- 您现在的位置：买卖IC网 > PDF目录15310 > LTC3830-1ES8#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM VM 8-SOIC PDF资料下载
参数资料
| 型号： | LTC3830-1ES8#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 8-SOIC |
| 标准包装： | 2,500 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 250kHz |
| 占空比： | 95% |
| 电源电压： | 3 V ~ 8 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
LTC3830/LTC3830-1
APPLICATIO S I FOR ATIO
Similarly, the MAX comparator forces the output to 0%
duty cycle if the feedback signal is greater than 40mV
above the internal reference. To prevent these two com-
parators from triggering due to noise, the MIN and MAX
comparators’ response times are deliberately delayed by
two to three microseconds. These two comparators help
prevent extreme output perturbations with fast output
load current transients, while allowing the main feedback
loop to be optimally compensated for stability.
Thermal Shutdown
The LTC3830/LTC3830-1 have a thermal protection cir-
cuit that disables both gate drivers if activated. If the chip
junction temperature reaches 150 ° C, both G1 and G2 are
pulled low. G1 and G2 remain low until the junction
temperature drops below 125 ° C, after which, the chip
resumes normal operation.
Soft-Start and Current Limit
The 16-lead LTC3830 devices include a soft-start circuit
that is used for start-up and current limit operation. The
LTC3830-1 only has the soft-start function; the current
limit function is disabled. The 8-lead LTC3830 has both the
soft-start and current limit function disabled. The SS pin
requires an external capacitor, C SS , to GND with the value
determined by the required soft-start time. An internal
12 μ A current source is included to charge C SS . During
power-up, the COMP pin is clamped to a diode drop (B-E
junction of QSS in the Block Diagram) above the voltage at
the SS pin. This prevents the error amplifier from forcing
the loop to maximum duty cycle. The LTC3830/LTC3830-1
operate at low duty cycle as the SS pin rises above 0.6V
the voltage at I FB to the voltage at the I MAX pin. As the peak
current rises, the measured voltage across Q1 increases
due to the drop across the R DS(ON) of Q1. When the voltage
at I FB drops below I MAX , indicating that Q1’s drain current
has exceeded the maximum level, CC starts to pull current
out of C SS , cutting the duty cycle and controlling the output
current level. The CC comparator pulls current out of the
SS pin in proportion to the voltage difference between I FB
and I MAX . Under minor overload conditions, the SS pin
falls gradually, creating a time delay before current limit
takes effect. Very short, mild overloads may not affect the
output voltage at all. More significant overload conditions
allow the SS pin to reach a steady state, and the output
remains at a reduced voltage until the overload is re-
moved. Serious overloads generate a large overdrive at
CC, allowing it to pull SS down quickly and preventing
damage to the output components. By using the R DS(ON)
of Q1 to measure the output current, the current limiting
circuit eliminates an expensive discrete sense resistor that
would otherwise be required. This helps minimize the
number of components in the high current path.
The current limit threshold can be set by connecting an
external resistor R IMAX from the I MAX pin to the main V IN
supply at the drain of Q1. The value of R IMAX is determined
by:
R IMAX = (I LMAX )(R DS(ON)Q1 )/I IMAX
where:
I LMAX = I LOAD + (I RIPPLE /2)
I LOAD = Maximum load current
I RIPPLE = Inductor ripple current
(V COMP ≈ 1.2V). As SS continues to rise, QSS turns off and
the error amplifier takes over to regulate the output. The
MIN comparator is disabled during soft-start to prevent it
=
( V IN – V OUT )( V OUT )
( f OSC ) ( L O )( V IN )
from overriding the soft-start function.
The 16-lead LTC3830 devices include yet another feed-
back loop to control operation in current limit. Just before
every falling edge of G1, the current comparator, CC,
samples and holds the voltage drop measured across the
f OSC = LTC3830 oscillator frequency = 200kHz
L O = Inductor value
R DS(ON)Q1 = On-resistance of Q1 at I LMAX
I IMAX = Internal 12 μ A sink current at I MAX
external upper MOSFET, Q1, at the I FB pin. CC compares
3830fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| ADM690SQ | IC SUPERVISOR MPU 4.65V WD 8CDIP |
| VE-B2Y-EY-F2 | CONVERTER MOD DC/DC 3.3V 33W |
| UPS1A472MHD | CAP ALUM 4700UF 10V 20% RADIAL |
| SRP1235-R10M | INDUCTOR 100NH 43A SMD |
| URY2W6R8MHD | CAP ALUM 6.8UF 450V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3830EGN | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3830EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3830EGN#TR | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3830EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3830ES | 功能描述:IC REG CTRLR BUCK PWM VM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。