- 您现在的位置：买卖IC网 > PDF目录1967 > SI2457-D-GT (Silicon Laboratories Inc)IC ISOMODEM GLOBAL DAA 24TSSOP PDF资料下载
参数资料
| 型号： | SI2457-D-GT |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 14/60页 |
| 文件大小： | 0K |
| 描述： | IC ISOMODEM GLOBAL DAA 24TSSOP |
| 标准包装： | 62 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
Si2457/34/15/04
Rev. 1.3
21
4.13. Overcurrent Detection
The Si2457/34/15/04 includes an overcurrent detection
feature
that
measures
the
loop
current
at
a
programmable time after the Si2457/34/15/04 goes off-
hook. This allows the Si2457/34/15/04 to detect if it is
connected
to
an
improper
telephone
line.
The
overcurrent detection feature may be enabled by setting
the OCDM bit (U70, bit 11). OHT (U77, bits 8:0) sets the
delay after off-hook until the loop current is measured.
See “AN93: ISOmodem Chipset Family Designer's
Guide” for details.
4.14. Global Operation
The Si2457/34/15/04 chipset contains an integrated
silicon direct access arrangement (Silicon DAA) that
provides a programmable line interface to meet
international telephone line interface requirements.
“AN93: Modem Designer’s Guide” gives the DAA
register settings required to meet international PTT
standards.
Additionally, the user-access registers (via the AT:U and
AT:R commands) may be programmed for country-
specific settings, such as dial tone, ring, ringback, and
busy tone. See AN93 for complete details.
4.15. Firmware Upgrades
The Si2457/34/15/04 contains an on-chip program ROM
that includes the firmware required for the features
listed in this data sheet. In addition, the Si2457/34/15/04
contains on-chip program RAM to accommodate minor
changes to the ROM firmware. This allows Silicon Labs
to provide future firmware updates to optimize the
characteristics of new modem designs and those
already deployed in the field. See AN93 for complete
details.
4.16. DTMF Detection / Generation
The Si2457/34/15/04 provides comprehensive DTMF
tone generation and detection. The ISOmodem can
generate single tones or DTMF tones using the +VTS
command. DTMF tones may also be generated during
dialing using the “ATDT” command. DTMF detection is
only available in voice mode (+FCLASS = 8). DTMF
digits are reported from the modem to the host using
<DLE> shielding.
4.17. SMS/MMS Support
Short Message Service (SMS) is a service that allows
text messages to be sent and received from one
telephone to another via an SMS service center.
Multimedia Messaging Service (MMS) extends the core
SMS
capability
to
send
messages
that
include
multimedia content. The Fax ISOmodem provides an
interface that offers a great deal of flexibility in handling
multiple SMS standards. This flexibility is possible
because most of the differences between standards are
handled by the host using the raw data itself. The
Si2457/34/15/04 performs the necessary modulation/
demodulation of the data and provides two options for
message packet structure (Protocol 1 and Protocol 2, as
defined in ETSI ES 201 912). The rest of the data link
layer and transfer layer are defined by the host system.
The content of the message is entirely up to the host
including any checksum or CRC. ETSI ES 201 912
describes two standard data and transfer layers that are
commonly
used.
SMS
typically
relies
on
caller
identification information to determine if the call should
be answered using an SMS device or not.
See “6.4. SMS Support” in AN93 for more information
on how to configure the modem for SMS support.
4.18. Codec Interface (24-Pin Version Only)
In order to support a full range of voice and data
applications, the Si2457/34/15/04 includes an optional
serial interface that connects to an external voice codec
(Si3000). See AN93 for complete details.
4.19. EEPROM Interface
(24-Pin Version Only)
The
Si2457/34/15/04
supports
an
optional
serial
peripheral interface (SPI) bus serial EEPROM Mode 3
with a 16-bit (8–64 kbit range) address. Upon powerup,
if a pulldown resistor
10 k is placed between D6 and
GND, the ISOmodem attempts to detect an EEPROM.
The EEPROM is intended first for setting custom
defaults, second for automatically loading firmware
upgrades, and third to allow for user-defined AT
command macros for use in custom AT commands or
country codes. See AN93 for complete details.
4.20. AT Commands
At powerup, the Si2457/34/15/04 is in the AT command
mode. In command mode, the modem monitors the
input (serial or parallel) checking constantly for a valid
command (AT commands are described in Table 8.)
相关PDF资料 |
PDF描述 |
|---|---|
| SI3016-BS | IC LINE-SIDE DAA 16SOIC |
| SI3452D-B01-GM | IC POE CONTROLLER MIDSPAN 40QFN |
| SI4126-F-BMR | IC SYNTHESIZER RF2/IF 28MLP |
| SI5040-A-GM | IC TXRX XFP 10GBPS 32LGA |
| SI5100-G-BC | IC TXRX SERIAL/DESERIAL 195CBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI2457-D-GTR | 制造商:Silicon Laboratories Inc 功能描述:56 KBPS, V.90 ISOMODEM SYSTEM- 制造商:Silicon Laboratories Inc 功能描述:56 KBPS, V.90 ISOMODEM SYSTEM-SIDE - LEAD-FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEM GLOBAL DAA 24TSSOP 制造商:Silicon Laboratories Inc 功能描述:56 kbps V90 ISOmodem System-Side PBF |
| Si2457FS08-EVB | 功能描述:网络开发工具 16-pin Si2457+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 产品:Development Kits 类型:Ethernet to Wi-Fi Bridges 工具用于评估:RCM6600W 数据速率:20 Mbps, 40 Mbps 接口类型:802.11 b/g, Ethernet 工作电源电压:3.3 V |
| Si2457FS18-EVB | 功能描述:网络开发工具 16-pin Si2457+Si3018 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 产品:Development Kits 类型:Ethernet to Wi-Fi Bridges 工具用于评估:RCM6600W 数据速率:20 Mbps, 40 Mbps 接口类型:802.11 b/g, Ethernet 工作电源电压:3.3 V |
| SI2457-FT | 功能描述:电信线路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| Si2457FT08-EVB | 功能描述:网络开发工具 24-pin Si2457+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 产品:Development Kits 类型:Ethernet to Wi-Fi Bridges 工具用于评估:RCM6600W 数据速率:20 Mbps, 40 Mbps 接口类型:802.11 b/g, Ethernet 工作电源电压:3.3 V |
发布紧急采购，3分钟左右您将得到回复。