- 您现在的位置：买卖IC网 > PDF目录5232 > LTC3733CUHF-1#TRPBF (Linear Technology)IC CTRLR BUCK 3PH AMD CPU 38-QFN PDF资料下载
参数资料
| 型号： | LTC3733CUHF-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/32页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR BUCK 3PH AMD CPU 38-QFN |
| 标准包装： | 2,500 |
| 应用： | 控制器，AMD |
| 输入电压： | 4 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 1.55 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3733/LTC3733-1
APPLICATIO S I FOR ATIO
board trace and connector resistance losses are also
reduced by the reduction of the input ripple current in a
PolyPhase system. The required amount of input capaci-
tance is further reduced by the factor, N, due to the
effective increase in the frequency of the current pulses.
Ceramic capacitors are becoming very popular for small
designs but several cautions should be observed. “X7R”,
“X5R” and “Y5V” are examples of a few of the ceramic
materials used as the dielectric layer, and these different
dielectrics have very different effect on the capacitance
value due to the voltage and temperature conditions
applied. Physically, if the capacitance value changes due
to applied voltage change, there is a concommitant piezo
effect which results in radiating sound! A load that draws
varying current at an audible rate may cause an attendant
varying input voltage on a ceramic capacitor, resulting in
an audible signal. A secondary issue relates to the energy
flowing back into a ceramic capacitor whose capacitance
value is being reduced by the increasing charge. The
voltage can increase at a considerably higher rate than the
constant current being supplied because the capacitance
value is decreasing as the voltage is increasing! Ceramic
capacitors, when properly selected and used however, can
provide the lowest overall loss due to their extremely low
ESR.
The selection of C OUT is driven by the required effective
series resistance (ESR). Typically once the ESR require-
ment is satisfied the capacitance is adequate for filtering.
The steady-state output ripple ( ? V OUT ) is determined by:
with input voltage. The output ripple will be less than 50mV
at max V IN with ? I L = 0.4I OUT(MAX) assuming:
C OUT required ESR < N ? R SENSE
and
C OUT > 1/(8Nf)(R SENSE )
The emergence of very low ESR capacitors in small,
surface mount packages makes very small physical imple-
mentations possible. The ability to externally compensate
the switching regulator loop using the I TH pin allows a
much wider selection of output capacitor types. The
impedance characteristics of each capacitor type is sig-
nificantly different than an ideal capacitor and therefore
requires accurate modeling or bench evaluation during
design.
Manufacturers such as Nichicon, United Chemicon and
Sanyo should be considered for high performance through-
hole capacitors. The OS-CON semiconductor dielectric
capacitor available from Sanyo and the Panasonic SP
surface mount types have a good (ESR)(size) product.
Once the ESR requirement for C OUT has been met, the
RMS current rating generally far exceeds the I RIPPLE(P-P)
requirement. Ceramic capacitors from AVX, Taiyo Yuden,
Murata and Tokin offer high capacitance value and very
low ESR, especially applicable for low output voltage
applications.
In surface mount applications, multiple capacitors may
have to be paralleled to meet the ESR or RMS current
handling requirements of the application. Aluminum elec-
? V OUT RIPPLE ? ESR +
≈ ? I
8 NfC OUT ?
?
?
1 ?
?
trolytic and dry tantalum capacitors are both available in
surface mount configurations. New special polymer sur-
face mount capacitors offer very low ESR also but have
where f = operating frequency of each stage, N is the
number of output stages, C OUT = output capacitance and
? I L = ripple current in each inductor. The output ripple is
highest at maximum input voltage since ? I L increases
much lower capacitive density per unit volume. In the case
of tantalum, it is critical that the capacitors are surge tested
for use in switching power supplies. Several excellent
choices are the AVX TPS, AVX TPSV, the KEMET T510
3733f
17
相关PDF资料 |
PDF描述 |
|---|---|
| HSM22DSAN | CONN EDGECARD 44POS R/A .156 SLD |
| HMM22DSAN | CONN EDGECARD 44POS R/A .156 SLD |
| LTC3733CUHF-1#TR | IC CTRLR BUCK 3PH AMD CPU 38-QFN |
| LTC3733CUHF-1#PBF | IC CTRLR BUCK 3PH AMD CPU 38-QFN |
| HSM22DSAH | CONN EDGECARD 44POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3734EUH | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3734EUH#PBF | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
| LTC3734EUH#TR | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3734EUH#TRPBF | 功能描述:IC CTRLR DC/DC 1PH HI EFF 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3735EG | 功能描述:IC CTRLR DC/DC 2PH HI EFF 36SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。