- 您现在的位置：买卖IC网 > PDF目录98002 > LTC3125EDCB#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, 1900 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | LTC3125EDCB#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, 1900 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | 2 X 2 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, DFN-8 |
| 文件页数： | 18/18页 |
| 文件大小： | 303K |
| 代理商： | LTC3125EDCB#PBF |
LTC3125
9
3125fa
OPERATION
prevents the inductor current from reversing in polarity,
improving efciency at light loads.
OSCILLATOR
An internal oscillator sets the switching frequency to
1.6MHz.
SHUTDOWN
Shutdown of the boost converter is accomplished by
pulling SHDN below 0.35V and enabled by pulling SHDN
above 1V. Note that SHDN can be driven above VIN or
VOUT, as long as it is limited to less than the absolute
maximum rating.
OUTPUT DISCONNECT
The LTC3125 is designed to allow true output disconnect
by eliminating body diode conduction of the internal
P-channel MOSFET rectier. This allows for VOUT to go
to zero volts during shutdown, drawing no current from
the input source. It also limits inrush current at turn-on,
minimizing surge currents seen by the input supply. Note
that to obtain the advantages of output disconnect, there
cannot be an external Schottky diode connected between
the SW pin and VOUT. The output disconnect feature also
allows VOUT to be pulled high, without any reverse current
into the power source connected to VIN.
THERMAL SHUTDOWN
If the die temperature exceeds 160°C typical, the LTC3125
will go into thermal shutdown. All switches will be off and
the soft-start capacitor will be discharged. The device
will be enabled again when the die temperature drops by
approximately 15°C.
SYNCHRONOUS RECTIFIER
To control inrush current and to prevent the inductor
current from running away when VOUT is close to VIN, the
P-channel MOSFET synchronous rectier is only enabled
when VOUT > (VIN + 0.38V).
ANTI-RINGING CONTROL
The anti-ringing control connects a resistor across the
inductor to prevent high frequency ringing on the SW pin
during discontinuous current mode operation. Although
the ringing of the resonant circuit formed by L and CSW
(capacitance on SW pin) is low energy, it can cause EMI
radiation.
SOFT-START
The LTC3125 contains internal circuitry to provide soft-
start operation. The soft-start circuitry slowly ramps the
peak inductor current from zero to its peak value of 1.8A
(typical) in approximately 0.5ms, allowing start-up into
heavy loads. The soft-start circuitry is reset in the event
of a shutdown command or a thermal shutdown.
Burst Mode OPERATION
The LTC3125 will automatically enter Burst Mode opera-
tion at light load and return to xed frequency PWM mode
when the load increases. Refer to the Typical Performance
Characteristics to see the output load Burst Mode thresh-
old current vs VIN. The load current at which Burst Mode
operation is entered can be changed by adjusting the
inductor value. Raising the inductor value will lower the
load current at which Burst Mode operation is entered.
In Burst Mode operation, the LTC3125 still switches at a
xed frequency of 1.6MHz, using the same error amplier
and loop compensation for peak current mode control.
This control method eliminates any output transient
when switching between modes. In Burst Mode opera-
tion, energy is delivered to the output until it reaches the
nominal regulation value, then the LTC3125 transitions to
sleep mode where the outputs are off and the LTC3125
consumes only 15μA of quiescent current from VOUT.When
the output voltage droops slightly, switching resumes.
This maximizes efciency at very light loads by minimizing
switching and quiescent losses.
As the load current increases, the LTC3125 will automati-
cally leave Burst Mode operation. Once the LTC3125 has left
Burst Mode operation and returned to normal operation,
it will remain there until the output load is reduced below
the burst threshold.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3406ES5-1.2#PBF | 1.3 A SWITCHING REGULATOR, 1800 kHz SWITCHING FREQ-MAX, PDSO5 |
| LTC3414MPFE#PBF | 9.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO20 |
| LTC3522EUD#TR | 0.85 A DUAL SWITCHING CONTROLLER, 1330 kHz SWITCHING FREQ-MAX, PQCC16 |
| LTC3525LESC6-3#PBF | 0.45 A SWITCHING REGULATOR, PDSO6 |
| LTC3526LEDC | SWITCHING CONTROLLER, 1250 kHz SWITCHING FREQ-MAX, PDSO6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3125EDCBTRMPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Up 1.8-5.5V DFN8EP |
| LTC3125EDCB-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2A Synchronous Step-Up DC/DC Converter with Input Current Limit |
| LTC3127 | 制造商:LINEAR 制造商全称:LINEAR 功能描述:40V, 2A Synchronous Buck-Boost DC/DC Converter |
| LTC3127EDD | 制造商:LINER 制造商全称:Linear Technology 功能描述:1A Buck-Boost DC/DC Converter with Programmable Input Current Limit |
| LTC3127EDD#PBF | 功能描述:IC BUCK BOOST SYNC ADJ 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 应用:热电冷却器 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.173"，4.40mm 宽）裸露焊盘 供应商设备封装:28-TSSOP 裸露焊盘 包装:管件 产品目录页面:1410 (CN2011-ZH PDF) |
发布紧急采购，3分钟左右您将得到回复。