参数资料
型号: ZY7007LG-T3
厂商: Power-One
文件页数: 29/35页
文件大小: 0K
描述: PROGBL CONVERT DC-DC 7A OUT SMD
特色产品: ZY Series Converters
标准包装: 1
系列: 智能 POL 转换器
类型: 非隔离(POL)
输出数: 1
电压 - 输入(最小): 3V
电压 - 输入(最大): 14V
Voltage - Output 1: 0.5 ~ 5.5 V
电流 - 输出(最大): 7A
电源(瓦) - 制造商系列: 38W
安装类型: 表面贴装
封装/外壳: 36-DIP SMD 模块
尺寸/尺寸: 0.87" L x 0.49" W x 0.26" H(22.2mm x 12.5mm x 6.5mm)
包装: 标准包装
工作温度: -40°C ~ 85°C
电源(瓦特)- 最大: 38.5W
产品目录页面: 2739 (CN2011-ZH PDF)
其它名称: 179-2410-6
ZY7007 7A DC-DC Intelligent POL Data Sheet
3V to 14V Input ? 0.5V to 5.5V Output
8.5
Current Share
8.6
Performance Parameters Monitoring
The POL converters are equipped with the digital
current share function. To activate the current share,
interconnect the CS pins of the POLs connected in
parallel. The digital signal transmitted over the CS
line sets output currents of all POLs to the same
level.
When POLs are connected in parallel, they must be
included in the same parallel bus in the GUI System
Configuration window shown in Figure 53. In this
case, the GUI automatically copies parameters of
one POL onto all POLs connected to the parallel
bus. It makes it impossible to configure different
performance parameters for POLs connected in
parallel except for interleave and load regulation
settings that are independent. The interleave allows
to reduce and move the output noise of the
converters connected in parallel to higher
frequencies as shown in Figure 49 and Figure 50.
The load regulation allows controlling the current
share loop gain in case of small signal oscillations. It
is recommended to always add a small amount of
load regulation to one of the converters connected in
parallel to reduce loop gain and therefore improve
stability.
The POL converters can monitor their own
performance parameters such as output voltage,
output current, and temperature.
The output voltage is measured at the output sense
pins, output current is measured using the ESR of
the output inductor and temperature is measured by
the thermal sensor built into the controller IC. Output
current readings are adjusted based on temperature
readings to compensate for the change of ESR of
the inductor with temperature.
An 8-Bit Analog to Digital Converter (ADC) converts
the output voltage, output current, and temperature
into a digital signal to be transmitted via the serial
interface. The ADC allows a minimum sampling
frequency of 1 kHz for all three values.
Monitored parameters are stored in registers (VOM,
IOM, and TMON) that are continuously updated. If
the Retrieve Monitoring bits in the GUI Group
Configuration window shown in Figure 54 are
checked, those registers are being copied into the
ring buffer located in the DPM. Contents of the ring
buffer can be displayed in the GUI IBS Monitoring
Window shown in Figure 55 or it can be read directly
via the I 2 C bus using high and low level commands
as described in the ‘”DPM Programming Manual”.
ZD-00245 Rev. 2.6, 01-Jul-10
www.power-one.com
Page 29 of 35
相关PDF资料
PDF描述
VI-23B-CY-F1 CONVERTER MOD DC/DC 95V 50W
MAX7503MSA+T IC TEMP SENSOR DIGIT 8-SOIC
ADSP-BF514KBCZ-4 IC DSP 16/32B 400MHZ 168CSPBGA
VI-233-CY-F3 CONVERTER MOD DC/DC 24V 50W
LSM2-T/6-D12-C CONV DC/DC 30W 6A 12V SMD
相关代理商/技术参数
参数描述
ZY7007L-T3 制造商:Power-One 功能描述:- Tape and Reel
ZY7007LU-Q1 制造商:POWER-ONE 制造商全称:Power-One 功能描述:7A DC-DC Intelligent POL 3V to 14V Input - 0.5V to 5.5V Output
ZY7007LU-T1 制造商:POWER-ONE 制造商全称:Power-One 功能描述:7A DC-DC Intelligent POL 3V to 14V Input - 0.5V to 5.5V Output
ZY7007LU-T2 制造商:POWER-ONE 制造商全称:Power-One 功能描述:7A DC-DC Intelligent POL 3V to 14V Input - 0.5V to 5.5V Output
ZY7007LU-T3 制造商:POWER-ONE 制造商全称:Power-One 功能描述:7A DC-DC Intelligent POL 3V to 14V Input - 0.5V to 5.5V Output