参数资料
型号: NCP3011DTBR2G
厂商: ON Semiconductor
文件页数: 25/28页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM VM 14TSSOP
标准包装: 1
PWM 型: 电压模式
输出数: 1
频率 - 最大: 470kHz
占空比: 83%
电源电压: 4.7 V ~ 28 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 14-TSSOP(0.173",4.40mm 宽)
包装: 标准包装
其它名称: NCP3011DTBR2GOSDKR
NCP3011, NCV3011
High ? Side
Logic Signal
Low ? Side
Logic Signal
R DSmax
High ? Side
MOSFET
t d(on)
NOL HL
t f
NOL LH
R DS(on)min
R DSmax
Low ? Side
MOSFET
t r
t d(off)
t r
t f
R DS(on)min
t d(on)
t d(off)
Figure 44. MOSFETs Timing Diagram
f P0 +
f Z0 +
2 @ p @ C OUT @ ESR
Another consideration during MOSFET selection is their
delay times. Turn ? on and turn ? off times must be short
enough to prevent cross conduction. If not, there will be
conduction from the input through both MOSFETs to
ground. Therefore, the following conditions must be met.
t d(ON)_CONTROL ) NOL LH u t d(OFF)_SYNC ) t f _SYNC
and (eq. 40)
t (ON)_SYNC ) NOL HL u t d(OFF)_CONTROL ) t f _CONTROL
The MOSFET parameters, t d(ON) , t r , t d(OFF) and t f are can
be found in their appropriate datasheets for specific
conditions. NOL LH and NOL HL are the dead times which
were described earlier and are 85 ns and 75 ns, respectively.
Feedback and Compensation
The NCP3011 is a voltage mode buck convertor with a
transconductance error amplifier compensated by an
external compensation network. Compensation is needed to
achieve accurate output voltage regulation and fast transient
Table 2. COMPENSATION TYPES
response. The goal of the compensation circuit is to provide
a loop gain function with the highest crossing frequency and
adequate phase margin (minimally 45 ° ). The transfer
function of the power stage (the output LC filter) is a double
pole system. The resonance frequency of this filter is
expressed as follows:
1
(eq. 41)
2 @ p @ L @ C OUT
Parasitic Equivalent Series Resistance (ESR) of the
output filter capacitor introduces a high frequency zero to
the filter network. Its value can be calculated by using the
following equation:
1
(eq. 42)
The main loop zero crossover frequency f 0 can be chosen
to be 1/10 ? 1/5 of the switching frequency. Table 2 shows
the three methods of compensation.
Zero Crossover Frequency Condition
f P0 < f Z0 < f 0 < f S /2
f P0 < f 0 < f Z0 < f S /2
f P0 < f 0 < f S /2 < f Z0
Compensation Type
Type II
Type III Method I
Type III Method II
http://onsemi.com
25
Typical Output Capacitor Type
Electrolytic, Tantalum
Tantalum, Ceramic
Ceramic
相关PDF资料
PDF描述
RPP50-483.3S CONV DC/DC 50W 36-75VIN 3.3VOUT
RPP40-2424DW CONV DC/DC 40W 9-36V +/-24VOUT
RPP40-2415DW-F CONV DC/DC 40W 9-36V +/-15VOUT
RPP40-2415DW-1F CONV DC/DC 40W 9-36V +/-15VOUT
RPP40-2415DW-1 CONV DC/DC 40W 9-36V +/-15VOUT
相关代理商/技术参数
参数描述
NCP3011GEVB 功能描述:电源管理IC开发工具 NCP3011 EVALUATION BOARD RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
NCP3012 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Synchronous PWM Controller
NCP3012DTBR2G 功能描述:电压模式 PWM 控制器 Single Output Buck 0.8V to 40V 70uA RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel
NCP301HSN09T1 功能描述:电压监测器/监控器 0.9V Detector RoHS:否 制造商:Texas Instruments 监测电压数:2 监测电压:Adjustable 输出类型:Open Drain 欠电压阈值: 过电压阈值: 准确性:1 % 工作电源电压:1.5 V to 6.5 V 工作电源电流:1.8 uA 最大工作温度:+ 125 C 封装 / 箱体:SON-6 安装风格:SMD/SMT
NCP301HSN09T1G 功能描述:电压监测器/监控器 0.9V Detector w/Reset High RoHS:否 制造商:Texas Instruments 监测电压数:2 监测电压:Adjustable 输出类型:Open Drain 欠电压阈值: 过电压阈值: 准确性:1 % 工作电源电压:1.5 V to 6.5 V 工作电源电流:1.8 uA 最大工作温度:+ 125 C 封装 / 箱体:SON-6 安装风格:SMD/SMT