收藏本站
参数资料
型号： 91C100FDREVB
厂商： SMSC Corporation
英文描述： FEAST FAST ETHERNET CONTROLLER WITH FULL DUPLEX CAPABILITY
中文描述： 宴快速以太网控制器以全双工能力
文件页数： 14/68页
文件大小： 423K
代理商： 91C100FDREVB
SMSC DS – LAN91C100FD REV. B
Page 21
Rev. 05/31/2000
EXC_DEF - Excessive Deferral. When set last/ current transmit was deferred for more than 1518 * 2 byte times. Cleared at
the end of every packet sent.
LOST_CARR - Lost Carrier Sense. When set indicates that Carrier Sense was not present at end of preamble. Valid only if
MON_CSN is enabled. This condition causes TXENA bit in TCR to be reset. Cleared by setting TXENA bit in TCR.
LATCOL - Late collision detected on last transmit frame. If set a late collision was detected (later than 64 byte times into the
frame). When detected the transmitter jams and turns itself off clearing the TXENA bit in TCR. Cleared by setting TXENA in
TCR.
TX_DEFR - Transmit Deferred. When set, carrier was detected during the first 6.4
s of the inter frame gap. Cleared at the
end of every packet sent.
LTX_BRD - Last transmit frame was a broadcast. Set if frame was broadcast. Cleared at the start of every transmit frame.
SQET - Signal Quality Error Test. In MII, SQET bit is always set after first transmit, except if SWFDUP=1. As a
consequence, the STP_SQET bit in the TCR register cannot be set as it will always result in transmit fatal error. In non-MII
systems, the transmitter opens a 1.6
s window 0.8 s after transmission is completed and the receiver returns inactive.
During this window, the transmitter expects to see the SQET signal from the transceiver. The absence of this signal is a
'Signal Quality Error' and is reported in this status bit. Transmission stops and EPH INT is set if STP_SQET is in the TCR is
also set when SQET is set. This bit is cleared by setting TXENA high.
16COL
- 16 collisions reached. Set when 16 collisions are detected for a transmit frame. TXENA bit in TCR is reset.
Cleared when TXENA is set high.
LTX_MULT - Last transmit frame was a multicast. Set if frame was a multicast. Cleared at the start of every transmit
frame.
MULCOL - Multiple collision detected for the last transmit frame. Set when more than one collision was experienced.
Cleared when TX_SUC is high at the end of the packet being sent.
SNGLCOL - Single collision detected for the last transmit frame. Set when a collision is detected. Cleared when TX_SUC is
high at the end of the packet being sent.
TX_SUC
- Last transmit was successful. Set if transmit completes without a fatal error. This bit is cleared by the start of a
new frame transmission or when TXENA is set high. Fatal errors are:
16 collisions (1/2 duplex mode only)
SQET fail and STP_SQET = 1 (1/2 duplex mode only)
FIFO Underrun
Carrier lost and MON_CSN = 1 (1/2 duplex mode only)
Late collision (1/2 duplex mode only)
相关PDF资料
PDF描述
91C94 ISA/PCMCIA SINGLE CHIP ETHERNET CONTROLLER WITH RAM
92_TNC-50-0-4/111_NE BOARD TERMINATED, FEMALE, TNC CONNECTOR, SURFACE MOUNT, JACK
92_TNC-50-0-4/111_NM BOARD TERMINATED, FEMALE, TNC CONNECTOR, SURFACE MOUNT, JACK
92082-314 14 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
92082-316 16 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
相关代理商/技术参数
参数描述
91C100GTQFP 制造商:Rochester Electronics LLC 功能描述:- Bulk
91C100QFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMSC 功能描述:
91C15JC353 制造商:STM 功能描述:CGB015X335C
91C1A-A24-A13/A15 制造商:BOURNS 制造商全称:Bourns Electronic Solutions 功能描述:91, 92, 93, 94, 95, 96 - 5/8 ” Square Single-Turn Panel Control 97, 99 - 5/8 ” Square Single-Turn Panel Control with Rotary Switch
91C1A-A24-A13/A15L 制造商:BOURNS 制造商全称:Bourns Electronic Solutions 功能描述:91, 92, 93, 94, 95, 96 - 5/8 ” Square Single-Turn Panel Control 97, 99 - 5/8 ” Square Single-Turn Panel Control with Rotary Switch
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*