- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3522EUD#TRPBF (Linear Technology)IC REG BUCK BOOST SYNC ADJ 16QFN PDF资料下载
参数资料
| 型号： | LTC3522EUD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK BOOST SYNC ADJ 16QFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压），升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.4 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1.07MHz |
| 电流 - 输出： | 200mA，400mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-QFN-EP（3x3） |
LTC3522
OPERATION
The LTC3522 combines a synchronous buck DC/DC
converter and a 4-switch buck-boost DC/DC converter
in a single 3mm × 3mm QFN package. The buck-boost
converter utilizes a proprietary switching algorithm which
allows its output voltage to be regulated above, below or
equal to the input voltage. The buck converter provides a
high ef?ciency lower voltage output and supports 100%
duty cycle operation to extend battery life. In Burst Mode
operation, the combined quiescent current for both con-
verters is reduced to 25μA. Both converters operate from
the same internal 1MHz oscillator.
BUCK CONVERTER OPERATION
Characteristics section of this data sheet. Under dropout
and near dropout conditions, Burst Mode operation will
not be entered.
Dropout Operation
As the input voltage decreases to a value approaching the
output regulation voltage, the duty cycle increases toward
the maximum on-time. Further reduction of the supply
voltage will force the main switch to remain on for more
than one cycle until 100% duty cycle operation is reached
where the main switch remains on continuously. In this
dropout state, the output voltage will be determined by
the input voltage less the resistive voltage drop across the
main switch and series resistance of the inductor.
PWM Mode Operation
When the PWM pin is held high, the LTC3522 buck con-
verter uses a constant frequency, current mode control
architecture. Both the main (P-channel MOSFET) and
synchronous recti?er (N-channel MOSFET) switches are
internal. At the start of each oscillator cycle, the P-chan-
nel switch is turned on and remains on until the current
waveform with superimposed slope compensation ramp
exceeds the error ampli?er output. At this point, the syn-
chronous recti?er is turned on and remains on until the
inductor current falls to zero or a new switching cycle is
initiated. As a result, the buck converter operates with
discontinuous inductor current at light loads which im-
proves ef?ciency. At extremely light loads, the minimum
on-time of the main switch will be reached and the buck
converter will begin turning off for multiple cycles in order
to maintain regulation.
Burst Mode Operation
When the PWM pin is forced low, the buck converter will
automatically transition between Burst Mode operation
at suf?ciently light loads (below approximately 10mA)
and PWM mode at heavier loads. Burst Mode entry is
determined by the peak inductor current and therefore
the load current at which Burst Mode operation will be
entered depends on the input voltage, the output voltage
and the inductor value. Typical curves for Burst Mode
Slope Compensation
Current mode control requires the use of slope compensa-
tion to prevent sub-harmonic oscillations in the inductor
current waveform at high duty cycle operation. This is ac-
complished internally on the LTC3522 through the addition
of a compensating ramp to the current sense signal. In
some current mode ICs, current limiting is performed by
clamping the error ampli?er voltage to a ?xed maximum.
This leads to a reduced output current capability at low
step-down ratios. In contrast, the LTC3522 performs cur-
rent limiting prior to addition of the slope compensation
ramp and therefore achieves a peak inductor current limit
that is independent of duty cycle.
Short-Circuit Protection
When the output is shorted to ground, the error ampli?er
will saturate high and the P-channel MOSFET switch will
turn on at the start of each cycle and remain on until the
current limit trips. During this minimum on-time, the in-
ductor current will increase rapidly and will decrease very
slowly during the remainder of the period due to the very
small reverse voltage produced by a hard output short.
To eliminate the possibility of inductor current runaway
in this situation, the buck converter switching frequency
is reduced to approximately 250kHz when the voltage on
FB2 falls below 0.3V.
entry threshold are provided in the Typical Performance
3522fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3523EUD-2#TRPBF | IC REG BUCK BOOST SYNC ADJ 16QFN |
| LTC3525ESC6-3.3#TRPBF | IC REG BST SYNC 3.3V 0.4A SC70-6 |
| LTC3526BEDC#TRPBF | IC REG BOOST SYNC ADJ 0.5A 6DFN |
| LTC3527EUD-1#TRPBF | IC REG BOOST SYNC ADJ DL 16QFN |
| LTC3528EDDB#TRPBF | IC REG BOOST SYNC ADJ 1A 8DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3523 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Synchronous 600mA Step-Up and 400mA Step-Down DC/DC Converters |
| LTC3523EUD#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3523EUD#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3523EUD-2#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3523EUD-2#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。