- 您现在的位置：买卖IC网 > PDF目录1229 > MCP2515DM-PTPLS (Microchip Technology)BOARD DAUGHTER PICTAIL MCP2515 PDF资料下载
参数资料
| 型号： | MCP2515DM-PTPLS |
| 厂商： | Microchip Technology |
| 文件页数： | 16/92页 |
| 文件大小： | 0K |
| 描述： | BOARD DAUGHTER PICTAIL MCP2515 |
| 标准包装： | 1 |
| 系列： | * |
| 主要目的： | 接口，CAN 控制器 |
| 嵌入式： | 是，MCU，8 位 |
| 已用 IC / 零件： | MCP2515，MCP2551 |
| 主要属性： | 置于 PICtail Plus 子板内的 CAN 控制器和 CAN 收发器 |
| 已供物品： | 板，CD |
| 产品目录页面： | 685 (CN2011-ZH PDF) |
| 相关产品： | MCP2515T-I/ST-ND - IC CAN CONTROLLER W/SPI 20TSSOP MCP2515T-I/SO-ND - IC CAN CONTROLLER W/SPI 18SOIC MCP2515T-E/ST-ND - IC CAN CONTROLLER W/SPI 20TSSOP MCP2515T-E/SO-ND - IC CAN CONTROLLER W/SPI 18SOIC MCP2515-E/ST-ND - IC CAN CONTROLLER W/SPI 20TSSOP MCP2515-E/SO-ND - IC CAN CONTROLLER W/SPI 18SOIC MCP2515-E/P-ND - IC CAN CONTROLLER W/SPI 18DIP MCP2515-I/ST-ND - IC CAN CONTROLLER W/SPI 20TSSOP MCP2515-I/SO-ND - IC CAN CONTROLLER W/SPI 18SOIC MCP2515-I/P-ND - IC CAN CONTROLLER W/SPI 18DIP 更多... |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页
MCP2515
3.5
TXnRTS PINS
3.6
Aborting Transmission
The TXnRTS pins are input pins that can be configured
as:
? Request-to-send inputs, which provide an
alternative means of initiating the transmission of
a message from any of the transmit buffers
? Standard digital inputs
Configuration and control of these pins is accomplished
using the TXRTSCTRL register (see Register 3-3). The
TXRTSCTRL register can only be modified when the
request-to-send pin, the pin is mapped into the
respective TXBnCTRL.TXREQ bit for the transmit
buffer. The TXREQ bit is latched by the falling edge of
the TXnRTS pin. The TXnRTS pins are designed to
allow them to be tied directly to the RXnBF pins to
automatically initiate a message transmission when the
RXnBF pin goes low.
The TXnRTS pins have internal pull-up resistors of
100 k ? (nominal).
DS21801G-page 16
The MCU can request to abort a message in a specific
message buffer by clearing the associated
TXBnCTRL.TXREQ bit.
In addition, all pending messages can be requested to
be aborted by setting the CANCTRL.ABAT bit. This bit
MUST be reset (typically after the TXREQ bits have
been verified to be cleared) to continue transmitting
messages. The TXBnCTRL.ABTF flag will only be set
if the abort was requested via the CANCTRL.ABAT bit.
Aborting a message by resetting the TXREQ bit does
NOT cause the ABTF bit to be set.
Note 1: Messages that were transmitting when
the abort was requested will continue to
transmit. If the message does not
successfully complete transmission (i.e.,
lost arbitration or was interrupted by an
error frame), it will then be aborted.
2: When One-Shot mode is enabled, if the
message is interrupted due to an error
frame or loss of arbitration, the
TXBnCTRL.ABTF bit will set.
? 2003-2012 Microchip Technology Inc.
相关PDF资料 |
PDF描述 |
|---|---|
| MCP3905EV | BOARD DEMO FOR MCP3905 |
| MCP402XEV | BOARD EVAL FOR MCP402X |
| MCP42XXEV | BOARD EVALUATION MCP42XX |
| MCP43XXEV | BOARD EVALUATION MCP43XX |
| MCP46XXDM-PTPLS | BOARD PICTAIL DIGI POT MCP4XXX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP2515-E | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Stand-Alone CAN Controller with SPI Interface |
| MCP2515-E/ML | 制造商:Microchip Technology Inc 功能描述: |
| MCP2515-E/P | 功能描述:网络控制器与处理器 IC W/ SPI Inter 125dC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MCP2515-E/SO | 功能描述:网络控制器与处理器 IC W/ SPI Inter 125dC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MCP2515-E/SORB4 | 制造商:Microchip Technology Inc 功能描述: |
发布紧急采购，3分钟左右您将得到回复。