- 您现在的位置：买卖IC网 > PDF目录18714 > 4460-TCE10D434-EK (Silicon Laboratories Inc)KIT EZRADIO TEST CARD SI4460 TX PDF资料下载
参数资料
| 型号： | 4460-TCE10D434-EK |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 34/56页 |
| 文件大小： | 0K |
| 描述： | KIT EZRADIO TEST CARD SI4460 TX |
| 设计资源： | 4460-TCE10D434 BOM 4460-TCE10D434 PCB 4460-TCE10D434 SCH |
| 标准包装： | 1 |
| 系列： | EZRadioPRO® |
| 类型： | 收发器，ISM |
| 频率： | 434MHz |
| 适用于相关产品： | Si4460 |
| 已供物品： | 板 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页当前第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页
Si4464/63/61/60
6. Program the RSSI threshold property in the modem using “MODEM_RSSI_THRESH”.
7. Set the preamble threshold using “PREAMBLE_CONFIG_STD_1”.
8. Program the preamble timeout property using “PREAMBLE_CONFIG_STD_2”.
9. Set the sync detection parameters if enabled.
10. If needed, use “GPIO_PIN_CFG” to configure a GPIO to toggle on hop and hop table wrap.
11. Use the “START_RX” API with channel number set to the first valid entry in the hop table (i.e., the first non
0xFF entry).
12. Device should now be in auto hop mode.
5.3.1.3. Manual RX Hopping
The RX_HOP command provides the fastest method for hopping from RX to RX but it requires more overhead and
management by the host MCU. Using the RX_HOP command, the turn-around time is 75 μs. The timing is faster
with this method than Start_RX or RX hopping because one of the calculations required for the synthesizer
calibrations is offloaded to the host and must be calculated/stored by the host, VCO_CNT0. For information about
using fast manual hopping, contact customer support.
5.4. Transmitter (TX)
The Si4464/63 contains an integrated +20 dBm transmitter or power amplifier that is capable of transmitting from
–20 to +20 dBm. The output power steps are less than 0.25 dB within 6 dB of max power but become larger and
more non-linear close to minimum output power. The Si4464/63 PA is designed to provide the highest efficiency
and lowest current consumption possible. The Si4461 PA is capable of transmitting from –40 to +16 dBm. The
Si4461 PA can be optimized for either optimum current consumption (Class E) or for fine output power steps and
performance over voltage and temperature (switched-current). Switched-current matching will have fine output
power steps and more constant output power over VDD, but it will have higher current consumption than the
class-E matching. The class E will have the most efficient current consumption, but it will have more coarse output
power steps and variation across VDD. The Si4460 is designed to supply +10 dBm output power for less than
20 mA for applications that require operation from a single coin cell battery. The Si4460 can also operate with
either class-E or switched current matching and output up to +13 dBm Tx power. All PA options are single-ended to
allow for easy antenna matching and low BOM cost. Automatic ramp-up and ramp-down is automatically
performed to reduce unwanted spectral spreading.
Chip’s TXRAMP pin is disabled by default to save current in cases where on-chip PA will be able to drive the
antenna. In cases where on-chip PA will drive the external PA, and the external PA needs a ramping signal,
TXRAMP is the signal to use. To enable TXRAMP, set the API Property PA_MODE[7] = 1. TXRAMP will start to
ramp up, and ramp down at the SAME time as the internal on-chip PA ramps up/down.
The ramping speed is programmed by TC[3:0] in the PA_RAMP_EX API property, which has the following
characteristics:
34
TC
0.0
1.0
2.0
3.0
4.0
5.0
6.0
7.0
8.0
Ramp Time (μs)
2.0
2.1
2.2
2.4
2.6
2.8
3.1
3.4
3.7
Rev 1.2
相关PDF资料 |
PDF描述 |
|---|---|
| SI4844-DEMO | SI4844 EVAL AND DEMO BOARD |
| GSEB01D | SWITCH ROTARY SIDE |
| ATAKSTK511-8 | KIT RF MODULE 868MHZ FOR STK500 |
| XT09-DK | KIT DEVELOPMENT 900MHZ |
| ATAKSTK511-9 | KIT RF MODULE 915MHZ FOR STK500 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 4460-TCE10D868-EK | 功能描述:射频开发工具 4460 10 dBm 868MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 446-0X | 制造商:Apex Tool Group 功能描述:HEX BIT PHILLIPS #0X25MM TOOL STEEL 制造商:APEX 功能描述:HEX BIT, PHILLIPS, #0X25MM, TOOL STEEL 制造商:APEX 功能描述:HEX BIT, PHILLIPS, #0X25MM, TOOL STEEL; Bit Type:Phillips; Hex Bit Size:#0; Length:25mm; Size:1" ;RoHS Compliant: NA |
| 4461 | 功能描述:电缆固定件和配件 PG16 HYBRID CG 1.48X1.10 .39-.67 RoHS:否 制造商:Heyco 类型:Cable Grips, Liquid Tight 材料:Nylon 颜色:Black 安装方法:Cable 最大光束直径:11.4 mm 抗拉强度: |
| 44-610 | 制造商:RAWLPLUG 功能描述:RAWLBOLT PROJECTING M1030P 制造商:RAWLPLUG 功能描述:RAWLBOLT, PROJECTING, M1030P |
| 44610 | 制造商:3-IN-ONE 功能描述:3IN1 SILICONE SPRAY, 400ML |
发布紧急采购，3分钟左右您将得到回复。