- 您现在的位置：买卖IC网 > PDF目录136905 > TSC87C52-20IAD (ATMEL CORP) 8-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PDIP40 PDF资料下载
参数资料
| 型号： | TSC87C52-20IAD |
| 厂商： | ATMEL CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PDIP40 |
| 封装： | PLASTIC, DIP-40 |
| 文件页数： | 11/46页 |
| 文件大小： | 4720K |
| 代理商： | TSC87C52-20IAD |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页
18
ATtiny20 [DATASHEET]
8235E–AVR–03/2013
6.1.4
ADC Clock – clk
ADC
The ADC is provided with a dedicated clock domain. This allows halting the CPU and I/O clocks in order to reduce noise
generated by digital circuitry. This gives more accurate ADC conversion results.
6.2
Clock Sources
All synchronous clock signals are derived from the main clock. The device has three alternative sources for the main
clock, as follows:
External Clock (see page 18)
See Table 6-3 on page 21 on how to select and change the active clock source.
6.2.1
Calibrated Internal 8 MHz Oscillator
The calibrated internal oscillator provides an approximately 8 MHz clock signal. Though voltage and temperature
dependent, this clock can be very accurately calibrated by the user. See Table 20-2 on page 169, and “Internal Oscillator
Speed” on page 200 for more details.
This clock may be selected as the main clock by setting the Clock Main Select bits CLKMS[1:0] in CLKMSR to 0b00.
Once enabled, the oscillator will operate with no external components. During reset, hardware loads the calibration byte
into the OSCCAL register and thereby automatically calibrates the oscillator. The accuracy of this calibration is shown as
Factory calibration in Table 20-2 on page 169.
When this oscillator is used as the main clock, the watchdog oscillator will still be used for the watchdog timer and reset
time-out. For more information on the pre-programmed calibration value, see section “Calibration Section” on page 162.
6.2.2
External Clock
To use the device with an external clock source, CLKI should be driven as shown in Figure 6-2. The external clock is
selected as the main clock by setting CLKMS[1:0] bits in CLKMSR to 0b10.
Figure 6-2.
External Clock Drive Configuration
When applying an external clock, it is required to avoid sudden changes in the applied clock frequency to ensure stable
operation of the MCU. A variation in frequency of more than 2% from one clock cycle to the next can lead to
unpredictable behavior. It is required to ensure that the MCU is kept in reset during such changes in the clock frequency.
6.2.3
Internal 128 kHz Oscillator
The internal 128 kHz oscillator is a low power oscillator providing a clock of 128 kHz. The frequency depends on supply
voltage, temperature and batch variations. This clock may be select as the main clock by setting the CLKMS[1:0] bits in
CLKMSR to 0b01.
EXTERNAL
CLOCK
SIGNAL
CLKI
GND
相关PDF资料 |
PDF描述 |
|---|---|
| TSC87C52-25AKB | 8-BIT, UVPROM, 25 MHz, MICROCONTROLLER, CQCC44 |
| TSC80C31-20MXR | 8-BIT, 20 MHz, MICROCONTROLLER, UUC40 |
| TSC80C31-25MWB/883 | 8-BIT, 25 MHz, MICROCONTROLLER, UUC40 |
| TSC80C51-12MXR | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, UUC40 |
| TSC80C51-20MWR/883 | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, UUC40 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSC888AILT | 功能描述:电流灵敏放大器 Sense Amplifier 20 Gain RoHS:否 制造商:Texas Instruments 通道数量: 共模抑制比（最小值）:110 dB 输入补偿电压:80 uV 电源电压-最大:5.5 V 电源电压-最小:2.7 V 电源电流:350 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-16 封装:Reel |
| TSC888BILT | 功能描述:电流灵敏放大器 Sense Amplifier 50 Gain RoHS:否 制造商:Texas Instruments 通道数量: 共模抑制比（最小值）:110 dB 输入补偿电压:80 uV 电源电压-最大:5.5 V 电源电压-最小:2.7 V 电源电流:350 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-16 封装:Reel |
| TSC888CILT | 功能描述:电流灵敏放大器 Sense Amplifier 100 Gain RoHS:否 制造商:Texas Instruments 通道数量: 共模抑制比（最小值）:110 dB 输入补偿电压:80 uV 电源电压-最大:5.5 V 电源电压-最小:2.7 V 电源电流:350 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-16 封装:Reel |
| TSC9 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:EURO TERMINAL BLOCKS |
| TSC903 | 制造商:Laird Technologies Inc 功能描述:CLIP TO-3P 制造商:Laird Technologies Inc 功能描述:CLIP, TO-3P 制造商:Laird Technologies Inc 功能描述:CLIP, TO-3P; External Width:6.5mm; SVHC:No SVHC (18-Jun-2012); Isolation Voltage:1kV; Length:30mm; Material:Steel; Package / Case:TO-3P, TO-218, TO-247; Packages Cooled:TO-3P, TO-218, TO-247; Pad Thickness Max:0.5mm; Panel Thickness ;RoHS Compliant: Yes 制造商:Laird Technologies Inc 功能描述:CLIP, TO-3P; External Width:6.5mm; SVHC:No SVHC (18-Jun-2012); Isolation Voltage:1kV; Length:30mm; Material:Steel; Package / Case:TO-3P, TO-218, TO-247; Packages Cooled:TO-218, TO-247, TO-3P; Pad Thickness Max:0.5mm; Panel Thickness ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。