参数资料
型号: NCV8881PWR2G
厂商: ON Semiconductor
文件页数: 26/33页
文件大小: 321K
描述: IC REG TRPL BUCK/LINEAR 16SOIC
标准包装: 1
拓扑: 降压(降压)(1),线性(LDO)(2)
功能: 车载
输出数: 3
频率 - 开关: 170kHz
电压/电流 - 输出 1: 3.3 V ~ 8 V,1.5A
电压/电流 - 输出 2: 5V,100mA
电压/电流 - 输出 3: 8.5V,40mA
带 LED 驱动器:
带监控器:
带序列发生器:
电源电压: 5 V ~ 19 V
工作温度: -40°C ~ 150°C
安装类型: 表面贴装
封装/外壳: 16-SOIC(0.295",7.50mm 宽)裸露焊盘
供应商设备封装: 16-SOIC W
包装: 标准包装
其它名称: NCV8881PWR2GOSDKR
NCV8881
http://onsemi.com
26
0
8P5
1
2
3
4
5
6
7
9
10
11
12
OUTPUT
ENABLE
5P0
VIN
8
SMPS
SOFTSTART TIMER
ShortCircuit Threshold
SMPS LATCHED OFF
Regulation Threshold
Figure 51. SMPS ShortCircuit After Successful Startup #2
WATCHDOG
WATCHDOG FUNCTION
The Watchdog function monitors the WDI input to check
that WDI pulses arrive more frequently than the
programmed minimum rate. Monitoring commences after
two sequential time periods (the POR and BOOT Delays)
which start when the SMPS output reaches regulation. After
these initial time periods, time between WDI falling edges
exceeding the Watchdog Delay indicates abnormal
microcontroller activity, and the NCV8881 responds by
pulling the open drain RESB output low. A single external
resistor from the RDLY pin to ground programs the POR,
BOOT and Watchdog Delays.
When enabled and upon the SMPS output reaching
regulation, the NCV8881 enters the POR Delay period
t
POR
, during which the RESB pin is held low. When the
POR Delay expires, the NCV8881 enters the BOOT Delay
period t
BD
 during which the RESB output is allowed to be
pulled up by the external resistance. When the BOOT Delay
expires, the Watchdog circuit begins monitoring the WDI
pin for a falling edge (from a microprocessor or other signal
source). If a falling edge arrives before the Watchdog Delay
period t
WD
 expires, RESB remains high and a new
Watchdog Delay period is initiated. Otherwise the
NCV8881 enters another POR Delay period and the RESB
pin is pulled low, while the SMPS and LDO outputs continue
to regulate. If EN is low when the Watchdog Delay expires
(no falling edge has occurred at the WDI input), RESB is
pulled low and the NCV8881 shuts off all power outputs
(SMPS and LDOs) and minimizes supply current.
In order to ensure that WDI pulses keep RESB from being
pulled low, they must never occur further apart than the
minimum specified t
WD
. However, RESB is not guaranteed
to be pulled low unless pulses occur further apart than the
maximum specified t
WD
.
Removal of other conditions that cause RESB to go low
(V
IN
 > V
OVSTP
, temperature > T
TSD
, and SMPS output
voltage low) also initiate POR and BOOT Delays prior to
resumption of WDI monitoring.
Figures 52 through 57 illustrate the action of RESB and
the POR, BOOT, and Watchdog Delays during startup and
shutdown.
The Watchdog Delay is internally limited to a maximum
value proportional to the switching period in case the
resistance at the RDLY pin becomes excessively high, such
as would occur if the path from the RDLY pin through the
RDLY resistance becomes an open circuit.
相关PDF资料
PDF描述
NE1617ADS,112 IC TEMP MONITOR 16SSOP
NE1619DS,118 IC TEMP MONITOR 16SSOP
NIS5112D1R2G IC ELECTRONIC FUSE HOTSWAP 8SOIC
NIS5132MN2TXG IC ELECTRONIC FUSE 12V 10DFN
NIS5132MN3TXG IC ELECTRONIC FUSE 12V 10-DFN
相关代理商/技术参数
参数描述
NCV890100 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:1.2A, 2MHz Automotive Buck Switching Regulator
NCV890100MWTXG 功能描述:IC REG BUCK ADJ 1.2A 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:50 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:5 V ~ 25 V 输入电压:2.3 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:600kHz,1.2MHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP,8-MSOP(0.118",3.00mm 宽) 包装:管件 供应商设备封装:8-MSOP
NCV890100PDR2G 功能描述:直流/直流开关调节器 Auto Buck Switching Regulator 1.2A 2 MHz RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
NCV890101 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:1.2A, 2MHz Automotive Buck Switching Regulator
NCV890101MWTXG 功能描述:IC REG BUCK ADJ 1.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:两者兼有 输出数:1 输出电压:5V,1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:16-QSOP