- 您现在的位置：买卖IC网 > PDF目录1971 > VNC2-64Q1B-TRAY (FTDI, Future Technology Devices International Ltd)IC USB HOST/DEVICE CTRL 64-QFN PDF资料下载
参数资料
| 型号： | VNC2-64Q1B-TRAY |
| 厂商： | FTDI, Future Technology Devices International Ltd |
| 文件页数： | 61/88页 |
| 文件大小： | 0K |
| 描述： | IC USB HOST/DEVICE CTRL 64-QFN |
| 应用说明： | Vinculum-II IO Cell Description AppNote Vinculum-II Debug Interface Description AppNote Vinculum-II IO Mux Explained AppNote Vinculum-II PWM Example AppNote Migrating Vinculum Designs AppNote |
| 标准包装： | 260 |
| 系列： | Vinculum-II |
| 控制器类型： | USB 2.0 控制器 |
| 接口： | USB，主机/设备配置，UART，SPI，PWM，闪存 256K，DMA 4CH |
| 电源电压： | 1.62 V ~ 1.98 V |
| 电流 - 电源： | 25mA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-VFQFN 裸露焊盘 |
| 供应商设备封装： | 64-QFN（8x8） |
| 包装： | 托盘 |
| 其它名称： | VNC2-64Q1A-TRAY VNC2-64Q1A-TRAY-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页当前第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页
64
Copyright 2009-2011 Future Technology Devices International Limited
Datasheet
Vinculum-II Embedded Dual USB Host Controller IC
Version 1.5
Document No.: FT_000138 Clearance No.: FTDI# 143
Generation of up to 4-pulse signal with controlled output enable and configurable initial state
Interrupt
A single PWM cycle can have up to 4 pulses (8 edges). The PWM block uses a 16-bit counter to
determine the period of a single PWM cycle. This counter counts system clocks which can also be divided
by an optional 8-bit prescaler. The PWM drivers allow the user to select when PWM output toggles. These
values correspond to the values of 16-bit counter. For example, on the timing diagram below - Figure
6.24, the 16-bit counter counts to 23 and pwm_out[0] output toggles when the counters current value is
equal to 7, 8, 12, 14, 15, 16, 19 and 22.
Figure 6.24 PWM – Timing Diagram
The user can also select the initial state of each of the PWM outputs (HI or LOW). PWM outputs can also
be enabled continuously or a cycle can be repeated 1..255 times. The PWM cycle can be started by the
PWM driver or externally using a trigger input.
6.10 General Purpose Input Output
VNC2 provides up to 40 configurable Input/Output pins depending on the package. The Input/Output pins
are connected to Ports A through E. These ports are controlled by the VNC2 CPU. All ports are
configurable to be either inputs or outputs and allow level or edge driven interrupts to be generated.
To simplify the use of the 40 available GPIO signals, they have been grouped into 5 "ports", identified as
A, B, C, D and E. Each port is 1 byte wide and the RTOS drivers will allow each port to be individually
accessed.
Each GPIO signal is mapped on to a bit of the port value. For example, gpio[A0] is the least significant
bit of the value read from or written to GPIO port A. Similarly, gpio[A7] is the most significant bit of the
value read from or written to GPIO port A (see Figure 6.25 GPIO Port Groups)
Each pin can be individually configured as input or output. GPIO port A supports an interrupt that can be
used to detect a state change of any of its 8 pins. Port B features a more sophisticated set of 4
configurable interrupts that can be associated with individual pins and supports several conditions such
as positive edge, negative edge, high or low.
PORT A
gpio[A0]
gpio[A1]
gpio[A2]
gpio[A3]
gpio[A4]
gpio[A5]
gpio[A7]
gpio[A6]
PORT B
gpio[B0]
gpio[B1]
gpio[B2]
gpio[B3]
gpio[B4]
gpio[B5]
gpio[B7]
gpio[B6]
PORT C
gpio[C0]
gpio[C1]
gpio[C2]
gpio[C3]
gpio[C4]
gpio[C5]
gpio[C7]
gpio[C6]
PORT D
gpio[D0]
gpio[D1]
gpio[D2]
gpio[D3]
gpio[D4]
gpio[D5]
gpio[D7]
gpio[D6]
PORT E
gpio[E0]
gpio[E1]
gpio[E2]
gpio[E3]
gpio[E4]
gpio[E5]
gpio[E7]
gpio[E6]
Figure 6.25 GPIO Port Groups
相关PDF资料 |
PDF描述 |
|---|---|
| W78E858A40FL | IC MCU 8-BIT 32K FLASH 44-PQFP |
| W83303AG | IC ACPI CONTROLLER 48-LQFP |
| W83627UHG | IC I/O CONTROLLER 128-QFP |
| W83L951DG | IC EMBEDDED CNTRLR 128-LQFP |
| X90100M8IZT1 | IC DIGITAL CAPACITOR NV 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| VNC2DEBUGMODULE | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:VNC2 Vinculum Debug Module |
| VNC712B-N50A-5TZ | 制造商:SMC Corporation of America 功能描述:Valve, media, coolant, 2 way |
| VNC-DK4-C1404CM | 制造商:L-com Inc 功能描述:4CH DVR w/4 CMOS CAMERAS no HD |
| VNC-DK4-C1404CM-HD | 制造商:L-com Inc 功能描述:4CH DVR w/4 CMOS CAMS 500GB HD |
| VNC-DK4-C2404CM | 制造商:L-com Inc 功能描述:4CH DVR w/4 CMOS CAMERAS no HD |
发布紧急采购，3分钟左右您将得到回复。