –
connects to the ground side. At maximum current (V C at
its maximum voltage) it has a 98mV threshold. The signal
is blanked (ignored) during the minimum turn-on time.
C CMP (Pin 13): Pin for external filter capacitor for the
optional load compensation function. Load compensation
reduces the effects of parasitic resistances in the feedback
sensing path. A 0.1μF ceramic capacitor suffices for most
applications. Short this pin to GND in less demanding ap-
plications that don’t require load compensation.
R CMP (Pin 14): Pin for optional external load compensation
resistor. Use of this pin allows for nominal compensation
of parasitic resistances in the feedback sensing path. In
less demanding applications, this resistor is not needed
and this pin can be left open. See Applications Informa-
tion for details.
PGDLY (Pin 15): Pin for external programming resistor to
set delay from synchronous gate turn-off to primary gate
turn-on. See Applications Information for details.
PG (Pin 16): Gate Drive Pin for the Primary-Side MOS-
FET Switch. Large dynamic currents flow during voltage
transitions. See the Applications Information for details.
GND (Exposed Pad Pin 17): This is the ground connec-
tion for both signal ground and gate driver grounds. This
GND must be connected to the PCB ground plane. Careful
attention must be paid to ground layout. See Applications
Information for details.
3825fe
7
相关PDF资料
PDF描述
VE-J2X-EY-F2 CONVERTER MOD DC/DC 5.2V 50W
IMC1210EBR10J INDUCTOR WW 100NH 5% 1210
PCF1D820MCL1GS CAP ALUM 82UF 20V 20% SMD
AS1902-C23-T IC SUPERVISOR ACT HIGH SOT23-3
LT3837EFE#TRPBF IC REG CTRLR FLYBK ISO 16-TSSOP
相关代理商/技术参数
参数描述
LT382B 制造商:EDSYN 功能描述:TIP CONICAL 0.5X15.8MM
LT383 制造商:EDSYN 功能描述:
LT3837 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModule Regulator
LT3837EFE 制造商:Linear Technology 功能描述:Current Mode PWM Controller 16-Pin TSSOP EP
LT3837EFE#PBF 功能描述:IC REG CTRLR FLYBK ISO 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR