参数资料
型号: MC13224V
厂商: FREESCALE SEMICONDUCTOR INC
元件分类: 微控制器/微处理器
英文描述: SPECIALTY MICROPROCESSOR CIRCUIT, PBGA99
封装: 9.50 X 9.50 MM, 1.20 MM HEIGHT, ROHS COMPLIANT, LGA-99
文件页数: 3/54页
文件大小: 490K
代理商: MC13224V
MC1322x Technical Data, Rev. 1.3
Freescale Semiconductor
11
impedance matching is also onboard. This combination allows for a very small footprint and a very low
cost RF solution.
The MC1322x also provides a secondary set of complementary PA outputs that can be used with external
RF circuitry such as a additional PA for higher TX power to the antenna. The single-ended port continues
as the receive input for this circuit configuration.
The receiver demodulator includes a module called the Differential Chip Detector which has two modes
of operation:
Non-coherent Detection (NCD) with automatic frequency control (AFC)
Non-coherent Differential Chip Detection (DCD) without AFC
The IEEE 802.15.4 standard allows a maximum clock drift of ±40 ppm (which equals ±80 ppm
station-to-station). The MC1322x 802.15.4 demodulator includes two different methods of operating in
the presence of such large frequency errors:
NCD Mode
Provides an increased ~3.5 dB of sensitivity. However, the addition of the AFC
increases the demodulator current drain about 3 mA.
DCD Mode
Default receive mode at lower current.
For longer range applications where external amplification may be desired (LNA and/or PA), additional
ports are provided for secondary complementary PA outputs. These can be used as a separate PA interface
while the single-ended port through the balun is used as an input only. Also, four control pins and a
regulated 20mA voltage source are provided to control external components and supply power to the PA
outputs.
The RF Interface functionality can be summarized as follows:
Programmable output power — 0 dBm nominal output power, programmable from -30 to +4 dBm
Receive sensitivity (at 1% PER, 20-byte packet) -
— < -96 dBm (typical) DCD receive (well above IEEE 802.15.4 specification of -85 dBm)
— < -100 dBm (typical) NCD receive (higher current)
Single-ended 50-
Ω antenna port — Uses integrated transmit/receive (T/R) switch, LNA, and
onboard balun. Impedance matching onboard.
Maximum flexibility — The optional single-ended port becomes RF input only and a separate set
of full differential PA outputs are provided. Separate input and outputs allow for a variety of RF
configurations including external LNA and PA for increased range
Four control signals for external RF components such as a LNA or PA
Regulated voltage source for PA biasing and powering external components
3.1.2
Modem
The modem supports the full requirement of the IEEE 802.15.4 Standard to transmit and receive data
packets. In additional, the mechanism is present to measure received signal level to provide CCA, ED, and
LQI as required by the 802.15.4 Standard.
相关PDF资料
PDF描述
MC141556P1 UNIVERSAL SERIAL BUS CONTROLLER, PDIP28
MC141556P1 UNIVERSAL SERIAL BUS CONTROLLER, PDIP28
MC14536BFL2 1 TIMER(S), PROGRAMMABLE TIMER, PDSO16
MC14536BFL1 1 TIMER(S), PROGRAMMABLE TIMER, PDSO16
MC146805E2CL 8-BIT, MICROCONTROLLER, CDIP40
相关代理商/技术参数
参数描述
MC13224V 制造商:Freescale Semiconductor 功能描述:; Controller Family/Series:(ARM7); Memor
MC13224V_09 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:Advanced ZigBee?- Compliant Platform-in-Package (PiP) for the 2.4 GHz IEEE? 802.15.4 Standard
MC13224VR2 功能描述:射频收发器 PIP 802.15.4 2.4G IND RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
MC13224VR2 制造商:Freescale Semiconductor 功能描述:IC 32BIT MCU ARM7 26MHZ LGA-99
MC13224VR2-CUT TAPE 制造商:Freescale 功能描述:MC13224 Series 2.4 GHz PIP 250 KBps Surface Mount RF Transceiver - LGA-99