- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3534EGN#TRPBF (Linear Technology)IC REG BUCK BST SYNC 0.5A 16SSOP PDF资料下载
参数资料
| 型号： | LTC3534EGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK BST SYNC 0.5A 16SSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压），升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.8 V ~ 7 V |
| 输入电压： | 2.4 V ~ 7 V |
| PWM 型： | Burst Mode? |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 500mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-SSOP |
LTC3534
OPERATION
The LTC3534 provides high efficiency, low noise power
for a wide variety of handheld electronic devices. Linear
Technology’s proprietary topology allows input voltages
above, below or equal to the output voltage by properly
phasing the output switches. The error amplifier output
voltage on V C determines the output duty cycle of the
switches. Since V C is a filtered signal, it provides rejection
of frequencies from well below the switching frequency.
The low R DS(ON) , low gate charge synchronous switches
provide high frequency pulse width modulation control at
high efficiency. High efficiency is achieved at light loads
when Burst Mode operation is invoked and the LTC3534’s
quiescent current drops to a mere 25μA.
LOW NOISE FIXED FREQUENCY OPERATION
Oscillator
The frequency of operation is internally set to 1MHz.
Error Amplifier
The error amplifier is a voltage mode amplifier. The loop
compensation components are configured around the
amplifier (from FB to V C ) to obtain stability of the converter.
For improved bandwidth, an additional R-C feedforward
network can be placed across the upper feedback divider
resistor. The voltage on RUN/SS clamps the error amplifier
output, V C , to provide a soft-start function.
Supply Current Limits
There are two different supply current limit circuits in the
LTC3534, each having internally fixed thresholds.
The first circuit is an average current limit amplifier, sourc-
ing current out of FB to drop the output voltage should
the peak input current exceed 1.8A typical. This method
provides a closed loop means of clamping the input cur-
rent. During conditions where V OUT is near ground, such
as during a short circuit or start-up, this threshold is cut
to 800mA typical, providing a foldback feature. For this
current limit feature to be most effective, the Thevenin
resistance from FB to ground should be greater than 100k.
Should the peak input current exceed 2.6A typical, the
second circuit, a high speed peak current limit compara-
tor, shuts off PMOS switch A. The delay to output of this
comparator is typically 50ns.
Reverse Current Limit
During fixed frequency operation, the LTC3534 operates
in forced continuous conduction mode. The reverse cur-
rent limit comparator monitors the inductor current from
the output through PMOS switch D. Should this negative
inductor current exceed 500mA typical, the LTC3534
shuts off switch D.
Four-Switch Control
Figure 1 shows a simplified diagram of how the four internal
switches are connected to the inductor, PV IN , V OUT , PGND1
and PGND2. Figure 2 shows the regions of operation for
the LTC3534 as a function of the internal control voltage,
V CI . Dependent on the magnitude of V CI , the LTC3534 will
operate in buck, buck-boost or boost mode. V CI is a level
INTERNAL
DUTY CONTROL
CYCLE VOLTAGE, V CI
PV IN
12
PMOS A
SW1
5
L1
SW2
6
V OUT
11
PMOS D
85%
D MAX
BOOST
D MIN
BOOST
D MAX
BUCK
A ON, B OFF
PWM C AND D
SWITCHES
FOUR SWITCH PWM
D ON, C OFF
BOOST REGION
BUCK-BOOST REGION
V4 ( ～ 1.2V)
V3 ( ～ 720mV)
V2 ( ～ 640mV)
NMOS B
4
PGND1
NMOS C
7
3534 F01
PGND2
0%
PWM A AND B
SWITCHES
BUCK REGION
3534 F02
V1 ( ～ 100mV)
Figure 1. Simplified Diagram of Output Switches
Figure 2. Switch Control vs Internal Control Voltage, V CI
3534fb
For more information www.linear.com/LTC3534
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3535EDD#PBF | IC REG BST SYNC ADJ 0.55A 12DFN |
| LTC3536IMSE#TRPBF | IC REG BUCK BST SYNC ADJ 12MSOP |
| LTC3538EDCB#TRPBF | IC REG BUCK BOOST SYNC ADJ 8DFN |
| LTC3539EDCB-2#TRPBF | IC REG BOOST SYNC ADJ 2A 8DFN |
| LTC3542IDC#TRMPBF | IC REG BUCK SYNC ADJ 0.5A 6DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3535 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter |
| LTC3535EDD#PBF | 功能描述:IC REG BST SYNC ADJ 0.55A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3535EDD#PBF | 制造商:Linear Technology 功能描述:DC/DC CONVERTER IC |
| LTC3535EDD#TRPBF | 功能描述:IC REG BST SYNC ADJ 0.55A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3535EDD-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter |
发布紧急采购，3分钟左右您将得到回复。