- 您现在的位置：买卖IC网 > PDF目录378679 > MSM82C37B-5VJS (OKI SEMICONDUCTOR CO., LTD.) Programmable DMA Controller(可编程DMA控制器) PDF资料下载
参数资料
| 型号： | MSM82C37B-5VJS |
| 厂商： | OKI SEMICONDUCTOR CO., LTD. |
| 英文描述： | Programmable DMA Controller(可编程DMA控制器) |
| 中文描述： | 可编程DMA控制器（可编程DMA的控制器） |
| 文件页数： | 13/33页 |
| 文件大小： | 209K |
| 代理商： | MSM82C37B-5VJS |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
13/33
Semiconductor
MSM82C37B-5RS/GS/VJS
Symbol
EOP
Pin Name
End of Process
Input/Output
Input/Output
Function
EOP
is active-low bidirectional three-state signal. Unlike other
pins, this pin is an N-channel open drain. During DMA operations,
a low-level output pulse is obtained from this pin if the channel
word count changes from 0000H to FFFFH.
And DMA transfers can be terminated by pulling the
EOP
input to
low level. Both of these actions are called terminal count (TC).
When internal or external
EOP
is generated, the MSM82C37B-5
terminates the transfer and resets the DMA request.
When the EOP pin is not used, it is necessary to hold the pin at
high level by pull-up resistor to prevent the input of an EOP
by error. Also note that the
EOP
function cannot be satisfied in
cascade mode.
Hold Request
HRQ
Output
HRQ is active-high signal used as an output of hold request to
the CPU for system data bus control purposes. After HRQ has
become active, at least one clock cycle is required before HLDA
becomes active.
Address Enable
AEN
Output
AEN is active-high ouput signal used to indicate that output
signals sent from the MSM82C37B-5 to the system are valid.
And in addition to enabling external latch to hold the eight higher
order bits of the transfer address, this signal is also used to
disable other system bus buffers.
ADSTB is active-high signal used to strobe the eight higher order
bits of the transfer address by external latch.
DMA Acknowledge
0 - 3 Channels
DACK
0
-
DACK
3
Output
DACK is output signals used to indicate that DMA transfer to
peripheral devices has been permitted. (Available in each channel.)
Although these pins are switched to active-low when reset, they
can be programmed to become active-high.
Note that there is no DACK output signal during memory-memory
transfers.
Address 0 - 3
A
0
- A
3
Input/Output
A
0
- A
3
is bidirectional three-state signals used as input signals
for specifying the MSM82C37B-5 internal register to be accessed
by the CPU during idle cycles, and as an output the four lower
order bits of the transfer address during active cycles.
A
4
- A
7
is three-state signals used as an output the four higher
order bits of the transfer address during active cycles.
Address 4 - 7
A
4
- A
7
Output
Memory Read
MEMR
Output
MEMR
is active-low three-state output signal used as a control
signal in reading data from memory during read transfers and
memory-memory transfers.
MEMW
is active-low three-state output signal used as a control
signal in writing data into memory during write transfers and
memory-memory transfers.
Memory Write
MEMW
Output
Address Strobe
ADSTB
Output
相关PDF资料 |
PDF描述 |
|---|---|
| MSM82C51A-2(中文) | Universal Synchronous Asynchronous Receiver Transmitter(通用同步/异步接收发送器,同步通讯最高可达64Kbps,异步通讯最高可达38.4Kbps) |
| MSM82C51A-2 | Universal Synchronous Asynchronous Receiver Transmitter(通用同步/异步接收发送器,同步通讯最高可达64Kbps,异步通讯最高可达38.4Kbps) |
| MSM82C53-2 | Programmable Universal Timers(可编程中断定时器,最高计数频率8MHz) |
| MSM82C54-2 | Programmable Universal Timers(可编程中断定时器,最高计数频率10MHz) |
| MSM82C55A_2 | Programmable Universal I/O Interface Device(可编程通用I/O接口器件) |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MSM82C43 | 制造商:OKI 制造商全称:OKI electronic componets 功能描述:INPUT/OUTPUT PORT EXPANDER |
| MSM82C51A-2GS | 制造商:OKI 制造商全称:OKI electronic componets 功能描述:UNIVERSAL SYNCHRONOUS ASYNCHRONOUS RECEIVER TRANSMITTER |
| MSM82C51A-2GS-K | 制造商:OK International 功能描述:USART, 32 Pin, Plastic, SOP 制造商:OKI Semiconductor 功能描述:USART, 32 Pin, Plastic, SOP |
| MSM82C51A-2JS | 制造商:ROHM Semiconductor 功能描述: |
| MSM82C51A-2RS | 制造商:ROHM Semiconductor 功能描述: 制造商:ROHM Semiconductor 功能描述:USART,Programmable multifunction 制造商:ROHM Semiconductor 功能描述:USART, programmable multi-function communication interface |
发布紧急采购，3分钟左右您将得到回复。