- 您现在的位置：买卖IC网 > PDF目录15235 > LTC1539CGW (Linear Technology)IC REG CTRLR BUCK PWM CM 36-SSOP PDF资料下载
参数资料
| 型号： | LTC1539CGW |
| 厂商： | Linear Technology |
| 文件页数： | 17/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 36-SSOP |
| 标准包装： | 32 |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 138kHz |
| 占空比： | 99% |
| 电源电压： | 3.5 V ~ 30 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 36-BSOP（0.295"，7.50mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC1538-AUX/LTC1539
APPLICATIO N S I N FOR M ATIO N
(DC) and the V OSENSE2 pin is connected to the feedback
resistors as shown in Figure 5b. Controller 2 will force the
externally attenuated output voltage to 1.19V.
Power-On Reset Function (POR)
The power-on reset function monitors the output voltage
of the first controller and turns on an open drain device
when it is below its properly regulated voltage. An external
pull-up resistor is required on the POR1 pin.
required from the input power supply. If RUN/SS has been
pulled all the way to ground there is a delay before starting
of approximately 500ms/ μ F, followed by a similar time to
reach full current on that controller.
By pulling both RUN/SS controller pins below 1.3V, the
LTC1538-AUX/LTC1539 are put into shutdown
(I Q < 200 μ A). These pins can be driven directly from logic
as shown in Figure 6. Diode D1 in Figure 6 reduces the start
When power is first applied or when coming out of
shutdown, the POR1 output is held at ground. When the
3.3V
OR 5V
D1
RUN/SS1
(RUN/SS2)
RUN/SS1
(RUN/SS2)
output voltage rises above a level which is 5% below the final
regulated output value, an internal counter starts. After this
C SS
C SS
counter counts 2 16 (65536) clock cycles, the POR1 pull-
down device turns off. The POR1 output is active when both
controllers are shut down as long as V IN is powered.
The POR1 output will go low whenever the output voltage
of the first controller drops below 7.5% of its regulated
value for longer than approximately 30 μ s, signaling an
out-of-regulation condition. In shutdown, when RUN/SS1
and RUN/SS2 are both below 1.3V, the POR1 output is
pulled low even if the regulator’s output is held up by an
external source.
RUN/ Soft Start Function
The RUN/SS1 and RUN/SS2 pins each serve two func-
tions. Each pin provides the soft start function and a
means to shut down each controller. Soft start reduces
surge currents from V IN by providing a gradual ramp-up of
the internal current limit. Power supply sequencing can
also be accomplished using this pin.
An internal 3 μ A current source charges up an external
capacitor C SS. When the voltage on RUN/SS1 (RUN/SS2)
reaches 1.3V the particular controller is permitted to start
operating. As the voltage on the pin continues to ramp
from 1.3V to 2.4V, the internal current limit is also ramped
at a proportional linear rate. The current limit begins at
approximately 50mV/R SENSE (at V RUN/SS = 1.3V) and ends
at 150mV/R SENSE (V RUN/SS ≥ 2.7V). The output current
1538 F06
Figure 6. RUN/SS Pin Interfacing
delay but allows C SS to ramp up slowly providing the soft
start function; this diode and C SS can be deleted if soft start
is not needed. Each RUN/SS pin has an internal 6V Zener
clamp (See Functional Diagram).
Foldback Current Limiting
As described in Power MOSFET and D1 Selection, the
worst-case dissipation for either MOSFET occurs with a
short-circuited output, when the synchronous MOSFET
conducts the current limit value almost continuously. In
most applications this will not cause excessive heating,
even for extended fault intervals. However, when heat
sinking is at a premium or higher R DS(ON) MOSFETs are
being used, foldback current limiting should be added to
reduce the current in proportion to the severity of the fault.
Foldback current limiting is implemented by adding diode
D FB between the output and the I TH pin as shown in the
Functional Diagram. In a hard short (V OUT = 0V) the
current will be reduced to approximately 25% of the
maximum output current. This technique may be used for
all applications with regulated output voltages of 1.8V or
greater.
thus ramps up slowly, reducing the starting surge current
17
相关PDF资料 |
PDF描述 |
|---|---|
| UVP0J472MHD | CAP ALUM 4700UF 6.3V 20% RADIAL |
| LTC1439CGW#PBF | IC REG CTRLR BUCK PWM CM 36-SSOP |
| EBC43DCST | CONN EDGECARD 86POS DIP .100 SLD |
| LTC1439CGW | IC REG CTRLR BUCK PWM CM 36-SSOP |
| VE-J7V-EY-F1 | CONVERTER MOD DC/DC 5.8V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1539CGW#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539CGW#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539CGW#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539IGW | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1539IGW#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。