参数资料
型号: LTC3823EUH
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PQCC32
封装: 5 X 5 MM, PLASTIC, MO-220WHHD, QFN-32
文件页数: 23/24页
文件大小: 345K
代理商: LTC3823EUH
LTC3823
3823fb
pin functions (UH/GN)
PGND (Pin 22/Pin 22): Power Ground. Connect this pin
closely to the source of the bottom N-channel MOSFET,
the (–) terminal of CVCC and CIN.
SENSE(Pin 23/Pin 23): Current Sense Comparator In-
put. The negative input to the current comparator is used
to accurately Kelvin sense the bottom side of the sense
resistor or MOSFET.
SENSE+ (Pin 24/Pin 24): Current Sense Comparator
Input. The positive input to the current comparator is
normally connected to the SW node unless using a sense
resistor.
SW (Pin 25/Pin 25): Switch Node. The (–) terminal of the
bootstrap capacitor, CB, connects here. This pin swings
from a diode drop below ground up to VIN.
TG (Pin 26/Pin 26): Top Gate Drive Output. This pin drives
the top N-channel MOSFET with a voltage swing equal to
INTVCC, superimposed on the switch node voltage SW.
BOOST (Pin 27/Pin 27): Boosted Floating Driver Supply.
The (+) terminal of the bootstrap capacitor, CB, connects
here. This pin swings from a diode voltage drop below
INTVCC up to VIN + INTVCC.
Z0 (Pin 28/Pin 28): Dead Time Control Input. Applying a
DC voltage at this pin will vary the dead time between TG
low and BG high transition. Do not force a voltage higher
than INTVCC on this pin.
FCB (Pin 29/Pin 1): Forced Continuous Input. Connect
this pin to SGND to force continuous synchronization
operation at low load, to INTVCC to enable discontinuous
mode operation at low load, or to a resistive divider from
a secondary output when using a secondary winding.
RUN (Pin 30/Pin 2): Run Control Input. A voltage above
1.5V turns on the IC. Forcing this pin below 1.5V shuts
down the device.
VON (Pin 31/Pin 3): On-Time Input. Connecting this pin
to the output voltage makes the on-time proportional to
VOUT. The comparator input defaults to 0.6V when the
pin is grounded and defaults to 4.8V when the pin is tied
to INTVCC.
PGOOD (Pin 32/Pin 4): Power Good Output. Open-drain
logic that is pulled to ground when the output voltage is
not within ±11% of the regulation point after the internal
20s power bad mask timer expires.
Exposed Pad (Pin 33, UH Package): SGND. This pin must
be soldered to the PCB ground.
相关PDF资料
PDF描述
LTC3823EGN 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28
LTC3823EUH#TR 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PQCC32
LTC3823EGN#TR 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28
LTC3827IUH 3 A DUAL SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PQCC32
LTC3827IUH#TR 3 A DUAL SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PQCC32
相关代理商/技术参数
参数描述
LTC3823EUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)
LTC3823EUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3823IGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)
LTC3823IGN#PBF 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN DC/DC CTRL SSOP-28
LTC3823IGN#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)