- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3547EDDB-1#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ .3A DL 8DFN PDF资料下载
参数资料
| 型号： | LTC3547EDDB-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ .3A DL 8DFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.5 V ~ 5.5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 2.25MHz |
| 电流 - 输出： | 300mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 8-DFN（3x2） |
LTC3547
APPLICATIO S I FOR ATIO
Input Capacitor (C IN ) Selection
In continuous mode, the input current of the converter
is a square wave with a duty cycle of approximately
V OUT /V IN . To prevent large voltage transients, a low equiv-
alent series resistance (ESR) input capacitor sized for
the maximum RMS current must be used. The max-
imum RMS capacitor current is given by:
where f = operating frequency, C OUT = output capacitance
and Δ I L = ripple current in the inductor. For a ?xed output
voltage, the output ripple is highest at maximum input
voltage since Δ I L increases with input voltage.
If tantalum capacitors are used, it is critical that the capaci-
tors are surge tested for use in switching power supplies.
An excellent choice is the AVX TPS series of surface mount
tantalum. These are specially constructed and tested for low
I RMS ≈ I MAX
V OUT ( V IN ? V OUT )
V IN
(2)
ESR so they give the lowest ESR for a given volume. Other
capacitor types include Sanyo POSCAP, Kemet T510 and
T495 series, and Sprague 593D and 595D series. Consult
Where the maximum average output current I MAX equals
the peak current minus half the peak-to-peak ripple cur-
rent, I MAX = I LIM – Δ I L /2.
This formula has a maximum at V IN = 2V OUT , where I RMS
= I OUT /2. This simple worst-case is commonly used to
design because even signi?cant deviations do not offer
much relief. Note that capacitor manufacturer’s ripple cur-
rent ratings are often based on only 2000 hours lifetime.
This makes it advisable to further derate the capacitor,
or choose a capacitor rated at a higher temperature than
required. Several capacitors may also be paralleled to meet
the size or height requirements of the design. An addi-
tional 0.1μF to 1μF ceramic capacitor is also recommended
on V IN for high frequency decoupling when not using an
all-ceramic capacitor solution.
Output Capacitor (C OUT ) Selection
The selection of C OUT is driven by the required effective
series resistance (ESR). Typically, once the ESR require-
ment for C OUT has been met, the RMS current rating
generally far exceeds the I RIPPLE(P-P) requirement. The
output ripple Δ V OUT is determined by:
the manufacturer for other speci?c recommendations.
Using Ceramic Input and Output Capacitors
Higher values, lower cost ceramic capacitors are now
becoming available in smaller case sizes. Their high
ripple current, high voltage rating and low ESR make
them ideal for switching regulator applications. Because
the LTC3547 control loop does not depend on the output
capacitor’s ESR for stable operation, ceramic capacitors
can be used freely to achieve very low output ripple and
small circuit size.
However, care must be taken when ceramic capacitors are
used at the input. When a ceramic capacitor is used at the
input and the power is supplied by a wall adapter through
long wires, a load step at the output can induce ringing at
the input, V IN . At best, this ringing can couple to the output
and be mistaken as loop instability. At worst, a sudden
inrush of current through the long wires can potentially
cause a voltage spike at V IN , large enough to damage the
part. For more information, see Application Note 88.
When choosing the input and output ceramic capacitors,
choose the X5R or X7R dielectric formulations. These
dielectrics have the best temperature and voltage charac-
? V OUT ? ? I L ? ESR +
?
?
1 ?
8 fC OUT ? ?
(3)
teristics of all the ceramics for a given value and size.
3547fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3548IMSE#TRPBF | IC REG BUCK SYNC ADJ DL 10MSOP |
| LTC3549EDCB#TRPBF | IC REG BUCK SYNC ADJ 0.25A 6DFN |
| LTC3550EDHC-1#TRPBF | IC CHARGER BATT DUAL 16-DFN |
| LTC3552EDHC-1#TRPBF | IC CHARGER BATT LI-ION 16-DFN |
| LTC3559EUD-1#TRPBF | IC USB BATTERY CHARGER 16-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3548 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous,400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous, Fixed Output 2.25MHz Step-Down DC/DC Regulator |
| LTC3548-2 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous, Fixed/Adjustable Output, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548A | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous 400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548AEDD | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous 400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
发布紧急采购，3分钟左右您将得到回复。