- 您现在的位置：买卖IC网 > PDF目录98229 > THS7365IPW (TEXAS INSTRUMENTS INC) 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 PDF资料下载
参数资料
| 型号： | THS7365IPW |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| 封装： | PLASTIC, TSSOP-20 |
| 文件页数： | 33/52页 |
| 文件大小： | 1599K |
| 代理商： | THS7365IPW |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页当前第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页
OUTPUT MODE OF OPERATION:
www.ti.com.................................................................................................................................................................................................. SBOS467 – MARCH 2009
There are many reasons dc-coupling is desirable,
In the same way as the dc output mode of operation
including reduced costs, PCB area, and no line tilt. A
discussed previously, each line should have a 75-
common question is whether or not there are any
source
termination
resistor
in
series
with
the
drawbacks to using dc-coupling. There are some
ac-coupling capacitor. This 75-
resistor should be
potential issues that must be examined, such as the
placed next to the THS7365 output to minimize
dc current bias as discussed above. Another potential
capacitive loading effects. If two lines are to be
risk is whether this configuration meets industry
driven, it is best to have each line use its own
standards. EIA-770 stipulates that the back-porch
capacitor and resistor rather than sharing these
shall be 0 V ± 1 V as measured at the receiver. With
components.
This
configuration
helps
ensure
a double-terminated load system, this requirement
line-to-line dc isolation and eliminates the potential
implies a 0 V ± 2 V level at the video amplifier output.
problems as described previously. Using a single,
The THS7365 can easily meet this requirement
1000-
F capacitor for two lines is permissible, but
without issue. However, in Japan, the EIAJ CP-1203
there is a chance for interference between the two
specification stipulates a 0 V ± 0.1 V level with no
receivers.
signal. This requirement can be met with the
Lastly, because of the edge rates and frequencies of
THS7365 in shutdown mode, but while active it
operation, it is recommended (but not required) to
cannot
meet
this
specification
without
output
place a 0.1-
F to 0.01-F capacitor in parallel with
ac-coupling.
AC-coupling
the
output
essentially
the large 220-
F to 1000-F capacitor. These large
ensures that the video signal works with any system
value capacitors are most commonly aluminum
and any specification. For many modern systems,
electrolytic. It is well-known that these capacitors
however, dc-coupling can satisfy most needs.
have significantly large equivalent series resistance
(ESR), and the impedance at high frequencies is
rather large as a result of the associated inductances
AC-COUPLED
involved with the leads and construction. The small
0.1-
F to 0.01-F capacitors help pass these
A very common method of coupling the video signal
high-frequency signals (greater than 1 MHz) with
to the line is with a large capacitor. This capacitor is
much lower impedance than the large capacitors.
typically between 220
F and 1000 F, although 470
F is very typical. The value of this capacitor must be
Although it is common to use the same capacitor
large enough to minimize the line tilt (droop) and/or
values for all the video lines, the frequency bandwidth
field tilt associated with ac-coupling as described
of the chroma signal in a S-Video system is not
previously
in
this
document.
AC-coupling
is
required to go as low (or as high of a frequency) as
performed for several reasons, but the most common
the luma channels. Thus, the capacitor values of the
is to ensure full interoperability with the receiving
chroma line(s) can be smaller, such as 0.1
F.
video system. This approach ensures that regardless
of the reference dc voltage used on the transmitting
side,
the
receiving
side
re-establishes
the
dc
reference voltage to its own requirements.
Copyright 2009, Texas Instruments Incorporated
39
Product Folder Link(s): THS7365
相关PDF资料 |
PDF描述 |
|---|---|
| THS7368IPWR | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7368IPW | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7372IPWR | 4 CHANNEL, VIDEO AMPLIFIER, PDSO14 |
| THS7372IPW | 4 CHANNEL, VIDEO AMPLIFIER, PDSO14 |
| THS7374IPWR | 4 CHANNEL, VIDEO AMPLIFIER, PDSO14 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| THS7365IPWR | 功能描述:视频放大器 6Ch Video Amp RoHS:否 制造商:ON Semiconductor 通道数量:4 电源类型: 工作电源电压:3.3 V, 5 V 电源电流: 最小工作温度: 最大工作温度: 封装 / 箱体:TSSOP-14 封装:Reel |
| THS7368 | 制造商:TI 制造商全称:Texas Instruments 功能描述:6-Channel Video Amplifier with 3-SD and 3-SD/ED/HD/Full-HD Filters and 6-dB Gain |
| THS7368EVM | 功能描述:放大器 IC 开发工具 THS7368EVM Eval Mod RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
| THS7368IPW | 功能描述:视频放大器 6-Ch Video Amp RoHS:否 制造商:ON Semiconductor 通道数量:4 电源类型: 工作电源电压:3.3 V, 5 V 电源电流: 最小工作温度: 最大工作温度: 封装 / 箱体:TSSOP-14 封装:Reel |
| THS7368IPW | 制造商:Texas Instruments 功能描述:Video Amplifier IC 制造商:Texas Instruments 功能描述:IC, VIDEO AMPLIFIER, HEX, 350MHZ TSSOP20 |
发布紧急采购，3分钟左右您将得到回复。