- 您现在的位置：买卖IC网 > PDF目录1233 > NCP1652L48VGEVB (ON Semiconductor)BOARD EVAL 100W 48V NCP1652 PFC PDF资料下载
参数资料
| 型号： | NCP1652L48VGEVB |
| 厂商： | ON Semiconductor |
| 文件页数： | 25/34页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL 100W 48V NCP1652 PFC |
| 产品变化通告： | 1Q2012 Discontinuation 30/Mar/2012 |
| 标准包装： | 1 |
| 系列： | * |
| 其它名称： | NCP1652L48VGEVB-ND NCP1652L48VGEVBOS |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
NCP1652, NCP1652A
I p
I spos
+
?
g m = 250 m S
g m
blanking
t LEB
Inst. current A
To PWM
comparator
R CS
I AVG
Current sense
amplifier
V IAVG
blanking
t LEB
To AC error
Inst. current B
To PWM skip
comparator
amplifier
R IAVG
Figure 63. Current Sense Amplifier
I CS + I IN + (eq. 3)
C IAVG +
Caution should be exercised when designing a filter
between the current sense resistor and the IS POS input, due
to the low impedance of this amplifier. Any series resistance
due to a filter creates a voltage offset (V OS ) due to its input
bias current, CA Ibias . The input bias current is typically
60 m A. The voltage offset is given by Equation 2.
V OS + CA Ibias @ R external (eq. 2)
The offset adds a positive offset to the current sense signal.
The ac error amplifier will then try to compensate for the
average output current which appears never to go to zero and
cause additional zero crossing distortion.
A voltage proportional to the main switch current is
applied to the IS POS pin. The IS POS pin voltage is converted
into a current, i 1 , and internally mirrored. Two internal
currents are generated, I CS and I AVG . I CS is a high frequency
signal which is a replica of the instantaneous switch current.
I AVG is a low frequency signal. The relationship between
V ISPOS and I CS and I AVG is given by Equation 3.
V ISPOS
4k
The PWM Output delivers current to the positive input of
the PWM input where it is added to the AC EA and ramp
compensation signal.
The I AVG Output generates a voltage signal to a buffer
amplifier. This voltage signal is the product of I AVG and an
external R IAVG resistor filtered by the capacitor on the I AVG
pin, C IAVG . The pole frequency, f P , set by C IAVG should be
significantly below the switching frequency to remove the
high frequency content. But, high enough to not to cause
significant distortion to the input full wave rectified
sinewave waveform. A properly filtered average current
signal has twice the line frequency. Equation 4 shows the
relationship between C IAVG (in nF) and f P (in kHz).
1
(eq. 4)
2 @ p @ R IAVG @ f P
http://onsemi.com
25
相关PDF资料 |
PDF描述 |
|---|---|
| NCP1653EVB | BOARD EVAL FOR NCP1653 |
| NCP2993FCT2GEVB | BOARD EVAL NCP2993 AUDIO PWR AMP |
| NCP345SNT1G | IC DETECTOR OVER VOLTAGE 5TSOP |
| NCP346SN2T1G | IC DETECTOR OVER VOLTAGE 5TSOP |
| NCP347MTAITBG | IC OVERVOLTAGE PROT CTRLR 10WDFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCP1653ADR2 | 功能描述:功率因数校正 IC Fixed Frequency RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| NCP1653ADR2G | 功能描述:功率因数校正 IC Fixed Frequency Current Mode PFC RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| NCP1653ADR2G-CUT TAPE | 制造商:ON 功能描述:NCP1653 Series 15 V 6 mA Current-Mode Power Factor Correction Controller SOIC-8 |
| NCP1653AP | 功能描述:功率因数校正 IC Fixed Frequency RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| NCP1653APG | 功能描述:功率因数校正 IC Fixed Frequency Current Mode PFC RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。