- 您现在的位置：买卖IC网 > PDF目录44993 > LTC3810IG#TR (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, PDSO28 PDF资料下载
参数资料
| 型号： | LTC3810IG#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO28 |
| 封装： | 5.30 MM, PLASTIC, SSOP-28 |
| 文件页数： | 17/36页 |
| 文件大小： | 495K |
| 代理商： | LTC3810IG#TR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTC3810
24
3810fb
Figure 11. Type 2 Schematic and Transfer Function
FEEDBACK LOOP/COMPENSATION
Feedback Loop Types
In a typical LTC3810 circuit, the feedback loop consists
of the modulator, the output lter and load, and the
feedback amplier with its compensation network. All of
these components affect loop behavior and must be ac-
counted for in the loop compensation. The modulator and
output lter consists of the internal current comparator,
the output MOSFET drivers and the external MOSFETs,
inductor and output capacitor. Current mode control
eliminates the effect of the inductor by moving it to the
inner loop, reducing it to a rst order system. From a
feedback loop point of view, it looks like a linear voltage
controlled current source from ITH to VOUT and has a gain
equal to (IMAXROUT)/1.2V. It has fairly benign AC behavior
at typical loop compensation frequencies with signicant
phase shift appearing at half the switching frequency. The
external output capacitor and load cause a rst order roll
off at the output at the ROUTCOUT pole frequency, with
the attendant 90° phase shift. This roll off is what lters
the PWM waveform, resulting in the desired DC output
voltage. The output capacitor also contributes a zero at
the COUTRESR frequency which adds back the 90° phase
and cancels the rst order roll off.
So far, the AC response of the loop is pretty well out of the
user’s control. The modulator is a fundamental piece of
the LTC3810 design and the external output capacitor is
usually chosen based on the regulation and load current
requirements without considering the AC loop response.
The feedback amplier, on the other hand, gives us a
handle with which to adjust the AC response. The goal is
to have 180° phase shift at DC (so the loop regulates), and
something less than 360° phase shift (preferably about
300°) at the point that the loop gain falls to 0dB, i.e., the
crossover frequency, with as much gain as possible at
frequencies below the crossover frequency. Since the
modulator/output lter is a rst order system with maxi-
mum of 90° phase shift (at frequencies below fSW/4) and
the feedback amplier adds another 90° of phase shift,
some phase boost is required at the crossover frequency
to achieve good phase margin. If the ESR zero is below the
Figure 12. Type 3 Schematic and Transfer Function
crossover frequency, this zero may provide enough phase
boost to achieve the desired phase margin and the only
requirement of the compensation will be to guarantee that
the gain is below zero at frequencies above fSW/4. If the
ESR zero is above the crossover frequency, the feedback
amplier will probably be required to provide phase boost.
For most LTC3810 applications, Type 2 compensation will
provide enough phase boost; however some applications
where high bandwidth is required with low ESR ceramics
and lots of bulk capacitance, Type 3 compensation may
be necessary to provide additional phase boost.
The two types of compensation networks, “Type 2” and
“Type 3” are shown in Figures 11 and 12. When compo-
nent values are chosen properly, these networks provide
a “phase bump” at the crossover frequency. Type 2 uses
a single pole-zero pair to provide up to about 60° of phase
boost while Type 3 uses two poles and two zeros to provide
up to 150° of phase boost.
APPLICATIONS INFORMATION
GAIN
(dB)
3810 F11
0
PHASE
–6dB/OCT
GAIN
PHASE
(DEG)
FREQ
–90
–180
–270
–360
RB
VREF
R1
R2
FB
C2
IN
OUT
+
–
C1
GAIN
(dB)
3810 F12
0
PHASE
–6dB/OCT
+6dB/OCT
–6dB/OCT
GAIN
PHASE
(DEG)
FREQ
–90
–180
–270
–360
RB
VREF
R1
R2
FB
C2
IN
OUT
+
–
C1
C3
R3
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3810EG | SWITCHING CONTROLLER, PDSO28 |
| LTC3812EFE-5 | 1 A SWITCHING CONTROLLER, PDSO16 |
| LTC3812IFE-5#TR | 1 A SWITCHING CONTROLLER, PDSO16 |
| LTC3812EFE-5#TR | 1 A SWITCHING CONTROLLER, PDSO16 |
| LTC3812IFE-5 | 1 A SWITCHING CONTROLLER, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3810IUH-5#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3810IUH-5#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3811EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3811EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3811EUHF#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。