- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3534EGN#TRPBF (Linear Technology)IC REG BUCK BST SYNC 0.5A 16SSOP PDF资料下载
参数资料
| 型号： | LTC3534EGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK BST SYNC 0.5A 16SSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压），升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.8 V ~ 7 V |
| 输入电压： | 2.4 V ~ 7 V |
| PWM 型： | Burst Mode? |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 500mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-SSOP |
LTC3534
PIN FUNCTIONS
V OUT = 1.000 ?
R1 + R2
GNDPads(Pins1,8,9,16;GNPackage): ICSubstrate
Grounds. These pins MUST be soldered to the printed
circuit board ground to provide both electrical contact
and a good thermal contact to the PCB.
RUN/SS (Pin 2): Combined Shutdown and Soft-Start. Ap-
plying a voltage below 400mV shuts down the IC. Apply
a voltage above 1.4V to enable the IC and above 2.4V to
ensure that the error amp is not clamped from soft-start.
An R-C from the enable command signal to this pin will
provide a soft-start function by limiting the rise time of
the V C pin. PWM mode operation must be commanded
to properly enable the IC.
GND (Pin 3): Signal Ground for the IC.
PGND1, PGND2 (Pins 4, 7): Power Ground for the Internal
N-channel MOSFET Power Switches (Switches B and C).
SW1 (Pin 5): Switch Pin where Internal Switches A and
B are Connected. Connect inductor from SW1 to SW2.
Minimize trace length to reduce EMI.
SW2 (Pin 6): Switch Pin where Internal Switches C and
D are Connected. Minimize trace length to reduce EMI.
PWM (Pin 10): Burst Mode Select. PWM must be driven
HIGH during start-up. When V OUT is in regulation, the
PWM pin may be driven LOW to command Burst Mode
operation. Applying a voltage below 400mV enables Burst
Mode operation, providing a significant efficiency improve-
ment at light loads. Burst Mode operation will continue
until this pin is driven high. Applying a voltage above 1.4V
disables Burst Mode operation, enabling low noise, fixed
frequency operation.
V OUT (Pin 11): Output of the Synchronous Rectifier. A filter
capacitor is placed from V OUT to GND. A ceramic bypass
capacitor is recommended as close to the V OUT and GND
pins as possible. V OUT is given by the following equation:
V
R2
PV IN (Pin 12): Power V IN Supply Pin. A 10μF ceramic
capacitor is recommended as close to the PV IN and PGND
pins as possible.
V IN (Pin 13): Input Supply Pin. Connect the power source
to this pin.
V C (Pin 14): Error Amp Output. An R-C network is con-
nected from this pin to FB for loop compensation. Refer
to “Closing the Feedback Loop” section for component
selection guidelines.
FB (Pin 15): Feedback Pin. Connect V OUT resistor divider
tap to this pin. The output voltage can be adjusted from
1.8V to 7V. The feedback reference voltage is typically 1V.
Exposed Pad (Pin 17; DHC Package): IC Substrate Ground.
This pin MUST be soldered to the printed circuit board
ground to provide both electrical contact and a good
thermal contact to the PCB.
3534fb
For more information www.linear.com/LTC3534
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3535EDD#PBF | IC REG BST SYNC ADJ 0.55A 12DFN |
| LTC3536IMSE#TRPBF | IC REG BUCK BST SYNC ADJ 12MSOP |
| LTC3538EDCB#TRPBF | IC REG BUCK BOOST SYNC ADJ 8DFN |
| LTC3539EDCB-2#TRPBF | IC REG BOOST SYNC ADJ 2A 8DFN |
| LTC3542IDC#TRMPBF | IC REG BUCK SYNC ADJ 0.5A 6DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3535 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter |
| LTC3535EDD#PBF | 功能描述:IC REG BST SYNC ADJ 0.55A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3535EDD#PBF | 制造商:Linear Technology 功能描述:DC/DC CONVERTER IC |
| LTC3535EDD#TRPBF | 功能描述:IC REG BST SYNC ADJ 0.55A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3535EDD-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter |
发布紧急采购，3分钟左右您将得到回复。