参数资料
型号: LTC3836EUFD#TRPBF
厂商: Linear Technology
文件页数: 16/30页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 28-QFN
标准包装: 2,500
系列: PolyPhase®
PWM 型: 电流模式
输出数: 2
频率 - 最大: 825kHz
占空比: 97%
电源电压: 2.75 V ~ 4.5 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 28-WFQFN 裸露焊盘
包装: 带卷 (TR)
LTC3836
APPLICATIONS INFORMATION
Inductor Core Selection
Once the inductance value is determined, the type of in-
ductor must be selected. Core loss is independent of core
size for a ?xed inductor value, but it is very dependent
on inductance selected. As inductance increases, core
losses go down. Unfortunately, increased inductance
requires more turns of wire and therefore copper losses
will increase.
phase technique typically reduces the input capacitor’s RMS
ripple current by a factor of 30% to 70% when compared
to a single phase power supply solution.
In continuous mode, the source current of the main N-chan-
nel MOSFET is a square wave of duty cycle (V OUT )/(V IN ). To
prevent large voltage transients, a low ESR capacitor sized
for the maximum RMS current of one channel must be
used. The maximum RMS capacitor current is given by:
Ferrite designs have very low core loss and are preferred
at high switching frequencies, so design goals can con-
C IN Required I RMS
I MAX
V IN
( V OUT ) ( V IN – V OUT )
1/2
centrate on copper loss and preventing saturation. Ferrite
core material saturates “hard,” which means that induc-
tance collapses abruptly when the peak design current is
exceeded. This results in an abrupt increase in inductor
ripple current and consequent output voltage ripple. Do
not allow the core to saturate!
Schottky Diode Selection (Optional)
The Schottky diodes D1 and D2 in Figure 16 conduct
current during the dead time between the conduction of
the power MOSFETs . This prevents the body diode of
the bottom MOSFET from turning on and storing charge
during the dead time, which could cost as much as 1% in
ef?ciency. A 1A Schottky diode is generally a good size for
most LTC3836 applications, since it conducts a relatively
small average current. Larger diodes result in additional
transition losses due to their larger junction capacitance.
This diode may be omitted if the ef?ciency loss can be
tolerated.
C IN and C OUT Selection
The selection of C IN is simpli?ed by the 2-phase architec-
ture and its impact on the worst-case RMS current drawn
through the input network (battery/fuse/capacitor). It can be
shown that the worst-case capacitor RMS current occurs
when only one controller is operating. The controller with
the highest (V OUT )(I OUT ) product needs to be used in the
formula below to determine the maximum RMS capacitor
current requirement. Increasing the output current drawn
from the other controller will actually decrease the input
RMS ripple current from its maximum value. The out-of-
This formula has a maximum at V IN = 2V OUT , where I RMS
= I OUT /2. This simple worst-case condition is commonly
used for design because even signi?cant deviations do not
offer much relief. Note that capacitor manufacturers’ ripple
current ratings are often based on only 2000 hours of life.
This makes it advisable to further derate the capacitor, or
to choose a capacitor rated at a higher temperature than
required. Several capacitors may be paralleled to meet
size or height requirements in the design. Due to the high
operating frequency of the LTC3836, ceramic capacitors
can also be used for C IN . Always consult the manufacturer
if there is any question.
The bene?t of the LTC3836 2-phase operation can be cal-
culated by using the equation above for the higher power
controller and then calculating the loss that would have
resulted if both controller channels switched on at the same
time. The total RMS power lost is lower when both control-
lers are operating due to the reduced overlap of current
pulses required through the input capacitor’s ESR. This is
why the input capacitor’s requirement calculated above for
the worst-case controller is adequate for the dual controller
design. Also, the input protection fuse resistance, battery
resistance, and PC board trace resistance losses are also
reduced due to the reduced peak currents in a 2-phase
system. The overall bene?t of a multiphase design will
only be fully realized when the source impedance of the
power supply/battery is included in the ef?ciency testing.
The drains of the main MOSFETs should be placed within
1cm of each other and share a common C IN (s). Separating
the drains and C IN may produce undesirable voltage and
current resonances at V IN .
3836fb
16
相关PDF资料
PDF描述
LTC3838IFE#TRPBF IC REG CTRLR BUCK PWM CM 38TSSOP
LTC3839EUH#PBF IC REG CTRLR BUCK PWM CM 32-QFN
LTC3850IGN-2#TRPBF IC REG CTRLR BUCK PWM CM 28-SSOP
LTC3850IGN#PBF IC REG CTRLR BUCK PWM CM 28-SSOP
LTC3851EGN#PBF IC REG CTRLR BUCK PWM CM 16-SSOP
相关代理商/技术参数
参数描述
LTC3838EFE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)
LTC3838EFE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3838EUHF#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3838EUHF#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3838EUHF-1#PBF 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM CM 38QFN 制造商:Linear Technology 功能描述:BUCK DUAL CNTRL 4.5-38V 2MHZ 38QFN 制造商:Linear Technology 功能描述:BUCK, DUAL, CNTRL, 4.5-38V, 2MHZ, 38QFN 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, DUAL, BUCK, ADJ, QFN-38, Primary Input Voltage:38V, No. of Outputs:2, Output Current:25A, No. of Pins:38, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Dual, Fast, Accurate Step-Down Controller with Differential