参数资料
型号: LTC1539CGW
厂商: Linear Technology
文件页数: 15/32页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 36-SSOP
标准包装: 32
PWM 型: 电流模式
输出数: 2
频率 - 最大: 138kHz
占空比: 99%
电源电压: 3.5 V ~ 30 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: 0°C ~ 70°C
封装/外壳: 36-BSOP(0.295",7.50mm 宽)
包装: 管件
LTC1538-AUX/LTC1539
APPLICATIO N S I N FOR M ATIO N
higher price. Once the ESR requirement for C OUT has been
met, the RMS current rating generally far exceeds the
I RIPPLE(P-P) requirement.
In surface mount applications multiple capacitors may
have to be paralleled to meet the ESR or RMS current
handling requirements of the application. Aluminum elec-
trolytic and dry tantalum capacitors are both available in
surface mount configurations. In the case of tantalum, it is
critical that the capacitors are surge tested for use in
switching power supplies. An excellent choice is the AVX
TPS series of surface mount tantalums, available in case
heights ranging from 2mm to 4mm. Other capacitor types
include Sanyo OS-CON, Nichicon PL series and Sprague
593D and 595D series. Consult the manufacturer for other
specific recommendations.
INTV CC / 5V Standby Regulator
An internal P-channel low dropout regulator produces 5V
at the INTV CC pin from the V IN supply pin. INTV CC powers
the drivers and internal circuitry within the LTC1538-AUX/
LTC1539, as well as any “wake-up” circuitry tied externally
to the INTV CC pin. The INTV CC pin regulator can supply
40mA and must be bypassed to ground with a minimum
of 2.2 μ F tantalum or low ESR electrolytic capacitor. Good
bypassing is necessary to supply the high transient cur-
rents required by the MOSFET gate drivers.
To prevent any interaction due to the high transient gate
currents being drawn from the external capacitor an
additional series filter of 10 ? and 10 μ F to SGND can be
added.
High input voltage applications in which large MOSFETs
are being driven at high frequencies may cause the maxi-
mum junction temperature rating for the LTC1538-AUX/
LTC1539 to be exceeded. The IC supply current is domi-
nated by the gate charge supply current when not using an
output derived EXTV CC source. The gate charge is depen-
dent on operating frequency as discussed in the Efficiency
Considerations section. The junction temperature can be
estimated by using the equations given in Note 1 of the
Electrical Characteristics. For example, the LTC1539 is
limited to less than 21mA from a 30V supply:
T J = 70 ° C + (21mA)(30V)(85 ° C/W) = 124 ° C
To prevent maximum junction temperature from being
exceeded, the input supply current must be checked while
operating in continuous mode at maximum V IN .
EXTV CC Connection
The LTC1538-AUX/LTC1539 contain an internal P-chan-
nel MOSFET switch connected between the EXTV CC and
INTV CC pins. When the voltage applied to EXTV CC rises
above 4.8V, the internal regulator is turned off and an
internal switch closes, connecting the EXTV CC pin to the
INTV CC pin thereby supplying internal power to the IC. The
switch remains closed as long as the voltage applied to
EXTV CC remains above 4.5V. This allows the MOSFET
driver and control power to be derived from the output
during normal operation (4.8V < V OUT < 9V) and from the
internal regulator when the output is out of regulation
(start-up, short circuit). Do not apply greater than 10V to
the EXTV CC pin and ensure that EXTV CC ≤ V IN .
Significant efficiency gains can be realized by powering
INTV CC from the output, since the V IN current resulting
from the driver and control currents will be scaled by a
factor of Duty Cycle/Efficiency. For 5V regulators this
supply means connecting the EXTV CC pin directly to V OUT .
However, for 3.3V and other lower voltage regulators,
additional circuitry is required to derive INTV CC power
from the output.
The following list summarizes the four possible connec-
tions for EXTV CC:
1. EXTV CC left open (or grounded). This will cause INTV CC
to be powered from the internal 5V regulator resulting
in an efficiency penalty of up to 10% at high input
voltages.
2. EXTV CC connected directly to V OUT . This is the normal
connection for a 5V regulator and provides the highest
efficiency.
3. EXTV CC connected to an output-derived boost network.
For 3.3V and other low voltage regulators, efficiency
gains can still be realized by connecting EXTV CC to an
output-derived voltage which has been boosted to
15
相关PDF资料
PDF描述
UVP0J472MHD CAP ALUM 4700UF 6.3V 20% RADIAL
LTC1439CGW#PBF IC REG CTRLR BUCK PWM CM 36-SSOP
EBC43DCST CONN EDGECARD 86POS DIP .100 SLD
LTC1439CGW IC REG CTRLR BUCK PWM CM 36-SSOP
VE-J7V-EY-F1 CONVERTER MOD DC/DC 5.8V 50W
相关代理商/技术参数
参数描述
LTC1539CGW#PBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1539CGW#TR 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1539CGW#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1539IGW 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1539IGW#PBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX