- 您现在的位置：买卖IC网 > PDF目录378674 > MR27V3266D (OKI SEMICONDUCTOR CO., LTD.) 2M x16 / 1M x32 Synchronous OTP ROM PDF资料下载
参数资料
| 型号： | MR27V3266D |
| 厂商： | OKI SEMICONDUCTOR CO., LTD. |
| 英文描述： | 2M x16 / 1M x32 Synchronous OTP ROM |
| 中文描述： | 200万x16 / 1米X32号，同步检察官办公室光盘 |
| 文件页数： | 9/36页 |
| 文件大小： | 234K |
| 代理商： | MR27V3266D |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
1
Semiconductor
READ OPERATIONS
MR27V3266D
August , 1999
Revision 2.4
32M Synchronous OTP
9
CLOCK ( CLK )
The clock input enables MR27V3266D to sample all the inputs, control internal circuitry, and turn on output drivers. All
timings are referred to the rising edge of the clock. All inputs with high level CKE and low level /CS should be valid at
the rising edge of CLK for proper functionality.
CLOCK ENABLE ( CKE )
The clock enable(CKE) turns on or switches off the admission of the clock input into the internal clock signal lines. All
internal circuits are controlled by the internal clock signal to implement every command. High level CKE sampled at
CKEn-1 clock cycle enables the admission of the rising edge of clock input into internal clock line at CKEn cycle. Low
level CKE sampled at CKEn-1 cycle suspends the rising edge of CLK at CKEn cycle. The suspension of internal clock
signal in all state ignores new input except CKE, and holds internal state and output state. Low level CKE in Active
Standby state, defined as Power Down state, cuts power dissipation. In Power Down state the contents of mode
register and Row Address are preserved. After recovering
MR27V3266D is in Active Standby state. Low level CKE just after the sampling of "Read" command till the completion
of burst read, defined as Clock Suspend, makes read operation go on with power dissipation. Any command operation
does not interrupted by arbitrary low level CKE. Sampling command with low level CKE preceded with high level CKE is
illegal.
high level CKE to exit from Power Down state,
POWER ON
Apply power and start clock considering following issues.
1. During power on Mode Register is initialized into default state.
(default state: CAS latency=5, Burst Type=Sequential, Burst length=4)
2. After power on MR27V3266D is in Active Standby state and ready for "Mode Register set" command or
"Row Active" command. MR27V3266D requires neither command nor waiting time as power on sequence after
starting CLK input in order to start "Row Active" command to read data.
3. It is recommended in order to utilize default state of Mode Register that /MR and CKE inputs are maintained
to be pulled up during power on till the implementation of the first "Row Active" command.
After above power on "Row Active" command and "Read" command can be started immediately on default
Mode Register state.
4. It is recommended that DQM input is maintained to be pulled up to prevent unexpected operation of output
buffers.
ORGANIZATION CONTROL
Organization of data output(DQ0-DQ31) depends on the logical level on /WORD at the input timing of every "Read"
command. High level sampling of /WORD derives double word mode(x32) output and low level sampling of /WORD
derives word mode(x16) output. Constant /WORD level input brings consistent organization.
MODE REGISTER
Mode register stores the operating mode of MR27V3266D. Operating modes are consisted with CAS latency, Burst
Type, and Burst Length. Registration of RAS latency is not required, because RAS to CAS delay(tRCD) is requested
independently of system clock.
When the contents of Mode register are required to be changed for the next
operation, "Mode Register Set" command can be sampled at any cycle in Active Standby state. After "Mode Register
Set" command is sampled, /CS must be fixed to logical high level to prevent sampling of new command input during
succeeding three clock cycles.
Refer to Mode Register Field Table for the relation between Operation modes and input pin assignment.
相关PDF资料 |
PDF描述 |
|---|---|
| MRF1015MA | MICROWAVE POWER TRANSISTORS |
| MRF1015MB | MICROWAVE POWER TRANSISTORS |
| MRF16030 | RF POWER TRANSISTOR NPN SILICON |
| MRF18060ASR3 | RF POWER FIELD EFFECT TRANSISTORS |
| MRF18060A | RF POWER FIELD EFFECT TRANSISTORS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MR27V401D | 制造商:OKI 制造商全称:OKI electronic componets 功能描述:524,288-Word x 8-Bit One Time PROM |
| MR27V401D-09TA | 制造商:ROHM Semiconductor 功能描述: |
| MR27V401E | 制造商:OKI 制造商全称:OKI electronic componets 功能描述:524,288-Word 】 8-Bit One Time PROM |
| MR27V401EMA | 制造商:OKI 制造商全称:OKI electronic componets 功能描述:524,288-Word 】 8-Bit One Time PROM |
| MR27V401ERA | 制造商:OKI 制造商全称:OKI electronic componets 功能描述:524,288-Word × 8-Bit One Time PROM |
发布紧急采购，3分钟左右您将得到回复。