- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3547EDDB-1#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ .3A DL 8DFN PDF资料下载
参数资料
| 型号： | LTC3547EDDB-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ .3A DL 8DFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.5 V ~ 5.5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 2.25MHz |
| 电流 - 输出： | 300mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 8-DFN（3x2） |
LTC3547
OPERATIO
(Refer to Functional Diagram )
The LTC3547 uses a constant-frequency current mode
architecture. The operating frequency is set at 2.25MHz.
Both channels share the same clock and run in-phase.
The output voltage is set by an external resistor divider
returned to the V FB pins. An error ampli?er compares the
divided output voltage with a reference voltage of 0.6V and
regulates the peak inductor current accordingly.
Main Control Loop
During normal operation, the top power switch (P-channel
MOSFET) is turned on at the beginning of a clock cycle
when the V FB voltage is below the reference voltage. The
current into the inductor and the load increases until the
peak inductor current (controlled by I TH ) is reached. The
RS latch turns off the synchronous switch and energy
stored in the inductor is discharged through the bottom
switch (N-channel MOSFET) into the load until the next
clock cycle begins, or until the inductor current begins to
reverse (sensed by the I RCMP comparator).
The peak inductor current is controlled by the internally
compensated I TH voltage, which is the output of the er-
ror ampli?er. This ampli?er regulates the V FB pin to the
internal 0.6V reference by adjusting the peak inductor
current accordingly.
Burst Mode Operation
To optimize ef?ciency, the LTC3547 automatically switches
from continuous operation to Burst Mode operation when
the load current is relatively light. During Burst Mode op-
eration, the peak inductor current (as set by I TH ) remains
?xed at approximately 60mA and the PMOS switch operates
intermittently based on load demand. By running cycles
periodically, the switching losses are minimized.
The duration of each burst event can range from a few
Dropout Operation
When the input supply voltage decreases toward the out-
put voltage the duty cycle increases to 100%, which is the
dropout condition. In dropout, the PMOS switch is turned
on continuously with the output voltage being equal to the
input voltage minus the voltage drops across the internal
P-channel MOSFET and the inductor.
An important design consideration is that the R DS(ON)
of the P-channel switch increases with decreasing input
supply voltage (see Typical Performance Characteristics).
Therefore, the user should calculate the worst-case power
dissipation when the LTC3547 is used at 100% duty cycle
with low input voltage (see Thermal Considerations in the
Applications Information Section).
Soft-Start
In order to minimize the inrush current on the input by-
pass capacitor, the LTC3547 slowly ramps up the output
voltage during start-up. Whenever the RUN1 or RUN2 pin
is pulled high, the corresponding output will ramp from
zero to full-scale over a time period of approximately
650μs. This prevents the LTC3547 from having to quickly
charge the output capacitor and thus supplying an exces-
sive amount of instantaneous current.
Short-Circuit Protection
When either regulator output is shorted to ground, the
corresponding internal N-channel switch is forced on for
a longer time period for each cycle in order to allow the
inductor to discharge, thus preventing current runaway.
This technique has the effect of decreasing switching
frequency. Once the short is removed, normal operation
resumes and the regulator output will return to its nominal
voltage.
cycles at light load to almost continuous cycling with
short sleep intervals at moderate loads. During the sleep
intervals, the load current is being supplied solely from
the output capacitor. As the output voltage droops, the
error ampli?er output rises above the sleep threshold,
signaling the burst comparator to trip and turn the top
MOSFET on. This cycle repeats at a rate that is dependent
on load demand.
3547fa
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3548IMSE#TRPBF | IC REG BUCK SYNC ADJ DL 10MSOP |
| LTC3549EDCB#TRPBF | IC REG BUCK SYNC ADJ 0.25A 6DFN |
| LTC3550EDHC-1#TRPBF | IC CHARGER BATT DUAL 16-DFN |
| LTC3552EDHC-1#TRPBF | IC CHARGER BATT LI-ION 16-DFN |
| LTC3559EUD-1#TRPBF | IC USB BATTERY CHARGER 16-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3548 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous,400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous, Fixed Output 2.25MHz Step-Down DC/DC Regulator |
| LTC3548-2 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous, Fixed/Adjustable Output, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548A | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous 400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548AEDD | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous 400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
发布紧急采购，3分钟左右您将得到回复。