- 您现在的位置：买卖IC网 > PDF目录10688 > LTC2435-1CGN#PBF (Linear Technology)IC ADC DIFF I/REF 20BIT 16-SSOP PDF资料下载
参数资料
| 型号： | LTC2435-1CGN#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/42页 |
| 文件大小： | 0K |
| 描述： | IC ADC DIFF I/REF 20BIT 16-SSOP |
| 标准包装： | 100 |
| 位数： | 20 |
| 采样率（每秒）： | 13.75 |
| 数据接口： | MICROWIRE?，串行，SPI? |
| 转换器数目： | 2 |
| 功率耗散（最大）： | 1mW |
| 电压电源： | 单电源 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SSOP |
| 包装： | 管件 |
| 输入数目和类型： | 1 个差分，双极 |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
LTC2435/LTC2435-1
16
24351fc
For more information www.linear.com/LTC2435
applicaTions inForMaTion
Frequency Rejection Selection LTC2435 (FO)
The LTC2435 internal oscillator provides better than 110dB
normalmoderejectionatthelinefrequencyanditsharmonics
for 50Hz ±2% or 60Hz ±2%. For 60Hz rejection, FO should
be connected to GND while for 50Hz rejection the FO pin
should be connected to VCC.
The selection of 50Hz or 60Hz rejection can also be made by
driving FO to an appropriate logic level. A selection change
during the sleep or data output states will not disturb the
converter operation. If the selection is made during the
conversion state, the result of the conversion in progress
maybeoutsidespecificationsbutthefollowingconversions
will not be affected.
When a fundamental rejection frequency different from
50Hz or 60Hz is required or when the converter must be
synchronized with an outside source, the LTC2435 can
operate with an external conversion clock. The converter
automatically detects the presence of an external clock
signal at the FO pin and turns off the internal oscillator.
The frequency fEOSC of the external signal must be at least
5kHz to be detected. The external clock signal duty cycle
is not significant as long as the minimum and maximum
specifications for the high and low periods tHEO and tLEO
are observed.
While operating with an external conversion clock of a
frequency fEOSC, the LTC2435 provides better than 110dB
normal mode rejection in a frequency range fEOSC/2560
±4% and its harmonics. The normal mode rejection as a
function of the input frequency deviation from fEOSC/2560
is shown in Figure 7a.
Whenever an external clock is not present at the FO pin, the
converter automatically activates its internal oscillator and
enters the Internal Conversion Clock mode. The LTC2435
operation will not be disturbed if the change of conversion
clock source occurs during the sleep state or during the
data output state while the converter uses an external serial
clock. If the change occurs during the conversion state,
the result of the conversion in progress may be outside
specifications but the following conversions will not be
affected. If the change occurs during the data output state
and the converter is in the Internal SCK mode, the serial
clock duty cycle may be affected but the serial data stream
will remain valid.
Table 3a summarizes the duration of each state and the
achievable output data rate as a function of FO.
Frequency Rejection Selection LTC2435-1 (FO)
TheLTC2435-1internaloscillatorprovidesbetterthan87dB
normal mode rejection over the range of 49Hz to 61.2Hz as
shown in Figure 7b. For simultaneous 50Hz/60Hz rejection,
FO should be connected to GND.
In order to achieve 87dB normal mode rejection of 50Hz
±2% and 60Hz ±2%, two consecutive conversions must be
averaged. By performing a continuous running average of
thetwomostcurrentresults,bothsimultaneousrejectionis
achieved and a nearly 2× increase in throughput is realized
relativetotheLTC2430(seeNormalModeRejection,Output
Rate and Running Averages sections of this data sheet).
When a fundamental rejection frequency different from
the range 49Hz to 61.2Hz is required or when the con-
verter must be synchronized with an outside source, the
LTC2435-1 can operate with an external conversion clock.
The performance of the LTC2435-1 is the same as the
LTC2435 when driven by an external conversion clock
at the FO pin.
Table 3b summarizes the duration of each state and the
achievable output data rate as a function of FO.
Serial Interface Pins
The LTC2435/LTC2435-1 transmit the conversion results
and receive the start of conversion command through a
synchronous 3-wire interface. During the conversion and
sleep states, this interface can be used to assess the con-
verter status and during the data output state it is used to
read the conversion result.
相关PDF资料 |
PDF描述 |
|---|---|
| AD8611ARZ-REEL7 | IC COMP SGL 4NS ULTRFAST 8SOIC |
| AD7823YRZ | IC ADC 8BIT SRL 2.7/5.5V 8-SOIC |
| LTC1540IMS8#TRPBF | IC COMP NANOPOWER W/REF 8-MSOP |
| ISL4489EIBZ | TRANSCEIVER RS-485/422 14-SOIC |
| LTC1540IMS8#TR | IC COMP 300NA 2% VOLT REF 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2435-1IGN | 功能描述:IC CONV A/D 20BIT DIFF 16-SSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2435-1IGN#PBF | 功能描述:IC ADC DIFF I/REF 20BIT 16-SSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2435-1IGN#TR | 功能描述:IC CONV A/D 20BIT DIFF 16-SSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC2435-1IGN#TRPBF | 功能描述:IC ADC DIFF I/REF 20BIT 16-SSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC2435CGN | 功能描述:IC ADC DIFF I/REF 20BIT 16-SSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
发布紧急采购，3分钟左右您将得到回复。