参数资料
型号: R5F2L3AACDFP
元件分类: 微控制器/微处理器
英文描述: 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
封装: 14 X 14 MM, 0.50 MM PITCH, PLASTIC, LQFP-100
文件页数: 21/74页
文件大小: 959K
代理商: R5F2L3AACDFP
29
2588F–AVR–06/2013
ATtiny261/461/861
It is possible to reach a higher accuracy than factory calibration by changing the OSCCAL regis-
this calibration is shown as User calibration in Table 19-2 on page 189.
When this oscillator is used as device clock, the Watchdog Oscillator will still be used for the
Watchdog Timer and for the Reset Time-out. For more information on the pre-programmed cali-
bration value, see section “Calibration Byte” on page 173.
6.2.4
Internal 128 kHz Oscillator
The 128 kHz internal oscillator is a low power oscillator providing a clock of 128 kHz. The fre-
quency depends on supply voltage, temperature and batch variations. This clock may be select
as the system clock by programming the CKSEL Fuses to “0011”.
When this clock source is selected, start-up times are determined by the SUT Fuses as shown in
Note:
1. If the RSTDISBL fuse is programmed, this start-up time will be increased to 14CK + 4 ms to
ensure programming mode can be entered.
6.2.5
Low-Frequency Crystal Oscillator
To use a 32.768 kHz watch crystal as the clock source for the device, the low-frequency crystal
oscillator must be selected by setting CKSEL fuses to ‘0100’. The crystal should be connected
as shown in Figure 6-4. To find suitable capacitors please consult the manufacturer’s datasheet.
When this oscillator is selected, start-up times are determined by the SUT fuses as shown in
Notes:
1. These options should be used only if frequency stability at start-up is not important.
The Low-frequency Crystal Oscillator provides an internal load capacitance, see Table 6-10 at
each TOSC pin.
Table 6-8.
Start-up Times for the 128 kHz Internal Oscillator
SUT1:0
Start-up Time from Power-
down and Power-save
Additional Delay from
Reset
Recommended Usage
00
6 CK
14CK(1)
BOD enabled
01
6 CK
14CK + 4 ms
Fast rising power
10
6 CK
14CK + 64 ms
Slowly rising power
11
Reserved
Table 6-9.
Start-up Times for the Low Frequency Crystal Oscillator Clock Selection
SUT1:0
Start-up Time
from Power Down
Additional Delay
from Reset
Recommended usage
00
1K (1024) CK(1)
4 ms
Fast rising power or BOD enabled
01
1K (1024) CK(1)
64 ms
Slowly rising power
10
32K (32768) CK
64 ms
Stable frequency at start-up
11
Reserved
Table 6-10.
Capacitance for Low-Frequency Crystal Oscillator
Device
32 kHz Osc. Type
Cap (Xtal1/Tosc1)
Cap (Xtal2/Tosc2)
ATtiny261/461/861
System Osc.
16 pF
6 pF
相关PDF资料
PDF描述
R5F2L3ACCNFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
R5F2L38ACNFA 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
R5F2L38CCNFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
R5F2L387CDFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
R5F2L387CNFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
相关代理商/技术参数
参数描述
R5F2L3AACDFP#U1 制造商:Renesas Electronics Corporation 功能描述:
R5F2L3AACDFP#V0 制造商:Renesas Electronics Corporation 功能描述:R8C/L3AC 96K+4K/10K 100LQFP14X14 -40-+85 - Trays
R5F2L3AACNFA#U0 制造商:Renesas Electronics Corporation 功能描述:R8CL3AC 96+4KB 1.8/5.5V -20 TO 85C 100QFP - Trays 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH 100LQFP
R5F2L3AACNFP#30 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH 100LQFP 制造商:Renesas Electronics Corporation 功能描述:R8C Series 16 bit 10 kB RAM 96 kB Flash Single Chip Microcontroller SMT-LQFP-100
R5F2L3AACNFP#V0 功能描述:MCU 1KB FLASH 96K ROM 100-LQFP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:R8C/Lx/3AC 标准包装:250 系列:56F8xxx 核心处理器:56800E 芯体尺寸:16-位 速度:60MHz 连通性:CAN,SCI,SPI 外围设备:POR,PWM,温度传感器,WDT 输入/输出数:21 程序存储器容量:40KB(20K x 16) 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:6K x 16 电压 - 电源 (Vcc/Vdd):2.25 V ~ 3.6 V 数据转换器:A/D 6x12b 振荡器型:内部 工作温度:-40°C ~ 125°C 封装/外壳:48-LQFP 包装:托盘 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323