- 您现在的位置：买卖IC网 > PDF目录98142 > SST55LC100-45-C-BWE FLASH MEMORY DRIVE CONTROLLER, PBGA84 PDF资料下载
参数资料
| 型号： | SST55LC100-45-C-BWE |
| 元件分类： | 存储控制器/管理单元 |
| 英文描述： | FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
| 封装： | ROHS COMPLIANT, MO-210, TFBGA-84 |
| 文件页数： | 13/80页 |
| 文件大小： | 758K |
| 代理商： | SST55LC100-45-C-BWE |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页
20
Advance Information
CompactFlash Card Controller
SST55LC100
2005 Silicon Storage Technology, Inc.
S71298-00-000
10/05
Changed
Indicates that one or both of the Pin Replacement register CRdy or CWProt bits are set
to one (1). When the Changed bit is set, Pin 46 (STSCHG#) is held low if the SigChg bit
is a One (1) and the CompactFlash card is configured for the I/O interface.
SigChg
This bit is set and reset by the host to enable and disable a state-change “signal” from
the Status register, the Changed bit control pin 46 the Changed Status signal. If no state
change signal is desired, this bit should be set to zero (0) and pin 46 (STSCHG#) signal
will be held high while the CompactFlash card is configured for I/O.
IOis8
The host sets this bit to a one (1) if the CompactFlash card is to be configured in an 8-bit
I/O mode. The CompactFlash card is always configured for both 8- and 16-bit I/O, so this
bit is ignored.
XE#:
This bit has value 0 and is not writeable.
Audio:
This bit should always be zero for CompactFlash cards.
PwrDwn
This bit indicates whether the host requests the CompactFlash card to be in the power
saving or active mode. When the bit is one (1), the CompactFlash card enters a power
down mode. When zero (0), the host is requesting the CompactFlash card to enter the
active mode. The PCMCIA Ready value becomes BUSY when this bit is changed.
Ready will not become ready until the power state requested has been entered. The
CompactFlash card automatically powers down when it is idle and powers back up when
it receives a command.
Int
This bit represents the internal state of the interrupt request. This value is available
whether or not I/O interface has been configured. This signal remains true until the
condition which caused the interrupt request has been serviced. If interrupts are
disabled by the -IEn bit in the Device Control register, this bit is a zero (0).
TABLE
8-4: CARD CONFIGURATIONS
Conf5
Conf4
Conf3
Conf2
Conf1
Conf0
Disk Card Mode
0
Memory Mapped
0
1
I/O Mapped, any 16 Byte system
decoded boundary
0
1
0
I/O Mapped, 1F0H-1F7H/3F6H-3F7H
0
1
I/O Mapped, 170H-177H/376H-377H
T8-4.0 1298
TABLE
8-5: CARD CONFIGURATION AND STATUS REGISTER ORGANIZATION
Operation
D7
D6
D5D4
D3D2D1D0
Read
Changed
SigChg
IOis8
XE#
Audio
PwrDwn
Int
0
Write
0
SigChg
IOis8
XE#
Audio
PwrDwn
0
相关PDF资料 |
PDF描述 |
|---|---|
| SST55LC100M-45-C-BWE | IDE COMPATIBLE, FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
| SST55LD017D-40-C-TQWE | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| SST55LD017D-40-I-TQW | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| SST55LD019A-45-C-TQPE | FLASH MEMORY DRIVE CONTROLLER, PQFP64 |
| SST55LD019C-45-I-BWE | FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SST55LC100-45-C-TQWE | 功能描述:总线收发器 Compact Flash Card Controller RoHS:否 制造商:Fairchild Semiconductor 逻辑类型:CMOS 逻辑系列:74VCX 每芯片的通道数量:16 输入电平:CMOS 输出电平:CMOS 输出类型:3-State 高电平输出电流:- 24 mA 低电平输出电流:24 mA 传播延迟时间:6.2 ns 电源电压-最大:2.7 V, 3.6 V 电源电压-最小:1.65 V, 2.3 V 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-48 封装:Reel |
| SST55LC100-45-I-BWE | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:CompactFlash Card Controller |
| SST55LC100-45-I-TQWE | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:CompactFlash Card Controller |
| SST55LC100M | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:CompactFlash Card Controller |
| SST55LC100M-45-C-BWE | 功能描述:总线收发器 Compact Flash 45MHz 3.3V Commercial RoHS:否 制造商:Fairchild Semiconductor 逻辑类型:CMOS 逻辑系列:74VCX 每芯片的通道数量:16 输入电平:CMOS 输出电平:CMOS 输出类型:3-State 高电平输出电流:- 24 mA 低电平输出电流:24 mA 传播延迟时间:6.2 ns 电源电压-最大:2.7 V, 3.6 V 电源电压-最小:1.65 V, 2.3 V 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-48 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。