- 您现在的位置：买卖IC网 > PDF目录15296 > LTC3713EG (Linear Technology)IC REG CTRLR BUCK PWM CM 24-SSOP PDF资料下载
参数资料
| 型号： | LTC3713EG |
| 厂商： | Linear Technology |
| 文件页数： | 14/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 24-SSOP |
| 标准包装： | 59 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1.5MHz |
| 占空比： | 90% |
| 电源电压： | 1.5 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 24-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
LTC3713
APPLICATIO S I FOR ATIO
Tantalum capacitors have the highest capacitance density
but it is important to only use types that have been surge
tested for use in switching power supplies. Aluminum
electrolytic capacitors have significantly higher ESR, but
can be used in cost-sensitive applications providing that
consideration is given to ripple current ratings and long
term reliability. Ceramic capacitors have excellent low
ESR characteristics but can have a high voltage coeffi-
cient and audible piezoelectric effects. The high Q of
Fault Conditions: Current Limit and Foldback
The maximum inductor current is inherently limited in a
current mode controller by the maximum sense voltage. In
the LTC3713, the maximum sense voltage is controlled by
the voltage on the V RNG pin. With valley current control,
the maximum sense voltage and the sense resistance
determine the maximum allowed inductor valley current.
The corresponding output current limit is:
+ ? I L
ceramiccapacitorswithtraceinductancecanalsoleadto
significant ringing. When used as input capacitors, care
must be taken to ensure that ringing from inrush currents
I LIMIT =
V SNS ( MAX )
R DS ( ON ) ρ T
1
2
and switching does not pose an overvoltage hazard to the
power switches and controller. To dampen input voltage
transients, add a small 5 μ F to 50 μ F aluminum electrolytic
capacitor with an ESR in the range of 0.5 ? to 2 ? . High
performance through-hole capacitors may also be used,
but an additional ceramic capacitor in parallel is recom-
mended to reduce the effect of their lead inductance.
Top MOSFET Driver Supply (C B , D B )
An external bootstrap capacitor C B connected to the BOOST
pin supplies the gate drive voltage for the topside MOSFET.
This capacitor is charged through diode D B from INTV CC
when the switch node is low. When the top MOSFET turns
on, the switch node rises to V IN and the BOOST pin rises
to approximately V IN + INTV CC . The boost capacitor needs
to store about 100 times the gate charge required by the
top MOSFET. In most applications a 0.1 μ F to 0.47 μ F X5R
or X7R dielectric capacitor is adequate.
Discontinuous Mode Operation and FCB Pin
The FCB pin determines whether the bottom MOSFET
remains on when current reverses in the inductor. Tying
this pin above its 0.8V threshold enables discontinuous
operation where the bottom MOSFET turns off when
inductor current reverses. The load current at which
current reverses and discontinuous operation begins
depends on the amplitude of the inductor ripple current
and will vary with changes in V IN . Tying the FCB pin below
the 0.8V threshold forces continuous synchronous opera-
tion, allowing current to reverse at light loads and main-
taining high frequency operation.
The current limit value should be checked to ensure that
I LIMIT(MIN) > I OUT(MAX) . The minimum value of current limit
generally occurs with the largest V IN at the highest ambi-
ent temperature, conditions that cause the largest power
loss in the converter. Note that it is important to check for
self-consistency between the assumed MOSFET junction
temperature and the resulting value of I LIMIT which heats
the MOSFET switches.
Caution should be used when setting the current limit
based upon the R DS(ON) of the MOSFETs. The maximum
current limit is determined by the minimum MOSFET on-
resistance. Data sheets typically specify nominal and
maximum values for R DS(ON) , but not a minimum. A
reasonable assumption is that the minimum R DS(ON) lies
the same amount below the typical value as the maximum
lies above it. Consult the MOSFET manufacturer for further
guidelines.
To further limit current in the event of a short circuit to
ground, the LTC3713 includes foldback current limiting. If
the output falls by more than 25%, then the maximum
sense voltage is progressively lowered to about one sixth
of its full value.
Minimum Off-time and Dropout Operation
The minimum off-time t OFF(MIN) is the smallest amount of
time that the LTC3713 is capable of turning on the bottom
MOSFET, tripping the current comparator and turning the
MOSFET back off. This time is generally about 250ns. The
minimum off-time limit imposes a maximum duty cycle of
t ON /(t ON + t OFF(MIN) ). If the maximum duty cycle is reached,
3713fa
14
相关PDF资料 |
PDF描述 |
|---|---|
| VE-27P-EW-F3 | CONVERTER MOD DC/DC 13.8V 100W |
| VE-27P-EW-F2 | CONVERTER MOD DC/DC 13.8V 100W |
| VE-27P-EW-F1 | CONVERTER MOD DC/DC 13.8V 100W |
| VE-27N-EY-B1 | CONVERTER MOD DC/DC 18.5V 50W |
| VE-27N-EW-F3 | CONVERTER MOD DC/DC 18.5V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3713EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3713EG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3713EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3714EG | 功能描述:IC STP-DWN CNTRLR W/OPAMP 28SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3714EG#PBF | 功能描述:IC STP-DWN CNTRLR W/OPAMP 28SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。