参数资料
型号: PCA9624PW,118
厂商: NXP Semiconductors
文件页数: 2/37页
文件大小: 0K
描述: IC LED DRIVER RGBA 24-TSSOP
标准包装: 2,500
拓扑: 开路漏极,PWM
输出数: 8
内部驱动器:
类型 - 主要: 背光,LED 闪烁器
类型 - 次要: RGBA
频率: 100kHz ~ 1MHz
电源电压: 2.3 V ~ 5.5 V
输出电压: 40V
安装类型: 表面贴装
封装/外壳: 24-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 24-TSSOP
包装: 带卷 (TR)
工作温度: -40°C ~ 85°C
NXP Semiconductors
PCA9624
8-bit Fm+ I 2 C-bus 100 mA 40 V LED driver
2. Features and benefits
? 8 LED drivers. Each output programmable at:
? Off
? On
? Programmable LED brightness
? Programmable group dimming/blinking mixed with individual LED brightness
? 1 MHz Fast-mode Plus compatible I 2 C-bus interface with 30 mA high drive capability
on SDA output for driving high capacitive buses
? 256-step (8-bit) linear programmable brightness per LED output varying from fully off
(default) to maximum brightness using a 97 kHz PWM signal
? 256-step group brightness control allows general dimming (using a 190 Hz PWM
signal) from fully off to maximum brightness (default)
? 256-step group blinking with frequency programmable from 24 Hz to 10.73 s and duty
cycle from 0 % to 99.6 %
? Eight open-drain outputs can sink between 0 mA to 100 mA and are tolerant to a
maximum off state voltage of 40 V. No input function.
? Output state change programmable on the Acknowledge or the STOP Command to
update outputs byte-by-byte or all at the same time (default to ‘Change on STOP’).
? Active LOW Output Enable (OE) input pin allows for hardware blinking and dimming of
the LEDs
? 7 hardware address pins allow 126 PCA9624 devices to be connected to the same
I 2 C-bus and to be individually programmed
? 4 software programmable I 2 C-bus addresses (one LED Group Call address and three
LED Sub Call addresses) allow groups of devices to be addressed at the same time in
any combination (for example, one register used for ‘All Call’ so that all the PCA9624s
on the I 2 C-bus can be addressed at the same time and the second register used for
three different addresses so that 1 ? 3 of all devices on the bus can be addressed at the
same time in a group). Software enable and disable for I 2 C-bus address.
? Software Reset feature (SWRST Call) allows the device to be reset through the
I 2 C-bus
? 25 MHz internal oscillator requires no external components
? Internal power-on reset
? Noise filter on SDA/SCL inputs
? No glitch on power-up
? Supports hot insertion
? Low standby current
? Operating power supply voltage (V DD ) range of 2.3 V to 5.5 V
? 5.5 V tolerant inputs on non-LED pins
? ? 40 ? C to +85 ? C operation
? ESD protection exceeds 2000 V HBM per JESD22-A114 and 1000 V CDM per
JESD22-C101
? Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA
? Packages offered: TSSOP24, HVQFN24
PCA9624
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 3 — 6 September 2012
? NXP B.V. 2012. All rights reserved.
2 of 37
相关PDF资料
PDF描述
PCA9625D/S911,518 IC LED DRIVER RGBA 32-SOIC
PCA9626BS,518 IC LED DRIVER RGBA 48HVQFN
PCA9632DP2,118 IC LED DRIVER RGBA 10-TSSOP
PCA9633BS,118 IC LED DRIVER RGBA 16-HVQFN
PCA9634D,118 IC LED DRIVER RGBA 20-SOIC
相关代理商/技术参数
参数描述
PCA9625D 功能描述:LED照明驱动器 16BT I2C FMTP LED HVCON RST OE RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9625D,512 功能描述:LED照明驱动器 16BT I2C FMTP LED HVCON RST OE RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9625D,518 功能描述:LED照明驱动器 16-bit Fm I2C Bus 100mA 24 V LED drivr RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9625D/S911,518 功能描述:LED照明驱动器 16BT I2C FMTP LED HVCON RST OE RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9625D/S911-T 功能描述:LED照明驱动器 16BT I2C FMTP LED HVCON RST OE RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N