- 您现在的位置：买卖IC网 > PDF目录96096 > MTP2N40E (ON SEMICONDUCTOR) 2 A, 400 V, 3.5 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB PDF资料下载
参数资料
| 型号： | MTP2N40E |
| 厂商： | ON SEMICONDUCTOR |
| 元件分类： | JFETs |
| 英文描述： | 2 A, 400 V, 3.5 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| 文件页数： | 4/8页 |
| 文件大小： | 217K |
| 代理商： | MTP2N40E |
MTP2N40E
4
Motorola TMOS Power MOSFET Transistor Device Data
POWER MOSFET SWITCHING
Switching behavior is most easily modeled and predicted
by recognizing that the power MOSFET is charge controlled.
The lengths of various switching intervals (
t) are deter-
mined by how fast the FET input capacitance can be charged
by current from the generator.
The published capacitance data is difficult to use for calculat-
ing rise and fall because drain–gate capacitance varies
greatly with applied voltage. Accordingly, gate charge data is
used. In most cases, a satisfactory estimate of average input
current (IG(AV)) can be made from a rudimentary analysis of
the drive circuit so that
t = Q/IG(AV)
During the rise and fall time interval when switching a resis-
tive load, VGS remains virtually constant at a level known as
the plateau voltage, VSGP. Therefore, rise and fall times may
be approximated by the following:
tr = Q2 x RG/(VGG – VGSP)
tf = Q2 x RG/VGSP
where
VGG = the gate drive voltage, which varies from zero to VGG
RG = the gate drive resistance
and Q2 and VGSP are read from the gate charge curve.
During the turn–on and turn–off delay times, gate current is
not constant. The simplest calculation uses appropriate val-
ues from the capacitance curves in a standard equation for
voltage change in an RC network. The equations are:
td(on) = RG Ciss In [VGG/(VGG – VGSP)]
td(off) = RG Ciss In (VGG/VGSP)
The capacitance (Ciss) is read from the capacitance curve at
a voltage corresponding to the off–state condition when cal-
culating td(on) and is read at a voltage corresponding to the
on–state when calculating td(off).
At high switching speeds, parasitic circuit elements com-
plicate the analysis. The inductance of the MOSFET source
lead, inside the package and in the circuit wiring which is
common to both the drain and gate current paths, produces a
voltage at the source which reduces the gate drive current.
The voltage is determined by Ldi/dt, but since di/dt is a func-
tion of drain current, the mathematical solution is complex.
The MOSFET output capacitance also complicates the
mathematics. And finally, MOSFETs have finite internal gate
resistance which effectively adds to the resistance of the
driving source, but the internal resistance is difficult to mea-
sure and, consequently, is not specified.
The resistive switching time variation versus gate resis-
tance (Figure 9) shows how typical switching performance is
affected by the parasitic circuit elements. If the parasitics
were not present, the slope of the curves would maintain a
value of unity regardless of the switching speed. The circuit
used to obtain the data is constructed to minimize common
inductance in the drain and gate circuit loops and is believed
readily achievable with board mounted components. Most
power electronic loads are inductive; the data in the figure is
taken with a resistive load, which approximates an optimally
snubbed inductive load. Power MOSFETs may be safely op-
erated into an inductive load; however, snubbing reduces
switching losses.
GATE–TO–SOURCE OR DRAIN–TO–SOURCE VOLTAGE (VOLTS)
C,
CAP
ACIT
ANCE
(pF)
VGS
VDS
VDS, DRAIN–TO–SOURCE VOLTAGE (VOLTS)
C,
CAP
ACIT
ANCE
(pF)
Figure 7a. Capacitance Variation
Figure 7b. High Voltage Capacitance
Variation
TJ = 25°C
VGS = 0 V
VDS = 0 V
Crss
Ciss
Crss
Coss
500
400
300
200
100
0
–10
– 5
0
5
10
15
20
25
VGS = 0 V
TJ = 25°C
1000
100
10
1
10
100
1000
Ciss
Coss
Crss
相关PDF资料 |
PDF描述 |
|---|---|
| MTP2N40 | 2 A, 400 V, 5 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP2N35 | 2 A, 350 V, 5 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP2N45 | 2 A, 450 V, 4 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP2N50 | 2 A, 500 V, 4 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP3055A | 12 A, 60 V, 0.15 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MTP2N45 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:N-Channel Power MOSFETs, 3.0 A, 450 V/500 V |
| MTP2N50 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:N-Channel Power MOSFETs, 3.0 A, 450 V/500 V |
| MTP2N50E | 制造商:Motorola Inc 功能描述: |
| MTP2N60 | 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:TMOS POWER FET 2.0 AMPERES 600 VOLTS RDS(on) = 3.8 OHMS |
| MTP2N60E | 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:TMOS POWER FET 2.0 AMPERES 600 VOLTS RDS(on) = 3.8 OHMS |
发布紧急采购，3分钟左右您将得到回复。