- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3407EDD#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ 1A DL 10DFN PDF资料下载
参数资料
| 型号： | LTC3407EDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1A DL 10DFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.6 V ~ 5 V |
| 输入电压： | 2.5 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1.5MHz |
| 电流 - 输出： | 1A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-DFN（3x3） |
LTC3407
APPLICATIONS INFORMATION
capacitors, such as Sanyo POSCAP, offer very low ESR,
but have a lower capacitance density than other types.
Tantalum capacitors have the highest capacitance density,
but it has a larger ESR and it is critical that the capacitors
are surge tested for use in switching power supplies.
An excellent choice is the AVX TPS series of surface
mount tantalums, available in case heights ranging from
2mm to 4mm. Aluminum electrolytic capacitors have a
signi?cantly larger ESR, and are often used in extremely
cost-sensitive applications provided that consideration
is given to ripple current ratings and long term reliability.
Ceramic capacitors have the lowest ESR and cost, but also
have the lowest capacitance density, a high voltage and
temperature coef?cient, and exhibit audible piezoelectric
effects. In addition, the high Q of ceramic capacitors along
with trace inductance can lead to signi?cant ringing. Other
capacitor types include the Panasonic special polymer
(SP) capacitors.
In most cases, 0.1μF to 1μF of ceramic capacitors should
also be placed close to the LTC3407 in parallel with the
main capacitors for high frequency decoupling.
V IN = 2.5V
TO 5.5V
caps are prone to temperature effects which requires the
designer to check loop stability over the operating tem-
perature range. To minimize their large temperature and
voltage coef?cients, only X5R or X7R ceramic capacitors
should be used. A good selection of ceramic capacitors
is available from Taiyo Yuden, TDK, and Murata.
Great care must be taken when using only ceramic input
and output capacitors. When a ceramic capacitor is used
at the input and the power is being supplied through long
wires, such as from a wall adapter, a load step at the output
can induce ringing at the V IN pin. At best, this ringing can
couple to the output and be mistaken as loop instability.
At worst, the ringing at the input can be large enough to
damage the part.
Since the ESR of a ceramic capacitor is so low, the input
and output capacitor must instead ful?ll a charge storage
requirement. During a load step, the output capacitor must
instantaneously supply the current to support the load
until the feedback loop raises the switch current enough
to support the load. The time required for the feedback
loop to respond is dependent on the compensation and
the output capacitor size. Typically, 3-4 cycles are required
C IN
BURST*
PULSESKIP*
RUN2 V IN
MODE/SYNC
RUN1
POR
R5
POWER-ON
RESET
to respond to a load step, but only in the ?rst cycle does
the output drop linearly. The output droop, V DROOP , is
LTC3407
usually about 3 times the linear drop of the ?rst cycle.
V OUT2
C5
L2
SW2
SW1
L1
C4
V OUT1
Thus, a good place to start is with the output capacitor
size of approximately:
C OUT2
R4
R3
V FB2
GND
V FB1
R1
R2
C OUT1
C OUT ≈ 3
Δ I OUT
f O ? V DROOP
3407 F02
*MODE/SYNC = 0V: PULSE-SKIPPING
MODE/SYNC = V IN : Burst Mode OPERATION
Figure 2. LTC3407 General Schematic
Ceramic Input and Output Capacitors
Higher value, lower cost ceramic capacitors are now be-
coming available in smaller case sizes. These are tempting
for switching regulator use because of their very low ESR.
Unfortunately, the ESR is so low that it can cause loop
stability problems. Solid tantalum capacitor ESR gener-
ates a loop “zero” at 5kHz to 50kHz that is instrumental in
giving acceptable loop phase margin. Ceramic capacitors
remain capacitive to beyond 300kHz and usually resonate
More capacitance may be required depending on the duty
cycle and load step requirements.
In most applications, the input capacitor is merely required
to supply high frequency bypassing, since the impedance
to the supply is very low. A 10μF ceramic capacitor is
usually enough for these conditions.
Setting the Output Voltage
The LTC3407 develops a 0.6V reference voltage between
the feedback pin, V FB , and the ground as shown in Figure 2.
The output voltage is set by a resistive divider according
to the following formula:
with their ESL before ESR becomes effective. Also, ceramic
3407fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3408EDD#TRPBF | IC REG BUCK W/BYPASS TXRX 8-DFN |
| LTC3409IDD#TRPBF | IC REG BUCK SYNC ADJ 0.6A 8DFN |
| LTC3410BESC6-1.8#TRPBF | IC REG BUCK SYNC 1.8V .3A SC70-6 |
| LTC3411AIMS#TRPBF | IC REG BUCK SYNC ADJ 10MSOP |
| LTC3411IMS#TRPBF | IC REG BUCK SYNC ADJ 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3407EMSE | 功能描述:IC REG BUCK SYNC ADJ 1A 10MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3407EMSE#PBF | 功能描述:IC REG BUCK SYNC ADJ 1A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3407EMSE#TR | 功能描述:IC REG BUCK SYNC ADJ 1A 10MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3407EMSE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3407EMSE-2 | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 2.5V to 5.5V 10-Pin MSOP EP |
发布紧急采购，3分钟左右您将得到回复。