- 您现在的位置：买卖IC网 > PDF目录11618 > PIC16F1508T-I/SS (Microchip Technology)IC MCU 8BIT 7KB FLASH 20-SSOP PDF资料下载
参数资料
| 型号： | PIC16F1508T-I/SS |
| 厂商： | Microchip Technology |
| 文件页数： | 54/123页 |
| 文件大小： | 0K |
| 描述： | IC MCU 8BIT 7KB FLASH 20-SSOP |
| 标准包装： | 1,600 |
| 系列： | PIC® XLP™ 16F |
| 核心处理器： | PIC |
| 芯体尺寸： | 8-位 |
| 速度： | 20MHz |
| 连通性： | I²C，LIN，SPI，UART/USART |
| 外围设备： | 欠压检测/复位，POR，PWM，WDT |
| 输入/输出数： | 17 |
| 程序存储器容量： | 7KB（4K x 14） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 256 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.3 V ~ 5.5 V |
| 数据转换器： | A/D 12x10b，D/A 1x5b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 20-SSOP（0.209"，5.30mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页当前第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页
Micrel, Inc.
KSZ8873MLLJ
September 2011
36
M9999-091911-1.8
All the packets received on port A and transmitted on port B are mirrored on the sniffer port. To turn on the “AND”
feature, set register 5 bit [0] to ‘1’. For example, port 1 is programmed to be “receive sniff”, port 2 is programmed
to be “transmit sniff”, and port 3 is programmed to be the “sniffer port”. A packet received on port 1 is destined to
port 2 after the internal lookup. The KSZ8873MLLJ forwards the packet to both port 2 and port 3.
Multiple ports can be selected as “receive sniff” or “transmit sniff”. In addition, any port can be selected as the “sniffer port”.
All these per port features can be selected through registers 17, 33 and 49 for ports 1, 2 and 3, respectively.
Rate Limiting Support
The KSZ8873MLLJ provides a fine resolution hardware rate limiting from 64Kbps to 99Mbps. The rate step is 64Kbps
when the rate range is from 64Kbps to 960Kbps and 1Mbps for 1Mbps to 100Mbps(100BT) or to 10Mbps(10BT) (refer to
Data Rate Limit Table). The rate limit is independently on the “receive side” and on the “transmit side” on a per port basis.
For 10BASE-T, a rate setting above 10 Mbps means the rate is not limited. On the receive side, the data receive rate for
each priority at each port can be limited by setting up Ingress Rate Control Registers. On the transmit side, the data
transmit rate for each priority queue at each port can be limited by setting up Egress Rate Control Registers. The size of
each frame has options to include minimum IFG (Inter Frame Gap) or Preamble byte, in addition to the data field (from
packet DA to FCS).
For ingress rate limiting, KSZ8873MLLJ provides options to selectively choose frames from all types, multicast, broadcast,
and flooded unicast frames. The KSZ8873MLLJ counts the data rate from those selected type of frames. Packets are
dropped at the ingress port when the data rate exceeds the specified rate limit.
For egress rate limiting, the Leaky Bucket algorithm is applied to each output priority queue for shaping output traffic. Inter
frame gap is stretched on a per frame base to generate smooth, non-burst egress traffic. The throughput of each output
priority queue is limited by the egress rate specified.
If any egress queue receives more traffic than the specified egress rate throughput, packets may be accumulated in the
output queue and packet memory. After the memory of the queue or the port is used up, packet dropping or flow control
will be triggered. As a result of congestion, the actual egress rate may be dominated by flow control/dropping at the
ingress end, and may be therefore slightly less than the specified egress rate.
To reduce congestion, it is a good practice to make sure the egress bandwidth exceeds the ingress bandwidth.
Unicast MAC Address Filtering
The unicast MAC address filtering function works in conjunction with the static MAC address table. First, the static MAC
address table is used to assign a dedicated MAC address to a specific port. If a unicast MAC address is not recorded in
the static table, it is also not learned in the dynamic MAC table. The KSZ8873MLLJ is then configured with the option to
either filter or forward unicast packets for an unknown MAC address. This option is enabled and configured in register 14.
This function is useful in preventing the broadcast of unicast packets that could degrade the quality of the port in
applications such as voice over Internet Protocol (VoIP).
Configuration Interface
The KSZ8873MLLJ can operate as both a managed switch and an unmanaged switch.
In unmanaged mode, the KSZ8873MLLJ is typically programmed using an EEPROM. If no EEPROM is present, the
KSZ8873MLLJ is configured using its default register settings. Some default settings are configured via strap-in pin
options. The strap-in pins are indicated in the “Pin Description and I/O Assignment” table.
I
2C Master Serial Bus Configuration
With an additional I
2C (“2-wire”) EEPROM, the KSZ8873MLLJ can perform more advanced switch features like “broadcast
storm protection” and “rate control” without the need of an external processor.
For KSZ8873MLLJ I
2C Master configuration, the EEPROM stores the configuration data for register 0 to register 120 (as
defined in the KSZ8873MLLJ register map) with the exception of the “Read Only” status registers. After the de-assertion
of reset, the KSZ8873MLLJ sequentially reads in the configuration data for all control registers, starting from register 0.
相关PDF资料 |
PDF描述 |
|---|---|
| PIC16HV610-E/P | IC PIC MCU FLASH 1KX14 14DIP |
| PIC16HV616-I/ML | IC PIC MCU FLASH 2KX14 16QFN |
| PIC16F1507T-I/ML | IC MCU 8BIT 3.5KB FLASH 20QFN |
| PIC16LF1507T-I/ML | IC MCU 8BIT 3.5KB FLASH 20QFN |
| D38999/20MJ24PA | CONN RCPT 24POS WALL MNT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PIC16F1509-E/ML | 功能描述:8位微控制器 -MCU 14KB FLASH 512B RAM 18 I/O 10-BIT ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16F1509-E/P | 功能描述:8位微控制器 -MCU 14KB FLASH 512B RAM 18 I/O 10-BIT ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16F1509-E/SO | 功能描述:8位微控制器 -MCU 14KB FLASH 512B RAM 18 I/O 10-BIT ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16F1509-E/SS | 功能描述:8位微控制器 -MCU 14KB FLASH 512B RAM 18 I/O 10-BIT ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16F1509-I/ML | 功能描述:8位微控制器 -MCU 14KB FLASH 512B RAM RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。