- 您现在的位置：买卖IC网 > PDF目录5232 > LTC3733CUHF-1#TRPBF (Linear Technology)IC CTRLR BUCK 3PH AMD CPU 38-QFN PDF资料下载
参数资料
| 型号： | LTC3733CUHF-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/32页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR BUCK 3PH AMD CPU 38-QFN |
| 标准包装： | 2,500 |
| 应用： | 控制器，AMD |
| 输入电压： | 4 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 1.55 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3733/LTC3733-1
OPERATIO
(Refer to Functional Diagram)
source or sink current in this mode. When forcing con-
tinuous operation and sinking current, this current will be
forced back into the main power supply, potentially
boosting the input supply to dangerous voltage levels—
BEWARE!
Frequency Synchronization or Setup
The phase-locked loop allows the internal oscillator to be
synchronized to an external source using the PLLIN pin.
The output of the phase detector at the PLLFLTR pin is also
the DC frequency control input of the oscillator which
operates over a 210kHz to 530kHz range corresponding to
a voltage input from 0V to 2.4V. When locked, the PLL
aligns the turn on of the top MOSFET to the rising edge of
the synchronizing signal. When no frequency information
is supplied to the PLLIN pin, PLLFLTR goes low, forcing
the oscillator to minimum frequency. A DC source can be
applied to the PLLFLTR pin to externally set the desired
operating frequency.
In the G36 package, the PLLIN pin is not brought out and
the PLLFLTR pin is for frequency setup only.
Differential Amplifier
This amplifier provides true differential output voltage
sensing. Sensing both V OUT+ and V OUT– benefits regula-
tion in high current applications and/or applications hav-
ing electrical interconnection losses. This sensing also
isolates the physical power ground from the physical
signal ground preventing the possibility of troublesome
“ground loops” on the PC layout and prevents voltage
errors caused by board-to-board interconnects, particu-
larly helpful in VRM designs.
Power Good
The PGOOD pin is connected to the drain of an internal
MOSFET. The MOSFET is turned on once the output
voltage has been away from its nominal value by greater
than 10%. The PGOOD signal is blanked for approximately
120 μ s during VID transitions. If a new VID transition
Short-Circuit Detection
The SS capacitor is used initially to limit the inrush current
from the input power source. Once the controllers have
been given time, as determined by the capacitor on the SS
pin, to charge up the output capacitors and provide full
load current, the SS capacitor is then used as a short-
circuit timeout circuit. If the output voltage falls to less
than 70% of its nominal output voltage, the SS capacitor
begins discharging, assuming that the output is in a severe
overcurrent and/or short-circuit condition. If the condition
lasts for a long enough period, as determined by the size
of the SS capacitor, the controller will be shut down until
the RUN pin voltage is recycled. This built-in latchoff can
be overridden by providing >5 μ A at a compliance of 4V to
the SS pin. This current shortens the soft-start period but
prevents net discharge of the SS capacitor during a severe
overcurrent and/or short-circuit condition. Foldback cur-
rent limiting is activated when the output voltage falls
below 70% of its nominal level whether or not the short-
circuit latchoff circuit is enabled. Foldback current limit
can be overridden by clamping the EAIN pin such that the
voltage is held above the (70%)(0.6V) or 0.42V level even
when the actual output voltage is low.
The SS capacitor will be reset if the input voltage, (V CC ) is
allowed to fall below approximately 4V. The capacitor on
the pin will be discharged until the short-circuit arming
latch is disarmed. The SS capacitor will attempt to cycle
through a normal soft-start ramp up after the V CC supply
rises above 4V. This circuit prevents power supply latchoff
in the event of input power switching break-before-make
situations.
No_CPU Detection
The LTC3733 detects the presense of CPU by monitoring
all VID bits. If an all-“1” condition is detected, the control-
ler acknowledges a No_CPU fault. If this fault condition
persists for more than 1 μ s, the SS pin is pulled low and the
controller is shut down.
occurs before the previous blanking time expires, the
timer is reset.
3733f
12
相关PDF资料 |
PDF描述 |
|---|---|
| HSM22DSAN | CONN EDGECARD 44POS R/A .156 SLD |
| HMM22DSAN | CONN EDGECARD 44POS R/A .156 SLD |
| LTC3733CUHF-1#TR | IC CTRLR BUCK 3PH AMD CPU 38-QFN |
| LTC3733CUHF-1#PBF | IC CTRLR BUCK 3PH AMD CPU 38-QFN |
| HSM22DSAH | CONN EDGECARD 44POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3734EUH | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3734EUH#PBF | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
| LTC3734EUH#TR | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3734EUH#TRPBF | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3735EG | 功能描述:IC CTRLR DC/DC 2PH HI EFF 36SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。