- 您现在的位置：买卖IC网 > PDF目录25623 > SJ80C32XXX-12SV (ATMEL CORP) 8-BIT, 12 MHz, MICROCONTROLLER, CQCC44 PDF资料下载
参数资料
| 型号： | SJ80C32XXX-12SV |
| 厂商： | ATMEL CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, 12 MHz, MICROCONTROLLER, CQCC44 |
| 封装： | JLCC-44 |
| 文件页数： | 67/109页 |
| 文件大小： | 10824K |
| 代理商： | SJ80C32XXX-12SV |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页当前第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页
46
ATtiny20 [DATASHEET]
8235E–AVR–03/2013
When reading back a software assigned pin value, a nop instruction must be inserted as indicated in Figure 10-5 on page
46. The out instruction sets the “SYNC LATCH” signal at the positive edge of the clock. In this case, the delay tpd through
the synchronizer is one system clock period.
Figure 10-5. Synchronization when Reading a Software Assigned Pin Value
10.2.5 Digital Input Enable and Sleep Modes
As shown in Figure 10-2 on page 43, the digital input signal can be clamped to ground at the input of the schmitt-trigger.
The signal denoted SLEEP in the figure, is set by the MCU Sleep Controller in Power-down and Standby modes to avoid
high power consumption if some input signals are left floating, or have an analog signal level close to VCC/2.
SLEEP is overridden for port pins enabled as external interrupt pins. If the external interrupt request is not enabled,
SLEEP is active also for these pins. SLEEP is also overridden by various other alternate functions as described in
If a logic high level (“one”) is present on an asynchronous external interrupt pin configured as “Interrupt on Rising Edge,
Falling Edge, or Any Logic Change on Pin” while the external interrupt is not enabled, the corresponding External
Interrupt Flag will be set when resuming from the above mentioned Sleep mode, as the clamping in these sleep mode
produces the requested logic change.
10.2.6 Unconnected Pins
If some pins are unused, it is recommended to ensure that these pins have a defined level. Even though most of the
digital inputs are disabled in the deep sleep modes as described above, floating inputs should be avoided to reduce
current consumption in all other modes where the digital inputs are enabled (Reset, Active mode and Idle mode).
The simplest method to ensure a defined level of an unused pin, is to enable the internal pull-up. In this case, the pull-up
will be disabled during reset. If low power consumption during reset is important, it is recommended to use an external
pull-up or pulldown. Connecting unused pins directly to VCC or GND is not recommended, since this may cause
excessive currents if the pin is accidentally configured as an output.
out PORTx, r16
nop
in r17, PINx
0xFF
0x00
0xFF
SYSTEM CLK
r16
INSTRUCTIONS
SYNC LATCH
PINxn
r17
t
pd
相关PDF资料 |
PDF描述 |
|---|---|
| S80C52EXXX-20SHXXX:D | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, PQCC44 |
| SCC9521002-01C | 8-BIT, 30 MHz, MICROCONTROLLER, CDIP40 |
| S80C52XXX-12D | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQCC44 |
| S80C32E-40SHXXX:RD | 8-BIT, 40 MHz, MICROCONTROLLER, PQCC44 |
| S80C52TXXX-12 | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQCC44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SJ81200 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| SJ83100 | 制造商:ON Semiconductor 功能描述:SJ83100 - Trays 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| SJ83180 | 制造商:ON Semiconductor 功能描述:NPN TO-3 METAL PWR TRANSISTOR - Trays 制造商:Rochester Electronics LLC 功能描述:NPN TO-3 METAL PWR TRANSISTOR - Bulk |
| SJ84140 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| SJ-870 | 制造商:NEL 制造商全称:Nel Frequency Controls,inc 功能描述:CRYSTAL CLOCK OSCILLATORS |
发布紧急采购，3分钟左右您将得到回复。