- 您现在的位置：买卖IC网 > PDF目录1833 > LTC3869EUFD#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 28-QFN PDF资料下载
参数资料
| 型号： | LTC3869EUFD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/42页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 28-QFN |
| 标准包装： | 73 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 850kHz |
| 占空比： | 95% |
| 电源电压： | 4 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
LTC3869/LTC3869-2
APPLICATIONS INFORMATION
R SENSE =
I MAX +
TheTypicalApplicationonthefirstpageisabasicLTC3869
application circuit. LTC3869 can be configured to use either
DCR (inductor resistance) sensing or low value resistor
sensing. The choice between the two current sensing
schemes is largely a design trade-off between cost, power
consumption, and accuracy. DCR sensing is becoming
popular because it saves expensive current sensing resis-
tors and is more power efficient, especially in high current
applications. However, current sensing resistors provide
the most accurate current limits for the controller. Other
external component selection is driven by the load require-
ment, and begins with the selection of R SENSE (if R SENSE is
used) and inductor value. Next, the power MOSFETs are
selected. Finally, input and output capacitors are selected.
Current Limit Programming
The I LIM pin is a tri-level logic input which sets the maxi-
mum current limit of the controller. When I LIM is either
grounded, floated or tied to INTV CC , the typical value for
the maximum current sense threshold will be 30mV, 50mV
or 75mV, respectively.
Which setting should be used? For the best current limit
accuracy, use the 75mV setting. The 30mV setting will
allow for the use of very low DCR inductors or sense
resistors, but at the expense of current limit accuracy.
The 50mV setting is a good balance between the two. For
single output dual phase applications, use the 50mV or
75mV setting for optimal current sharing.
SENSE + and SENSE – Pins
The SENSE + and SENSE – pins are the inputs to the current
comparators. The common mode input voltage range of
the current comparators is 0V to 12.5V. Both SENSE pins
are high impedance inputs with small base currents of less
than 1μA. When the SENSE pins ramp up from 0V to 1.4V,
the small base currents flow out of the SENSE pins. When
the SENSE pins ramp down from 12.5V to 1.1V, the small
base currents flow into the SENSE pins. The high imped-
ance inputs to the current comparators allow accurate
DCR sensing. However, care must be taken not to float
these pins during normal operation. The LTC3869GN-2
defaults to 50mV current limit value.
Filter components mutual to the sense lines should be
placed close to the LTC3869, and the sense lines should
run close together to a Kelvin connection underneath the
current sense element (shown in Figure 1). Sensing cur-
rent elsewhere can effectively add parasitic inductance
and capacitance to the current sense element, degrading
the information at the sense terminals and making the
programmed current limit unpredictable. If DCR sensing
is used (Figure 2b), sense resistor R1 should be placed
close to the switching node, to prevent noise from coupling
into sensitive small-signal nodes. The capacitor C1 should
be placed close to the IC pins.
TO SENSE FILTER,
NEXT TO THE CONTROLLER
C OUT
R SENSE 3869 F01
Figure 1. Sense Lines Placement with Sense Resistor
Low Value Resistors Current Sensing
A typical sensing circuit using a discrete resistor is shown
in Figure 2a. R SENSE is chosen based on the required
output current.
The current comparator has a maximum threshold
V SENSE(MAX) determined by the I LIM setting. The input
common mode range of the current comparator is 0V to
12.5V. The current comparator threshold sets the peak of
the inductor current, yielding a maximum average output
current I MAX equal to the peak value less half the peak-to-
peak ripple current, ?I L . To calculate the sense resistor
value, use the equation:
V SENSE(MAX)
?I L
2
Because of possible PCB noise in the current sensing loop,
the AC current sensing ripple of ?V SENSE = ?I L ? R SENSE
also needs to be checked in the design to get a good
signal-to-noise ratio. In general, for a reasonably good
PCB layout, a 10mV ?V SENSE voltage is recommended as
a conservative number to start with, either for R SENSE or
DCR sensing applications, for duty cycles less than 40%.
38692fa
14
For more information www.linear.com/LTC3869
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3872ETS8#TRMPBF | IC REG CTRLR BST PWM CM TSOT23-8 |
| LTC3873EDDB#TRMPBF | IC REG CTRLR BST FLYBK PWM 8-DFN |
| LTC3873ITS8-5#TRPBF | IC REG CTRLR BST FLYBK TSOT23-8 |
| LTC3876EFE#PBF | IC CTLR DC/DC DDR DUAL 38-TSSOP |
| LTC3878EGN#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3869IGN-2#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3869IGN-2#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3869IUFD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3869IUFD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3872EDDB#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Step Up 2.75V to 9.8V Input 8-Pin DFN EP 制造商:Linear Technology 功能描述:BOOST 2.75 - 9.8V 550KHZ 8D 制造商:Linear Technology 功能描述:BOOST, 2.75 - 9.8V, 550KHZ, 8DFN |
发布紧急采购，3分钟左右您将得到回复。