- 您现在的位置：买卖IC网 > PDF目录16300 > LTC4011CFE#PBF (Linear Technology)IC BATT CHARGER HIEFF 20TSSOP PDF资料下载
参数资料
| 型号： | LTC4011CFE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/26页 |
| 文件大小： | 0K |
| 描述： | IC BATT CHARGER HIEFF 20TSSOP |
| 标准包装： | 74 |
| 功能： | 充电管理 |
| 电池化学： | 镍镉（NiCd）、镍金属氢化物（NiMH） |
| 电源电压： | 4.5 V ~ 34 V |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 20-TSSOP-EP |
| 包装： | 管件 |
| 产品目录页面： | 1341 (CN2011-ZH PDF) |
LTC4011
OPERATION
V CC
P
N
SENSE
R SENSE CC
BAT
PWM Current Source Controller
An integral part of the LTC4011 is the PWM current source
controller. The charger uses a synchronous step-down
architecture to produce high efficiency and limited thermal
dissipation. The nominal operating frequency of 550kHz
allows use of a smaller external filter components. The
TGATE and BGATE outputs have internally clamped volt-
age swings. They source peak currents tailored to smaller
surface-mount power FETs likely to appear in applications
providing an average charge current of 3A or less. During
the various charging states, the LTC4011 uses the PWM
controller to regulate an average voltage between SENSE
and BAT that ranges from 10mV to 100mV.
A conceptual diagram of the LTC4011 PWM control loop
is shown in Figure 2.
The voltage across the external current programming
resistor R SENSE is averaged by integrating error amplifier
EA. An internal programming current is also pulled from
input resistor R1. The I PROG ? R1 product establishes the
desired average voltage drop across R SENSE , and hence,
the average current through R SENSE . The I TH output of
the error amplifier is a scaled control current for the input
LTC4011
TGATE S PWM CLOCK
17 Q
R
BGATE
15
R3
11
R4
12
R1
I TH
EA
R2
of the PWM comparator CC. The I TH ? R3 product sets a
peak current threshold for CC such that the desired aver-
age current through R SENSE is maintained. The current
comparator output does this by switching the state of the
SR latch at the appropriate time.
At the beginning of each oscillator cycle, the PWM clock
sets the SR latch and the external P-channel MOSFET is
switched on (N-channel MOSFET switched off) to refresh
the current carried by the external inductor. The inductor
current and voltage drop across R SENSE begin to rise
linearly. During normal operation, the PFET is turned
off (NFET on) during the cycle by CC when the voltage
difference across R SENSE reaches the peak value set by
the output of EA. The inductor current then ramps down
linearly until the next rising PWM clock edge. This closes
the loop and maintains the desired average charge current
in the external inductor.
Low Dropout Charging
After charging is initiated, the LTC4011 does not require
that V CC remain at least 500mV above BAT because situ-
ations exist where low dropout charging might occur. In
one instance, parasitic series resistance may limit PWM
headroom (between V CC and BAT) as 100% charge is
reached. A second case can arise when the DC adapter
selected by the end user is not capable of delivering the
current programmed by R SENSE , causing the output volt-
age of the adapter to collapse. While in low dropout, the
LTC4011 PWM runs near 100% duty cycle with a frequency
that may not be constant and can be less than 550kHz.
The charge current will drop below the programmed value
to avoid generating audible noise, so the actual charge
delivered to the battery may depend primarily on the
LTC4011 charge timer.
Internal Die Temperature
I PROG
Figure 2. LTC4011 PWM Control Loop
4011 F02
The LTC4011 provides internal overtemperature detection
to protect against electrical overstress, primarily at the
FET driver outputs. If the die temperature rises above this
thermal limit, the LTC4011 stops switching and indicates
a fault as previously discussed.
4011fb
相关PDF资料 |
PDF描述 |
|---|---|
| EEC49DRYS | CONN EDGECARD 98POS DIP .100 SLD |
| EMC12DRTN | CONN EDGECARD 24POS .100 EXTEND |
| 4-1906014-0 | CA 2.0MM OFNR 50/125,LC SEC YEL |
| ESC12DRTH | CONN EDGECARD 24POS DIP .100 SLD |
| LTC4010CFE#PBF | IC CHARGER NIMH/NICD 16-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4011CFETR | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency Standalone Nickel Battery Charger |
| LTC4011CFETRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency Standalone Nickel Battery Charger |
| LTC4011EFE | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency Standalone Nickel Battery Charger |
| LTC4012 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Effi ciency, Multi-Chemistry Battery Charger with PowerPath Control |
| LTC4012-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Effi ciency, Multi-Chemistry Battery Charger with PowerPath Control |
发布紧急采购，3分钟左右您将得到回复。