- 您现在的位置：买卖IC网 > PDF目录11546 > MC33389CDW (Freescale Semiconductor)IC SYSTEM BASE W/CAN 28-SOIC PDF资料下载
参数资料
| 型号： | MC33389CDW |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 25/49页 |
| 文件大小： | 0K |
| 描述： | IC SYSTEM BASE W/CAN 28-SOIC |
| 标准包装： | 26 |
| 控制器类型： | 系统基础芯片 |
| 接口： | CAN |
| 电源电压： | 5.5 V ~ 18 V |
| 电流 - 电源： | 45mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC W |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页
Analog Integrated Circuit Device Data
Freescale Semiconductor
31
33389
FUNCTIONAL DEVICE OPERATION
LOGIC COMMANDS AND REGISTERS
entered the MOSI pin starting with Bit15, followed by Bit14,
Bit13, etc., to Bit0. For each fall of the SCLK signal, with CS
held in a logic low state, a data bit is loaded into the shift
register per the tidbit MOSI state.The shift register is full after
sixteen bits of information have been entered.
MISO PIN
The serial output (MISO) pin is the tri-stateable output from
the shift register. The MISO pin remains in a high impedance
state until the CS pin goes to a logic low state. The MISO pin
changes state on the rising edge of SCLK and reads out on
the falling edge of SCLK. The MOSI/MISO shifting of data
follows a first-in-first-out protocol with both input and output
words transferring the MSB first.
Module Address Map, the module address map is shown
in table.
Control and Status Reporting of the 33389
The MCU is responsible for the control data transfer to the
33389, while the 33389 reports its status to the MCU. Major
data for control and status reporting are summarized here:
SPI initialization during start up
33389 control during operation
Watchdog triggering
Reading status registers of the 33389
Control Data
The control data are transferred from the MCU to the
33389. A control word includes an address of a control
register and the appropriate data (see Figure 17). Basically,
the following data will be transferred. Please see SPI
33389 mode control
Supply control
Forced wake-up timing
Cyclic sense control
Watchdog control
Transceiver control
Status Data
The status data are transmitted from the 33389 to the
MCU. After receiving a valid register address from the MCU,
the 33389 returns the appropriate status. Some of the major
status data are listed below:
Current operation mode status
Wake-up sources
Reset status
Error status
Over temperature status
Transceiver status
Data Transfer
The data to and from the 33389 are transferred in form of
two bytes.The structure of the transferred information is the
same as for control and status reporting. The address field A5
to A0 (Bit 15 to Bit 10) contains the address of a control or
status register in the 33389. RW (Bit 9 and Bit 8) contains the
read/write flag for the data field. The parity field is located at
P3 to P0 (Bit 7 to Bit 4). The data field D3 to D0 (Bit 3 to Bit
0) is part of the two-byte data word. Please see Figure 17.
Table 16. Module Address Map
Address
Register
Register Name
$000
Mode Control Register
MCR
$003
Mode Control Validation
RegisterMCVR
MCVR
$005
V3 control register
V3R
$006
Cyclic timing control register
CYTCR
$009
Software watchdog control
register
SWCR
$00A
Ground shift level register
GSLR
$00C
Wake-up input control register
WUICR
$00F
Wake-up input status register
WUISR
$011
Wake up input real time
information
WUIRTI
$012
Overtemperature status regist
OTSR
$014
Transceiver error status
register for CANH
TESRH
$017
Transceiver error status
register for CANL
TESRL
$018
Reset source register
RSR
$01B
Voltage supply status regist
VSSR
$01D
Interrupt mask control register 1
IMR1
$01E
Interrupt mask control register 2
IMR2
$021
Interrupt source register 1
ISR1
$022
Interrupt source register 2
ISR2
$024
Transceiver control register
TCR
Table 16. Module Address Map
Address
Register
Register Name
相关PDF资料 |
PDF描述 |
|---|---|
| MC33388DR2 | IC TOLERANT CAN INT FAULT 14SOIC |
| PX0414 | CONN SMB JACK PNL MNT RG174 |
| PIC16LF1937-E/PT | IC PIC MCU FLASH 512KX14 44-TQFP |
| PIC16F1934-E/ML | IC PIC MCU FLASH 256KX7 44-QFN |
| V48C12M75B | CONVERTER MOD DC/DC 12V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33389CDWR2 | 功能描述:网络控制器与处理器 IC SYSTEM BASIC CHIPS RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MC33389DDW | 功能描述:网络控制器与处理器 IC SBC SOW28 RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MC33389DDWR2 | 功能描述:网络控制器与处理器 IC SBC SOW28 RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MC33390D | 功能描述:IC TRANSCEIVER SER LINK 8-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| MC33390DR2 | 功能描述:IC TRANSCEIVER SER LINK 8-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。