参数资料
型号: M41T81M6E
厂商: STMICROELECTRONICS
元件分类: 时钟/数据恢复及定时提取
英文描述: 1 TIMER(S), REAL TIME CLOCK, PDSO8
封装: 0.150 INCH, LEAD FREE, PLASTIC, SOIC-8
文件页数: 4/29页
文件大小: 454K
代理商: M41T81M6E
Clock operation
M41T81
Doc ID 7529 Rev 10
3
Clock operation
The 20-byte register map (see Table 2 on page 13) is used to both set the clock and to read
the date and time from the clock, in a binary coded decimal format. Tenths/hundredths of
seconds, seconds, minutes, and hours are contained within the first four registers.
Note:
The tenths/hundredths of seconds cannot be written to any value other than “00.”
Bits D6 and D7 of clock register 03h (century/hours register) contain the CENTURY
ENABLE bit (CEB) and the CENTURY bit (CB). Setting CEB to a '1' will cause CB to toggle,
either from '0' to '1' or from '1' to '0' at the turn of the century (depending upon its initial
state). If CEB is set to a '0,' CB will not toggle. Bits D0 through D2 of register 04h contain the
day (day of week). Registers 05h, 06h, and 07h contain the date (day of month), month and
years. The ninth clock register is the control register (this is described in the clock calibration
section). Bit D7 of register 01h contains the STOP bit (ST). Setting this bit to a '1' will cause
the oscillator to stop. If the device is expected to spend a significant amount of time on the
shelf, the oscillator may be stopped to reduce current drain. When reset to a '0' the oscillator
restarts within one second.
The eight clock registers may be read one byte at a time, or in a sequential block. Provision
has been made to assure that a clock update does not occur while any of the eight clock
addresses are being read. If a clock address is being read, an update of the clock registers
will be halted. This will prevent a transition of data during the READ.
3.1
Power-down time-stamp
When a power failure occurs, the HT bit will automatically be set to a '1.' This will prevent the
clock from updating the TIMEKEEPER registers, and will allow the user to read the exact
time of the power-down event. Resetting the HT bit to a '0' will allow the clock to update the
TIMEKEEPER registers with the current time. For more information, see application note
AN1572.
3.2
Clock registers
The M41T81 offers 20 internal registers which contain clock, alarm, watchdog, flag, square
wave and control data. These registers are memory locations which contain external (user
accessible) and internal copies of the data (usually referred to as BiPORT cells). The
external copies are independent of internal functions except that they are updated
periodically by the simultaneous transfer of the incremented internal copy. The internal
divider (or clock) chain will be reset upon the completion of a WRITE to any clock address.
The system-to-user transfer of clock data will be halted whenever the address being read is
a clock address (00h to 07h). The update will resume either due to a stop condition or when
the pointer increments to any non-clock address (08h-13h).
Clock and alarm registers store data in BCD. Control, watchdog and square wave registers
store data in binary format.
相关PDF资料
PDF描述
MC68HC11F1VPU3 8-BIT, EEPROM, 3 MHz, MICROCONTROLLER, PQFP80
MC68HC908MR8VP 8-BIT, FLASH, 8.2 MHz, MICROCONTROLLER, PDIP28
MC68HLC908QY4CP 8-BIT, FLASH, 2 MHz, MICROCONTROLLER, PDIP16
MC68HC705P6ACP 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP28
MC908GR60AMFU 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64
相关代理商/技术参数
参数描述
M41T81M6F 功能描述:实时时钟 Serial 512 (64x8) RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
M41T81M6F-CUT TAPE 制造商:ST 功能描述:M41T Series 2 V Serial I2C Real Time Clock with Alarm - SOIC-8
M41T81M6TR 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Serial Access Real-Time Clock with Alarms
M41T81MX 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:SERIAL ACCESS RTC WITH ALARMS
M41T81MX6 功能描述:实时时钟 Serial 512 (64x8) RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube