- 您现在的位置：买卖IC网 > PDF目录15310 > LTC3830-1ES8#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM VM 8-SOIC PDF资料下载
参数资料
| 型号： | LTC3830-1ES8#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 8-SOIC |
| 标准包装： | 2,500 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 250kHz |
| 占空比： | 95% |
| 电源电压： | 3 V ~ 8 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
LTC3830/LTC3830-1
APPLICATIO S I FOR ATIO
The R DS(ON) of Q1 usually increases with temperature. To
keep the current limit threshold constant, the internal
12 μ A sink current at I MAX is designed with a positive
temperature coefficient to provide first order correction
for the temperature coefficient of R DS(ON)Q1 .
In order for the current limit circuit to operate properly and
to obtain a reasonably accurate current limit threshold, the
I IMAX and I FB pins must be Kelvin sensed at Q1’s drain and
source pins. In addition, connect a 0.1 μ F decoupling
capacitor across R IMAX to filter switching noise. Other-
wise, noise spikes or ringing at Q1’s source can cause the
actual current limit to be greater than the desired current
limit set point. Due to switching noise and variation of
R DS(ON) , the actual current limit trip point is not highly
accurate. The current limiting circuitry is primarily meant
to prevent damage to the power supply circuitry during
fault conditions. The exact current level where the limiting
circuit begins to take effect will vary from unit to unit as the
R DS(ON) of Q1 varies. Typically, R DS(ON) varies as much as
± 40% and with ± 25% variation on the LTC3830’s I MAX
current, this can give a ± 65% variation on the current limit
threshold.
The R DS(ON) is high if the V GS applied to the MOSFET is
low. This occurs during power up, when PV CC1 is ramping
up. To prevent the high R DS(ON) from activating the current
limit, the LTC3830 disables the current limit circuit if
PV CC1 is less than 2.5V above V CC . To ensure proper
V IN
operation of the current limit circuit, PV CC1 must be at
least 2.5V above V CC when G1 is high. PV CC1 can go low
when G1 is low, allowing the use of an external charge
pump to power PV CC1 .
Oscillator Frequency
The LTC3830 includes an onboard current controlled
oscillator that typically free-runs at 200kHz. The oscillator
frequency can be adjusted by forcing current into or out of
the FREQSET pin. With the pin floating, the oscillator runs
at about 200kHz. Every additional 1 μ A of current into/out
of the FREQSET pin decreases/increases the frequency by
10kHz. The pin is internally servoed to 1.265V, connecting
a 50k resistor from FREQSET to ground forces 25 μ A out
of the pin, causing the internal oscillator to run at approxi-
mately 450kHz. Forcing an external 10 μ A current into
FREQSET cuts the internal frequency to 100kHz. An inter-
nal clamp prevents the oscillator from running slower than
about 50kHz. Tying FREQSET to V CC forces the chip to run
at this minimum speed. The LTC3830-1 and the 8-lead
LTC3830 do not have this frequency adjustment function.
Shutdown
The LTC3830 includes a low power shutdown mode,
controlled by the logic at the SHDN pin. A high at SHDN
allows the part to operate normally. A low level at SHDN for
more than 100 μ s forces the LTC3830 into shutdown
mode. In this mode, all internal switching stops, the COMP
and SS pins pull to ground and Q1 and Q2 turn off. The
LTC3830
R IMAX
0.1 μ F
+
C IN
LTC3830 supply current drops to <10 μ A, although off-
state leakage in the external MOSFETs may cause the total
CC
+
–
12 μ A
12
I MAX
I FB
13
1k
G1
G2
Q1
Q2
L O
+
V OUT
C OUT
V IN current to be some what higher, especially at elevated
temperatures. If SHDN returns high, the LTC3830 reruns
a soft-start cycle and resumes normal operation. The
LTC3830-1 does not have this shutdown function.
3830 F04
Figure 4. Current Limit Setting
3830fa
10
相关PDF资料 |
PDF描述 |
|---|---|
| ADM690SQ | IC SUPERVISOR MPU 4.65V WD 8CDIP |
| VE-B2Y-EY-F2 | CONVERTER MOD DC/DC 3.3V 33W |
| UPS1A472MHD | CAP ALUM 4700UF 10V 20% RADIAL |
| SRP1235-R10M | INDUCTOR 100NH 43A SMD |
| URY2W6R8MHD | CAP ALUM 6.8UF 450V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3830EGN | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3830EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3830EGN#TR | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3830EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3830ES | 功能描述:IC REG CTRLR BUCK PWM VM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。