参数资料
型号: TC253SPD-B0
厂商: TEXAS INSTRUMENTS INC
元件分类: 模拟信号调理
英文描述: SPECIALTY ANALOG CIRCUIT, CDIP22
封装: 1.78 MM PITCH, WINDOWED, CERAMIC, DIP-22
文件页数: 2/23页
文件大小: 363K
代理商: TC253SPD-B0
TC253SPDB0
680 × 500 PIXEL IMPACTRON CCD IMAGE SENSOR
JULY 2003 SOCS084
10
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
optical characteristics, TA = 25°C (unless otherwise noted)
PARAMETER
MIN
TYP
MAX
UNIT
Sensitivity with typical CCM gain (see Note 12)
No IR filter
290
V/Lx*s
Sensitivity with typical CCM gain (see Note 12)
With IR filter
36
V/Lx*s
Sensiti it
itho t CCM gain (see Note 12)
No IR filter
9.6
V/L *s
Sensitivity without CCM gain (see Note 12)
With IR filter
1.2
V/Lx*s
Vsat
Saturation signal output without CCM gain (see Note 13)
300
400
mV
Handling capacity of charge multiplier
400
500
Voff
Zero-input offset output (see Note 14)
90
200
mV
Blooming overload ratio (see Note 15)
1000:1
Image area well capacity
33k
44k
e-/pixel
Smear (see Note 16)
60
dB
Dark current (see Note 17 and Note 22)
0.01
0.03
nA/cm2
Dark signal (see Note 18 and Note 22)
0.005
0.015
mV
Dark-signal uniformity (see Note 19)
0.15
mV
Dark-signal shading (see Note 20)
0.1
mV
Spurious nonuniformity
Dark
0.8
1.5
mV
Spurious nonuniformity
Illuminated
20
20
%
Column uniformity (see Note 21)
4.5
mV
Electronic-shutter capability
1/5000
1/30
s
NOTES: 12. Light source temperature is 2856
°K. The IR filter used is CM500, 1-mm thick.
13. Saturation is the condition in which further increase in exposure does not lead to further increases in output signal.
14. Zero-input offset is the residual output signal measured from the reset level with no input charge present. This level is not caused
by the dark current and remains approximately constant, independent of temperature. It may vary with the amplitude of SRG.
15. Blooming is the condition in which charge induced by light in one element spills over to the neighboring elements.
16. Smear is the measure of error signal introduced into the pixels by transferring them through the illuminated region into the memory.
The illuminated region is 1/10 of the image area height. The value in the table is obtained for an integration time of 16.66 ms and
a 3.125-MHz vertical-clock transfer frequency.
17. Dark current depends on temperature and approximately doubles every 8 oC. Dark current is also multiplied by CCM operation. The
value given in the table is with the multiplier turned off and it is a calculated value.
18. Dark signal is actual device output measured in darkness.
19. Dark signal uniformity is the sigma of the difference between two neighboring pixels taking from all the image area pixels.
20. Dark signal shading is the difference between maximum and minimum of a 5-pixel median taken anywhere in the array.
21. Column uniformity is obtained by summing all the lines in the array, finding the maximum of the difference between two neighboring
columns anywhere in the array, and dividing the result by the number of lines.
22. There will be an estimated 20% degradation in dark current performance when exposed to 320 nm UV light at 1 uWatt/cm2 for
2700 hours.
相关PDF资料
PDF描述
TC255 SPECIALTY ANALOG CIRCUIT, CDIP8
TC2574-VOETR 1.8 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PDSO16
TC2575-12.0VAT 3.2 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PSFM5
TC271-40 SPECIALTY ANALOG CIRCUIT, CDIP22
TC33025VOETR 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
相关代理商/技术参数
参数描述
TC254 制造商:Cooper Wiring Devices 功能描述:
TC2540 功能描述:铝质电解电容器 - 带引线 4000uF 25Volts RoHS:否 制造商:Kemet 引线类型: 电容:220 uF 容差:20 % 电压额定值:25 V 工作温度范围: 端接类型:Radial 外壳直径:8 mm 外壳长度:11 mm 引线间隔:5 mm 产品:General Purpose Electrolytic Capacitors 封装:Bulk
TC2540A 制造商:CDE 制造商全称:Cornell Dubilier Electronics 功能描述:Axial Leaded Aluminum Electrolytic Capacitors
TC254P 制造商:Texas Instruments 功能描述:
TC255 制造商:TI 制造商全称:Texas Instruments 功能描述:336- 】 244-pixel ccd image sensor