- 您现在的位置：买卖IC网 > PDF目录80426 > M38D29FFFP 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 PDF资料下载
参数资料
| 型号： | M38D29FFFP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 |
| 封装： | 14 X 14 MM, 0.80 MM PITCH, PLASTIC, LQFP-64 |
| 文件页数： | 30/136页 |
| 文件大小： | 2856K |
| 代理商： | M38D29FFFP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页当前第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页
Rev.3.02
Apr 10, 2008
Page 125 of 131
REJ03B0177-0302
38D2 Group
Notes on A/D Conversion
1. Analog Input Pin
Set the signal source impedance for analog input low, or equip an
analog input pin with an external capacitor of 0.01
μF to 1 μF.
In addition, operations of application products should be verified
thoroughly on the user side.
<Reason>
An analog input pin has a built-in capacitor for analog voltage
comparison. Thus if a signal from the high impedance signal
source is input to the analog input pin, charge and discharge
noise w i ll b e g e n e r a ted. This may cause th e A/D
conversion/comparison accuracy to drop.
2. Clock Frequency during A/D Conversion
The comparator input consists of a capacity coupling. If the
conversion rate is too low, the A/D conversion accuracy may
deteriorate due to a charge lost, so set f(XIN) 500 kHz or more for
A/D conversion in XIN mode. Also, do not execute the STP or
WIT instruction during A/D conversion.
In low-speed mode (when on-chip oscillator is selected), as A/D
conversion is performed using the internal on-chip oscillator,
there is no limit on the minimum frequency for f(XIN).
3. ADKEY Function
When the ADKEY enable bit is set to “1”, the analog input pin
selection bits are disabled. Do not execute the A/D conversion by
a program while ADKEY is enabled. Enabling ADKEY does not
change bits 0 to 2 of ADCON.
4. A/D Conversion Immediately After ADKEY Function
Started
In the ADKEY function, A/D conversion is not performed to the
analog input voltage immediately after starting the function. This
causes the A/D conversion result immediately after starting the
function to be undefined. If the A/D conversion result of the
analog input voltage applied to the ADKEY pin is required,
select the analog input pin corresponding to ADKEY before
performing A/D conversion.
5. Input Voltage Applied to ADKEY Pin
Set the input to the ADKEY pin into a steep falling waveform
and stabilize the input voltage within eight cycles (1
μs when
f(XIN) = 8 MHz) from the moment the input voltage reaches VIL
or lower.
The actual threshold voltage for the ADKEY pin is between VIH
and VIL.
To prevent unnecessary ADKEY operation due to noise or other
factors, set the ADKEY pin voltage to VIH (0.9 VCC) or more
while the input is waited.
6. Register Operation during A/D Conversion
The A/D conversion operation is not guaranteed if the following
are preformed:
The CPU mode register is operated during A/D conversion
operation
The AD control register is operated during A/D conversion
operation
The STP or WIT instruction is executed during A/D
conversion operation
7. A/D Converter Power Source Pin
Connect to the A/D converter power source pin to AVSS or VSS
whether the A/D conversion function is used or not.
<Reason>
If the AVSS pin is left open, the MCU may operate incorrectly
because the pin will be affected by noise or other factors.
相关PDF资料 |
PDF描述 |
|---|---|
| MPC5534MVZ80 | MICROCONTROLLER, PBGA324 |
| MC908GR16AVFAER | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP48 |
| MC908GZ16CFAER | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP48 |
| MC908QY2AMDWER | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDSO16 |
| MC9S08AW16CFUER | 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M38D29FFHP#U1 | 制造商:Renesas Electronics Corporation 功能描述: |
| M38D29GFHP#U0 | 制造商:Renesas Electronics Corporation 功能描述: |
| M38D29T2-RLFS-HP | 制造商:Renesas Electronics Corporation 功能描述: |
| M38D58G8FP#U0 | 功能描述:IC 740/38D5 MCU QZ-ROM 80QFP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 标准包装:250 系列:80C 核心处理器:8051 芯体尺寸:8-位 速度:16MHz 连通性:EBI/EMI，I²C，UART/USART 外围设备:POR，PWM，WDT 输入/输出数:40 程序存储器容量:- 程序存储器类型:ROMless EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:A/D 8x10b 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:68-LCC（J 形引线） 包装:带卷 (TR) |
| M38D58G8HP#U0 | 功能描述:IC 740/38D5 MCU QZ-ROM 80LQFP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 标准包装:250 系列:80C 核心处理器:8051 芯体尺寸:8-位 速度:16MHz 连通性:EBI/EMI，I²C，UART/USART 外围设备:POR，PWM，WDT 输入/输出数:40 程序存储器容量:- 程序存储器类型:ROMless EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:A/D 8x10b 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:68-LCC（J 形引线） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。