- 您现在的位置：买卖IC网 > PDF目录80396 > M41T81M6E (STMICROELECTRONICS) 1 TIMER(S), REAL TIME CLOCK, PDSO8 PDF资料下载
参数资料
| 型号： | M41T81M6E |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 时钟/数据恢复及定时提取 |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| 封装： | 0.150 INCH, LEAD FREE, PLASTIC, SOIC-8 |
| 文件页数： | 8/29页 |
| 文件大小： | 454K |
| 代理商： | M41T81M6E |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
Clock operation
M41T81
Doc ID 7529 Rev 10
3.4
Setting alarm clock registers
Address locations 0Ah-0Eh contain the alarm settings. The alarm can be configured to go
off at a prescribed time on a specific month, date, hour, minute, or second or repeat every
year, month, day, hour, minute, or second. It can also be programmed to go off while the
M41T81 is in the battery backup mode to serve as a system wake-up call.
Bits RPT5-RPT1 put the alarm in the repeat mode of operation. Table 3 on page 17 shows
the possible configurations. Codes not listed in the table default to the once per second
mode to quickly alert the user of an incorrect alarm setting.
When the clock information matches the alarm clock settings based on the match criteria
defined by RPT5-RPT1, the AF (alarm flag) is set. If AFE (alarm flag enable) is also set (and
SQWE is '0.'), the alarm condition activates the IRQ/FT/OUT/SQW pin.
Note:
If the address pointer is allowed to increment to the flag register address, an alarm condition
will not cause the interrupt/flag to occur until the address pointer is moved to a different
address. It should also be noted that if the last address written is the “alarm seconds,” the
address pointer will increment to the flag address, causing this situation to occur.
The IRQ/FT/OUT/SQW output is cleared by a READ to the flags register as shown in
Figure 12. A subsequent READ of the flags register is necessary to see that the value of the
alarm flag has been reset to '0.'
The IRQ/FT/OUT/SQW pin can also be activated in the battery backup mode. The
IRQ/FT/OUT/SQW will go low if an alarm occurs and both ABE (alarm in battery backup
mode enable) and AFE are set. Figure 13 illustrates the backup mode alarm timing.
Figure 12.
Alarm interrupt reset waveform
IRQ/FT/OUT/SQW
ACTIVE FLAG
0Fh
0Eh
10h
HIGH-Z
AI04617
相关PDF资料 |
PDF描述 |
|---|---|
| MC68HC11F1VPU3 | 8-BIT, EEPROM, 3 MHz, MICROCONTROLLER, PQFP80 |
| MC68HC908MR8VP | 8-BIT, FLASH, 8.2 MHz, MICROCONTROLLER, PDIP28 |
| MC68HLC908QY4CP | 8-BIT, FLASH, 2 MHz, MICROCONTROLLER, PDIP16 |
| MC68HC705P6ACP | 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP28 |
| MC908GR60AMFU | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M41T81M6F | 功能描述:实时时钟 Serial 512 (64x8) RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M41T81M6F-CUT TAPE | 制造商:ST 功能描述:M41T Series 2 V Serial I2C Real Time Clock with Alarm - SOIC-8 |
| M41T81M6TR | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Serial Access Real-Time Clock with Alarms |
| M41T81MX | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:SERIAL ACCESS RTC WITH ALARMS |
| M41T81MX6 | 功能描述:实时时钟 Serial 512 (64x8) RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。