- 您现在的位置：买卖IC网 > PDF目录15253 > LTC1159IS-5#TR (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SOIC PDF资料下载
参数资料
| 型号： | LTC1159IS-5#TR |
| 厂商： | Linear Technology |
| 文件页数： | 9/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SOIC |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 250kHz |
| 占空比： | 100% |
| 电源电压： | 4 V ~ 40 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 其它名称： | LTC1159IS-5TR LTC1159IS5TR |
LTC1159
LTC1159-3.3/LTC1159-5
APPLICATIO S I FOR ATIO
(I MAX ) 2 (1 + ? P ) R DS(ON) +
P-Ch P D =
N-Ch P D = IN
(I MAX ) 2 (1 + ? N ) R DS(ON)
P-Ch Duty Cycle = OUT
N-Ch Duty Cycle = IN
inductor ripple current and consequent output voltage
ripple which can cause Burst Mode operation to be falsely
triggered in the LTC1159. Do not allow the core to saturate!
Molypermalloy (from Magnetics, Inc.) is a low loss core
material for toroids, but it is more expensive than ferrite.
A reasonable compromise from the same manufacturer is
Kool M μ . Toroids are very space efficient, especially when
you can use several layers of wire. Because they generally
lack a bobbin, mounting is more difficult. However, new
surface mount designs available from Coiltronics do not
increase the height significantly.
Power MOSFET Selection
Two external power MOSFETs must be selected for use
with the LTC1159: a P-channel MOSFET for the main
switch and an N-channel MOSFET for the synchronous
switch.
The peak-to-peak drive levels are set by the V CC voltage on
the LTC1159. This voltage is typically 4.5V during start-up
and 5V to 7V during normal operation (see EXTV CC Pin
Connection). Consequently, logic-level threshold
MOSFETs must be used in most LTC1159 family applica-
tions. The only exception is applications in which EXTV CC
is powered from an external supply greater than 8V, in
which standard threshold MOSFETs (V GS(TH) < 4V) may be
used. Pay close attention to the BV DSS specification for the
MOSFETs as well; many of the logic-level MOSFETs are
limited to 30V.
Selection criteria for the power MOSFETs include the “ON”
resistance R DS(ON) , reverse transfer capacitance C RSS ,
input voltage and maximum output current. When the
LTC1159 is operating in continuous mode, the duty cycle
for the P-channel MOSFET is given by:
V
V IN
V – V OUT
V IN
The MOSFET dissipations at maximum output current are
given by:
V OUT
V IN
k(V IN ) 2 (I MAX ) (C RSS ) (f)
V – V OUT
V IN
where ? is the temperature dependency of R DS(ON) and k
is a constant inversely related to the gate drive current.
Both MOSFETs have I 2 R losses while the P-channel
equation includes an additional term for transition losses,
which are highest at high input voltages. For V IN < 20V the
high current efficiency generally improves with larger
MOSFETs, while for V IN > 20V the transition losses rapidly
increase to the point that the use of a higher R DS(ON)
device with lower C RSS actually provides higher effi-
ciency. The N-channel MOSFET losses are the greatest at
high input voltage or during a short circuit when the
N-channel duty cycle is nearly 100%.
The term (1 + ? ) is generally given for a MOSFET in the form
of a normalized R DS(ON) vs Temperature curve, but
? = 0.007/ ° C can be used as an approximation for low
voltage MOSFETs. C RSS is usually specified in the MOSFET
electrical characteristics. The constant k = 5 can be used for
the LTC1159 to estimate the relative contributions of the
two terms in the P-channel dissipation equation.
The Schottky diode D1 shown in Figure 1 only conducts
during the dead time between the conduction of the two
power MOSFETs. D1 prevents the body diode of the
N-channel MOSFET from turning on and storing charge
during the dead time, which could cost as much as 1% in
efficiency (although there are no other harmful effects if
D1 is omitted). Therefore, D1 should be selected for a
forward voltage of less than 0.6V when conducting I MAX .
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1159IS-3.3#TR | IC REG CTRLR BUCK PWM CM 16-SOIC |
| RBM31DRSH-S288 | CONN EDGECARD 62POS .156 EXTEND |
| GEC49DRXI-S734 | CONN EDGECARD 98POS DIP .100 SLD |
| RSM18DRSD-S288 | CONN EDGECARD 36POS DIP .156 SLD |
| VE-B7Y-EX-F1 | CONVERTER MOD DC/DC 3.3V 49.5W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1160CN | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
| LTC1160CS | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
| LTC1160IN | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
| LTC1160IS | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
| LTC1162CN | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
发布紧急采购，3分钟左右您将得到回复。