- 您现在的位置：买卖IC网 > PDF目录15235 > LTC1539CGW (Linear Technology)IC REG CTRLR BUCK PWM CM 36-SSOP PDF资料下载
参数资料
| 型号： | LTC1539CGW |
| 厂商： | Linear Technology |
| 文件页数： | 10/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 36-SSOP |
| 标准包装： | 32 |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 138kHz |
| 占空比： | 99% |
| 电源电压： | 3.5 V ~ 30 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 36-BSOP（0.295"，7.50mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC1538-AUX/LTC1539
OPERATIO N
Main Control Loop
(Refer to Functional Diagram)
Comparator OV guards against transient overshoots
The LTC1538-AUX/LTC1539 use a constant frequency,
current mode step-down architecture. During normal op-
eration, the top MOSFET is turned on each cycle when the
oscillator sets the RS latch and turned off when the main
current comparator I1 resets the RS latch. The peak
inductor current at which I1 resets the RS latch is con-
trolled by the voltage on the I TH1 (I TH2 ) pin, which is the
output of each error amplifier (EA). The V PROG1 pin,
described in the Pin Functions, allows the EA to receive a
selectively attenuated output feedback voltage V FB1 from
the SENSE – 1 pin while V PROG2 and V OSENSE2 allow EA to
receive an output feedback voltage V FB2 from either inter-
nal or external resistive dividers on the second controller.
When the load current increases, it causes a slight de-
crease in V FB relative to the 1.19V reference, which in turn
causes the I TH1 (I TH2 ) voltage to increase until the average
inductor current matches the new load current. After the
large top MOSFET has turned off, the bottom MOSFET is
turned on until either the inductor current starts to reverse,
as indicated by current comparator I2, or the beginning of
the next cycle.
The top MOSFET drivers are biased from floating boot
strap capacitor C B , which normally is recharged during
each Off cycle. When V IN decreases to a voltage close to
V OUT , however, the loop may enter dropout and attempt to
turn on the top MOSFET continuously. The dropout detec-
tor counts the number of oscillator cycles that the top
MOSFET remains on and periodically forces a brief off
period to allow C B to recharge.
The main control loop is shut down by pulling the RUN/
SS1 (RUN/SS2) pin low. Releasing RUN/SS1 (RUN/SS2)
allows an internal 3 μ A current source to charge soft start
capacitor C SS . When C SS reaches 1.3V, the main control
loop is enabled with the I TH1 (I TH2 ) voltage clamped at
approximately 30% of its maximum value. As C SS contin-
ues to charge, I TH1 (I TH2 ) is gradually released allowing
normal operation to resume. When both RUN/SS1 and
RUN/SS2 are low, all LTC1538-AUX/LTC1539 functions
are shut down except for the 5V standby regulator, internal
reference and a comparator. Refer to the LTC1438/LTC1439
for applications which do not require a 5V standby regulator.
10
> 7.5% by turning off the top MOSFET and keeping it off
until the fault is removed.
Low Current Operation
Adaptive Power Mode allows the LTC1539 to automati-
cally change between two output stages sized for different
load currents. The TGL1 (TGL2) and BG1 (BG2) pins drive
large synchronous N-channel MOSFETs for operation at
high currents, while the TGS1 (TGS2) pin drives a much
smaller N-channel MOSFET used in conjunction with a
Schottky diode for operation at low currents. This allows
the loop to continue to operate at normal operating fre-
quency as the load current decreases without incurring the
large MOSFET gate charge losses. If the TGS1 (TGS2) pin
is left open, the loop defaults to Burst Mode operation in
which the large MOSFETs operate intermittently based on
load demand. Adaptive Power mode provides constant
frequency operation down to approximately 1% of rated
load current. This results in an order of magnitude reduc-
tion of load current before Burst Mode operation com-
mences. Without the small MOSFET (ie: no Adaptive
Power mode) the transition to Burst Mode operation is
approximately 10% of rated load current. The transition to
low current operation begins when comparator I2 detects
current reversal and turns off the bottom MOSFET. If the
voltage across R SENSE does not exceed the hysteresis of
I2 (approximately 20mV) for one full cycle, then on follow-
ing cycles the top drive is routed to the small MOSFET at
the TGS1 (TGS2) pin and the BG1 (BG2) pin is disabled.
This continues until an inductor current peak exceeds
20mV/R SENSE or the I TH1 (I TH2 ) voltage exceeds 0.6V,
either of which causes drive to be returned to the TGL1
(TGL2) pin on the next cycle.
Two conditions can force continuous synchronous opera-
tion, even when the load current would otherwise dictate
low current operation. One is when the common mode
voltage of the SENSE + 1 (SENSE + 2) and SENSE – 1
(SENSE – 2) pins are below 1.4V, and the other is when the
SFB1 pin is below 1.19V. The latter condition is used to
assist in secondary winding regulation, as described in the
Applications Information section.
相关PDF资料 |
PDF描述 |
|---|---|
| UVP0J472MHD | CAP ALUM 4700UF 6.3V 20% RADIAL |
| LTC1439CGW#PBF | IC REG CTRLR BUCK PWM CM 36-SSOP |
| EBC43DCST | CONN EDGECARD 86POS DIP .100 SLD |
| LTC1439CGW | IC REG CTRLR BUCK PWM CM 36-SSOP |
| VE-J7V-EY-F1 | CONVERTER MOD DC/DC 5.8V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1539CGW#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539CGW#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539CGW#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539IGW | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539IGW#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。