- 您现在的位置：买卖IC网 > PDF目录20169 > MAX753ESE+T (Maxim Integrated)IC CNTRLR CONTRAST 16-SOIC PDF资料下载
参数资料
| 型号： | MAX753ESE+T |
| 厂商： | Maxim Integrated |
| 文件页数： | 4/16页 |
| 文件大小： | 0K |
| 描述： | IC CNTRLR CONTRAST 16-SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 显示器类型： | CCFL - 冷色阴极荧光灯 |
| 电流 - 电源： | 500µA |
| 电源电压： | 4 V ~ 30 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC |
| 包装： | 带卷 (TR) |
CCFL Backlight and
LCD Contrast Controllers
______________________________________________________________Pin Description
PIN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
NAME
V DD
LADJ
LON
CON
CADJ
GND
REF
CFB
CC
CS
CDRV
PGND
LDRV
LX
BATT
LFB
FUNCTION
5V Power-Supply Input
Digital Input for LCD Backplane Bias Adjustment. See Table 1.
Digital Input to Control LCD Bias Section. See Table 1.
Digital Input to Control CCFT Section. See Table 1.
Digital Input for CCFT Brightness Adjustment. See Table 1.
Analog Ground
Reference Voltage Output, 1.25V
Inverting Input for the CCFT Error Amplifier
Output of the CCFT Error Amplifier
Connect to V DD
Leave unconnected
Power Ground Connection for LDRV
Gate-Driver Output. Drives LCD backplane N-channel MOSFET.
LCD Backplane Inductor Voltage-Sense Pin. Used to sense inductor voltage for on time determination.
Battery Connection. Used to sense battery voltage for on time determination.
Voltage Feedback for the LCD Backplane Section
_______________Theory of Operation
CCFL Inverter
The MAX753/MAX754’s CCFL inverter is designed to
drive one or two cold-cathode fluorescent lamps
(CCFLs) with power levels from 100mW to 6W. These
lamps commonly provide backlighting for LCD panels
in portable computers.
Drive Requirements for CCFL Tubes
CCFL backlights require a high-voltage, adjustable AC
power source. The MAX753/MAX754 generate this AC
waveform with a self-oscillating, current-fed, parallel
resonant circuit, also known as a Royer-type oscillator.
Figure 1 shows one such circuit. The Royer oscillator is
comprised of T1, C9, the load at the secondary, Q4,
and Q5. The circuit self-oscillates at a frequency deter-
mined by the effective primary inductance and capaci-
tance. Q4 and Q5 are self-driven by the extra winding.
The current source feeding the Royer oscillator is com-
prised of L1, D5, and the MAX758A. When current from
the current source increases, so does the lamp current.
The lamp current is half-wave rectified by D7A and
D7B, and forms a voltage across resistor R8. The
MAX753’s error amplifier compares the average of this
voltage to the output of its internal DAC. Adjusting the
DAC output from zero scale to full scale (digital control)
causes the error amplifier to vary the tube current from
a minimum to a maximum. The DAC’s transfer function
is shown in Figure 2.
On power-up or after a reset, the counter sets the DAC
output to mid scale. Each rising edge of CADJ (with
CON high) decrements the DAC output. When decre-
mented beyond full scale, the counter rolls over and
sets the DAC to the maximum value. In this way, a sin-
gle pulse applied to CADJ decreases the DAC set-
point by one step, and 31 pulses increase the set-point
by one step.
The error amplifier’s output voltage controls the peak
current output of the MAX758A. The peak switch cur-
rent is therefore controlled by the output of the error
amplifier. The lower the error amplifier’s output, the
lower the peak current. Since the current through the
current source is related to the current through the
tube, the lower the error amplifier’s output, the lower the
tube current.
4
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| PSA60R-240-R-CR1 | ADAPTER WALL R-SERIES 60W 24V |
| PSA60R-240-R-CNR3 | ADAPTER WALL R-SERIES 60W 24V |
| ACM31DRSN | CONN EDGECARD 62POS DIP .156 SLD |
| ABB11DHFD | CONN EDGECARD 22POS .050 SMD |
| FMM36DSEH | CONN EDGECARD 72POS .156 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX-754-1205AP | 功能描述:线性和开关式电源 MAX750 SERIES MULTI OUTPT PWR SUPPLY 12V RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
| MAX-754-1205G | 功能描述:PWR/PWR SUPPLY QUAD OUTPUT 750W RoHS:是 类别:电源 - 外部/内部（非板载） >> AC DC 转换器 系列:MAX-750 产品培训模块:MP Modular-Configurable AC-DC Power Supply 特色产品:Configurable Power Supplies 标准包装:1 系列:MP |
| MAX-754-1205P | 制造商:SLPOWER 制造商全称:SL Power Electronics 功能描述:MAX-750 Multiple Output |
| MAX-754-1252 | 制造商:SLPOWER 制造商全称:SL Power Electronics 功能描述:700, 750 WATTS MULTIPLE OUTPUT |
| MAX7545AKCWP | 制造商:Maxim Integrated Products 功能描述: |
发布紧急采购，3分钟左右您将得到回复。