参数资料
型号: MC56F8011VFAE
厂商: FREESCALE SEMICONDUCTOR INC
元件分类: 数字信号处理
英文描述: 0-BIT, 8 MHz, OTHER DSP, PQFP32
封装: ROHS COMPLIANT, LQFP-32
文件页数: 27/125页
文件大小: 1702K
代理商: MC56F8011VFAE
56F8013/56F8011 Data Sheet, Rev. 11
122
Freescale Semiconductor
The thermal characterization parameter is measured per JESD51-2 specification using a 40-gauge type T
thermocouple epoxied to the top center of the package case. The thermocouple should be positioned so
that the thermocouple junction rests on the package. A small amount of epoxy is placed over the
thermocouple junction and over about 1mm of wire extending from the junction. The thermocouple wire
is placed flat against the package case to avoid measurement errors caused by cooling effects of the
thermocouple wire.
When heat sink is used, the junction temperature is determined from a thermocouple inserted at the
interface between the case of the package and the interface material. A clearance slot or hole is normally
required in the heat sink. Minimizing the size of the clearance is important to minimize the change in
thermal performance caused by removing part of the thermal interface to the heat sink. Because of the
experimental difficulties with this technique, many engineers measure the heat sink temperature and then
back-calculate the case temperature using a separate measurement of the thermal resistance of the
interface. From this case temperature, the junction temperature is determined from the junction-to-case
thermal resistance.
12.2 Electrical Design Considerations
Use the following list of considerations to assure correct operation of the 56F8013/56F8011:
Provide a low-impedance path from the board power supply to each VDD pin on the 56F8013/56F8011 and
from the board ground to each VSS (GND) pin
The minimum bypass requirement is to place 0.01–0.1
μF capacitors positioned as close as possible to the
package supply pins. The recommended bypass configuration is to place one bypass capacitor on each of
the VDD/VSS pairs, including VDDA/VSSA. Ceramic and tantalum capacitors tend to provide better
tolerances.
Ensure that capacitor leads and associated printed circuit traces that connect to the chip VDD and VSS (GND)
pins are as short as possible
CAUTION
This device contains protective circuitry to guard
against damage due to high static voltage or electrical
fields. However, normal precautions are advised to
avoid
application
of
any
voltages
higher
than
maximum-rated voltages to this high-impedance circuit.
Reliability of operation is enhanced if unused inputs are
tied to an appropriate voltage level.
相关PDF资料
PDF描述
S568013MFA00E 0-BIT, 8 MHz, OTHER DSP, PQFP32
MC56F8023VLC 16-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP32
MC56F8033VLC 16-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP32
MC56F8347MPY60 16-BIT, 120 MHz, OTHER DSP, PQFP160
MC56F8355VFG60 4-BIT, 120 MHz, OTHER DSP, PQFP128
相关代理商/技术参数
参数描述
MC56F8013 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
MC56F8013E 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
MC56F8013MFAE 功能描述:数字信号处理器和控制器 - DSP, DSC 16Bit DSPHC ANGUILLA RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT
MC56F8013MFAER2 制造商:Freescale Semiconductor 功能描述:16 BIT DSPHC ANGUILLA - Tape and Reel
MC56F8013PB 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers